ABSTRACT
In the present work, the hot deformation behavior and microstructural evolution of a TiB2/Al-Zn-Mg-Cu-Zr composite were studied. Hot compression tests were conducted within a temperature range of 370 °C to 490 °C and a strain rate of 0.001 s-1 to 10 s-1. We established the Arrhenius constitutive equation with Zener-Hollomon parameters and processing maps and discussed the microstructural evolution during hot deformation. The results indicated that the safe processing parameter region falls within 370 °C-490 °C and 0.001 s-1-0.025 s-1. The influence of the strain rate on the safe processing range is more dominant than that of deformation temperature, which is primarily attributed to TiB2. Dynamic softening is primarily governed by dynamic recovery (DRV). Small particles (η, Al3Zr) can pin dislocations, promoting the rearrangement and annihilation of dislocations and facilitating DRV. Higher temperatures and lower strain rates facilitated dynamic recrystallization (DRX). Continuous dynamic recrystallization (CDRX) occurs near high-angle grain boundaries induced by strain-induced boundary migration (SIBM). TiB2 and large second-phase particles generate high-density geometrically necessary dislocations (GNBs) during hot deformation, which serve as nucleation sites for discontinuous dynamic recrystallization (DDRX). This enhances dynamic softening and improves formability.
ABSTRACT
Nanocrystalline (NC) structure can lead to the considerable strengthening of metals and alloys. Obtaining appropriate comprehensive mechanical properties is always the goal of metallic materials. Here, a nanostructured Al-Zn-Mg-Cu-Zr-Sc alloy was successfully processed by high-pressure torsion (HPT) followed by natural aging. The microstructures and mechanical properties of the naturally aged HPT alloy were analyzed. The results show that the naturally aged HPT alloy primarily consists of nanoscale grains (~98.8 nm), nano-sized precipitates (20-28 nm in size), and dislocations (1.16 × 1015 m-2), and exhibits a high tensile strength of 851 ± 6 MPa and appropriate elongation of 6.8 ± 0.2%. In addition, the multiple strengthening modes that were activated and contributed to the yield strength of the alloy were evaluated according to grain refinement strengthening, precipitation strengthening, and dislocation strengthening, and it is shown that grain refinement strengthening and precipitation strengthening are the main strengthening mechanisms. The results of this study provide an effective pathway for achieving the optimal strength-ductility match of materials and guiding the subsequent annealing treatment.
