Vacancy Ordering in Ultrathin Copper Oxide Films on Cu(111).

Oxide thin films grown on metal surfaces have wide applications in catalysis and beyond owing to their unique surface structures compared to their bulk counterparts. Despite extensive studies, the atomic structures of copper surface oxides on Cu(111), commonly referred to as "44" and "29", have remained elusive. In this work, we demonstrated an approach for the structural determination of oxide surfaces using element-specific scanning tunneling microscopy (STM) imaging enhanced by functionalized tips. This approach enabled us to resolve the atomic structures of "44" and "29" surface oxides, which were further corroborated by noncontact atomic force microscopy (nc-AFM) measurements and Monte Carlo (MC) simulations. The stoichiometry of the "44" and "29" frameworks was identified as Cu23O16 and Cu16O11, respectively. Contrary to the conventional hypothesis, we observed ordered Cu vacancies within the "44" structure manifesting as peanut-shaped cavities in the hexagonal lattice. Similarly, a combination of Cu and O vacancies within the "29" structure leads to bean-shaped cavities within the pentagonal lattice. Our study has thus resolved the decades-long controversy on the atomic structures of "44" and "29" surface oxides, advancing our understanding of copper oxidation processes and introducing a robust framework for the analysis of complex oxide surfaces.

Atomic overlayer of permeable microporous cuprous oxide on palladium promotes hydrogenation catalysis.

The interfacial sites of metal-support interface have been considered to be limited to the atomic region of metal/support perimeter, despite their high importance in catalysis. By using single-crystal surface and nanocrystal as model catalysts, we now demonstrate that the overgrowth of atomic-thick Cu2O on metal readily creates a two-dimensional (2D) microporous interface with Pd to enhance the hydrogenation catalysis. With the hydrogenation confined within the 2D Cu2O/Pd interface, the catalyst exhibits outstanding activity and selectivity in the semi-hydrogenation of alkynes. Alloying Cu(0) with Pd under the overlayer is the major contributor to the enhanced activity due to the electronic modulation to weaken the H adsorption. Moreover, the boundary or defective sites on the Cu2O overlayer can be passivated by terminal alkynes, reinforcing the chemical stability of Cu2O and thus the catalytic stability toward hydrogenation. The deep understanding allows us to extend the interfacial sites far beyond the metal/support perimeter and provide new vectors for catalyst optimization through 2D interface interaction.

Design of Lewis Pairs via Interface Engineering of Oxide-Metal Composite Catalyst for Water Activation.

The rational design and controlled construction of active centers remain grand challenges in heterogeneous catalysis, in particular for oxide catalysts with complex surface and interface structures. This work describes a facile way in the design of highly active Ni-O Lewis pairs for water activation where Ni and O sites act as Lewis acid and base, respectively. Surface science experiments indicate that dissociative adsorption of water occurs at edges of NiOx nanoislands grown on Au(111) and NiOx-Ni interfaces formed by further depositing metallic Ni layers along the edges of NiOx nanoislands. Enhanced activity of Ni-O Lewis pairs at the NiOx-Ni interface has been demonstrated by theoretical calculations, which are attributed to the higher Lewis acidity of metallic Ni sites and synergy of the metal and oxide components. Moreover, proton can migrate away from the NiOx-Ni interface and refresh the O base sites, leading to further hydroxylation of the neighboring Ni acid sites.

Tuning the activities of cuprous oxide nanostructures via the oxide-metal interaction.

Despite tremendous importance in catalysis, the design of oxide-metal interface has been hampered by the limited understanding of the nature of interfacial sites and the oxide-metal interaction (OMI). Through construction of well-defined Cu2O/Pt, Cu2O/Ag and Cu2O/Au interfaces, we find that Cu2O nanostructures (NSs) on Pt exhibit much lower thermal stability than on Ag and Au, although they show the same structure. The activities of these interfaces are compared for CO oxidation and follow the order of Cu2O/Pt > Cu2O/Au > Cu2O/Ag. OMI is found to determine the activity and stability of supported Cu2O NSs, which could be described by the formation energy of interfacial oxygen vacancy. Further, electronic interaction between Cu+ and metal substrates is found center to OMI, where the d band center could be used as a key descriptor. Our study provides insight for OMI and for the development of Cu-based catalysts for low temperature oxidation reactions.

Probing surface defects of ZnO using formaldehyde.

The catalytic properties of metal oxides are often enabled by surface defects, and their characterization is thus vital to the understanding and application of metal oxide catalysts. Typically, surface defects for metal oxides show fingerprints in spectroscopic characterization. However, we found that synchrotron-radiation photoelectron spectroscopy (SRPES) is difficult to probe surface defects of ZnO. Meanwhile, CO as a probe molecule cannot be used properly to identify surface defect sites on ZnO in infrared (IR) spectroscopy. Instead, we found that formaldehyde could serve as a probe molecule, which is sensitive to surface defect sites and could titrate surface oxygen vacancies on ZnO, as evidenced in both SRPES and IR characterization. Density functional theory calculations revealed that formaldehyde dissociates to form formate species on the stoichiometric ZnO(101¯0) surface, while it dissociates to formyl species on Vo sites of the reduced ZnO(101¯0) surface instead. Furthermore, the mechanism of formaldehyde dehydrogenation on ZnO surfaces was also elucidated, while the generated hydrogen atoms are found to be stored in ZnO bulk from 423 K to 773 K, making ZnO an interesting (de)hydrogenation catalyst.

Enhancing CO2 Electroreduction with the Metal-Oxide Interface.

The electrochemical CO2 reduction reaction (CO2RR) typically uses transition metals as the catalysts. To improve the efficiency, tremendous efforts have been dedicated to tuning the morphology, size, and structure of metal catalysts and employing electrolytes that enhance the adsorption of CO2. We report here a strategy to enhance CO2RR by constructing the metal-oxide interface. We demonstrate that Au-CeOx shows much higher activity and Faradaic efficiency than Au or CeOx alone for CO2RR. In situ scanning tunneling microscopy and synchrotron-radiation photoemission spectroscopy show that the Au-CeOx interface is dominant in enhancing CO2 adsorption and activation, which can be further promoted by the presence of hydroxyl groups. Density functional theory calculations indicate that the Au-CeOx interface is the active site for CO2 activation and the reduction to CO, where the synergy between Au and CeOx promotes the stability of key carboxyl intermediate (*COOH) and thus facilitates CO2RR. Similar interface-enhanced CO2RR is further observed on Ag-CeOx, demonstrating the generality of the strategy for enhancing CO2RR.

Enhanced oxidation resistance of active nanostructures via dynamic size effect.

A major challenge limiting the practical applications of nanomaterials is that the activities of nanostructures (NSs) increase with reduced size, often sacrificing their stability in the chemical environment. Under oxidative conditions, NSs with smaller sizes and higher defect densities are commonly expected to oxidize more easily, since high-concentration defects can facilitate oxidation by enhancing the reactivity with O2 and providing a fast channel for oxygen incorporation. Here, using FeO NSs as an example, we show to the contrary, that reducing the size of active NSs can drastically increase their oxidation resistance. A maximum oxidation resistance is found for FeO NSs with dimensions below 3.2 nm. Rather than being determined by the structure or electronic properties of active sites, the enhanced oxidation resistance originates from the size-dependent structural dynamics of FeO NSs in O2. We find this dynamic size effect to govern the chemical properties of active NSs.