Comparative evaluations of shear bond strength of mineral trioxide aggregate, Biodentine, and calcium-enriched mixture to bulk-fill flowable composite using three different adhesive systems: An in vitro study.

Objective: The objective of the study was to assess the shear bond strength of bulk-fill flowable composite resin smart dentin replacement plus when bonded to mineral trioxide aggregate (MTA)-angelus, biodentine, and calcium-enriched mixture (CEM) at two different aging periods (15 min and 72 h) using three distinct adhesive systems. In addition, the study identified the specific modes of failure (adhesive, cohesive, or mixed) using a stereomicroscope and scanning electron microscope. Materials and Methods: One hundred and twenty-six cylindrical acrylic blocks used in the study were sorted into three groups based on the bioactive substance used to fill the 3-mm diameter and 3-mm high hole in the center of each block. The groups were MTA, Biodentine, and CEM. The specimens were then divided into subgroups based on the aging interval (15 min and 72 h) of the bioactive material and the adhesive system used (two-step total-etch, two-step self-etch [SE], and one-step SE) while bonding to the restorative bulk-fill flowable composite. The shear bond strength values were measured with a universal testing machine, and the data were analyzed using two-way and one-way analysis of variance, followed by a post hoc test. The specimens were assessed under stereomicroscope and scanning electron microscope to characterize the mode of bond failure (cohesive, adhesive, or mixed). Results: The study showed that the type of adhesive system and the time of bonding affected the shear bond strength of bulk-fill composite to the pulp capping agents (P < 0.05). For MTA, the highest bond strength was observed with two-step SE group at 15 min (18.16 ± 2.97 MPa) (P < 0.05). CEM exhibited the highest bond strength with two-step SE group at 72 h intervals (8.77 ± 1.76) (P < 0.05). The highest bond strength for biodentine group was observed with total-etch group (8.54 ± 1.35 Mpa) and two-step SE (8.19 ± 1.94 Mpa) bonded at 72 h interval (P < 0.05). The majority of the samples in the MTA group (29/42) and CEM group (20/42) showed a cohesive fracture, whereas Biodentine group (22/42) had an adhesive fracture in most of its samples. Conclusion: MTA demonstrated the highest bond strength with two-step SE group at 15 min, and CEM exhibited the highest bond strength with two-step SE groups at 72 h interval. For biodentine group, the type of adhesive used did not impact the bond strength values.

Evaluation of canal patency and cleanliness following retreatment of bioceramic sealer-obturated root canals using three different irrigant activation protocols.

This study evaluated the effectiveness of three different irrigant activation techniques in cleaning and establishing patency during retreatment of root canals obturated with gutta-percha and bioceramic sealer. 60 extracted premolars with oval-shaped canals were instrumented and obturated with gutta-percha and EndosequenceBC sealer using the 'warm hydraulic condensation' technique. The teeth were retreated using Protaper Universal Retreatment and XP-Endo Shaper system and divided into four groups according to the irrigant activation protocol used: control, passive ultrasonic irrigation (PUI), Endovac irrigation (EVI) and XP-Endo Finisher R (XPFR). Apical patency was achieved in all the samples of the XPFR group (100%), which showed a significantly higher success rate compared with the control (73.3%) and EVI groups (73.3%) (p < 0.05). The scanning electron microscopic evaluation revealed significantly cleaner middle and apical third root canals in the PUI and XPFR groups compared with the control group (p < 0.05). These findings suggest that XPFR effectively cleans and establishes patency in root canals filled with bioceramic sealers.

Comparative evaluation of the apical leakage of different bioceramic retrofilling materials with and without smear layer: A stereomicroscopic study.

Objective: Present in-vitro study aimed to evaluate the apical leakage of different bioceramic retrofilling materials with and without smear layer. Materials and Methods: : Sixty human single-rooted teeth were decoronated at a standardized root length of 13 mm, chemo-mechanically prepared and obturated. After obturation, root-end resection was done and root-end cavities were prepared using ultrasonic tips. The specimens with prepared retro cavities were randomly assigned into 2 groups (n = 30) based on the smear layer removal protocol used. Each group was further subdivided into 3 subgroups (n = 10) based on the bioceramic retrofilling material MTA (Mineral Trioxide Aggregate; Proroot Dentsply/Tulsa), CEM (Calcium-Enriched Mixture; Bionique Dent, Tehran) and ERRM (EndoSequence® Root Repair Material; Brasseler USA, Savannah, GA). The extension of dye (2% Rhodamine B) penetration was measured in millimetre using a stereomicroscope at 10× zoom. Results were statistically analysed using one-way ANOVA (analysis of variance) test and unpaired Student's t test. Results: In the presence of smear layer, MTA demonstrated maximum mean apical leakage value (1.70 ± 0.30), followed by CEM (1.40 ± 0.37) and ERRM (1.40 ± 0.23), which was statistically not significant. Without the smear layer, ERRM demonstrated the least mean apical leakage value, which was statistically significant as compared with CEM (P <.05) and MTA (P <.01). Conclusion(s): : All bioceramic retrofilling materials demonstrated apical leakage irrespective of the presence or absence of the smear layer. The presence of a smear layer is beneficial for the sealing ability of MTA and CEM, whereas, the absence of the smear layer is advocated while using ERRM.

Management of large preiapical lesion with the combination of second generation platelet extract and hydroxyapatite bone graft: a report of three cases.

The pulp tissue necrosis and extensive periodontal diseases leads to the development of the inflammatory periapical lesion which causes a local response of bone around the apex of the tooth. Depends upon the nature of wound and available biological growth factors the outcome will be either regeneration or repair. Being a rich source of growth factors, platelet rich fibrin (PRF) posses many advantages in bone regeneration. The purpose of this case report is to present an attempt to evaluate the healing potential of the combination of PRF and Hydroxyapatite bone graft as opposed to using these materials alone. A periapical endodontic surgery was performed on three patients with a large periapical inflammatory lesion and a large bony defect. The defect was then filled with a combination of PRF and Hydroxyapatite bone graft crystals. Clinical examination exhibited uneventful wound healing. The HA crystals have been replaced by new bone radiographically at the end of two years in Case 1 and Case 2, Case 3 were followed upto one year. On the basis of our cases outcome, we conclude the use of PRF in combination with HA crystals might have accelerate the bone regeneration.

Effect of passive ultrasonic irrigation and manual dynamic irrigation on smear layer removal from root canals in a closed apex in vitro model.

AIM: To compare the effect of passive ultrasonic irrigation with manual dynamic irrigation on smear layer removal from root canals using a closed apex in vitro model. METHODS: The root canals of 45 freshly-extracted human single-rooted mandibular premolar teeth were prepared by the Pro-Taper rotary system to an apical preparation of F4 size. Prepared teeth were randomly divided into three groups; two experimental groups and one control group (n = 15) on the basis of the type of activation of final irrigation as follows: (a) Group A, 3% sodium hypochlorite (NaOCl) and 17% ethylenediaminetetraacetic acid (EDTA), no activation received; (b) Group B, 3% NaOCl and 17% EDTA, ultrasonic activation with a small file; and (c) Group C, 3% NaOCl and 17% EDTA, manual activation with a master gutta-percha point. The prepared teeth were decoronated and split into two halves longitudinally, and observed under a scanning electron microscope to assess the removal of the smear layer. RESULTS: In the apical-third region, the mean smear scores for groups B and C were significantly less than those of Group A (control group) (P < 0.05). CONCLUSION: Both activation techniques are important adjuncts in removing the smear layer, with manual dynamic activation being a simpler, safer, and more cost-effective technique.

Retrieval of a separated nickel-titanium instrument using a modified 18-guage needle and cyanoacrylate glue: a case report.

During root canal preparation procedures, the potential for instrument breakage is always present. When instrument breakage occurs, it leads to anxiety of the clinician and as well as a metallic obstruction of the canal which hinders further cleaning and shaping. Separated instruments must always be attempted for retrieval and if retrieval is not possible bypass should be tried. With the increased use of nickel-titanium (NiTi) instruments the incidence of separated instruments has increased. A considerable amount of research has been done to understand the various factors related to the fracture of NiTi instruments to minimize its occurrence. This paper presents a review of the literature regarding the fracture of NiTi instruments and also describes a case report showing the use of a modified 18-guage needle and cyanoacrylate glue to retrieve a separated NiTi instrument from the mesiolingual canal of a mandibular first molar.

An In Vitro SEM Study on the Effectiveness of Smear Layer Removal of Four Different Irrigations.

INTRODUCTION: The aim of this study was to compare the smear layer removal efficacies of 3% sodium hypochlorite (NaOCl), 17% Ethylenediaminetetraacetic acid (EDTA), SmearClear and BioPure MTAD using a common irrigation protocol. MATERIALS AND METHODS: Fifty freshly extracted human single rooted maxillary and mandibular teeth were prepared by a ProTaper rotary system up to an apical preparation file size F3. Prepared teeth were randomly divided into five groups (n=10); distilled water (Group A; negative control), EDTA (Group B), SmearClear (Group C), BioPure MTAD (Group D) and NaOCl (Group E). After final irrigation with tested irrigants the teeth were decoronated, split into two halves longitudinally and observed under a scanning electron microscope (SEM) for removal of the smear layer. The SEM images were then analyzed for the amount of smear layer present using a three score system. Data were analyzed using the Kruskal-Wallis test and Mann-Whitney U test. RESULTS: Intergroup comparison of groups B, C, and D showed no statistical significant differences in the coronal and middle thirds, however, in the apical third the canal surfaces were cleaner in samples from group D (P<0.05). CONCLUSION: BioPure MTAD was the most effective agent for the purpose of smear layer removal in the apical third of the root canals.