ABSTRACT
PURPOSE: The aim of the study was to directly measure graft forces of an anterior cruciate ligament reconstruction (ACLR) and a lateral extra-articular tenodesis (LET) using the modified Lemaire technique in combined anterior cruciate ligament (ACL) deficient and anterolateral rotatory instable knees and to analyse the changes in knee joint motion resulting from combined ACLR + LET. METHODS: On a knee joint test bench, six fresh-frozen cadaveric specimens were tested at 0°, 30°, 60°, and 90° of knee flexion in the following states: 1) intact; 2) with resected ACL; 3) with resected ACL combined with anterolateral rotatory instability; 4) with an isolated ACLR; and 5) with combined ACLR + LET. The specimens were examined under various external loads: 1) unloaded; 2) with an anterior tibial translation force (ATF) of 98 N; 3) with an internal tibial torque (IT) of 5 Nm; and 4) with a combined internal tibial torque of 5 Nm and an anterior tibial translation force of 98 N (IT + ATF). The graft forces of the ACLR and LET were recorded by load cells incorporated into custom devices, which were screwed into the femoral tunnels. Motion of the knee joint was analysed using a 3D camera system. RESULTS: During IT and IT + ATF, the addition of a LET reduced the ACLR graft forces up to 61% between 0° and 60° of flexion (P = 0.028). During IT + ATF, the LET graft forces reached 112 N. ACLR alone did not restore native internal tibial rotation after combined ACL deficiency and anterolateral rotatory instability. Combined ACLR + LET was able to restore native internal tibial rotation values for 0°, 60° and 90° of knee flexion with decreased internal tibial rotation at 30° of flexion. CONCLUSION: The study demonstrates that the addition of a LET decreases the forces seen by the ACLR graft and reduces residual rotational laxity after isolated ACLR during internal tibial torque loading. Due to load sharing, a LET could support the ACLR graft and perhaps be the reason for reduced repeat rupture rates seen in clinical studies. Care must be taken not to limit the internal tibial rotation when performing a LET.
ABSTRACT
PURPOSE: To assess measurement equivalence, inter- and intra-rater reliability, standard error of measurements (SEM) and false positive measurements (FPM) of four different knee arthrometers (KLT,Karl Storz; KiRA, I + ; KT-1000 MEDmetric Corp; Rolimeter, Aircast) in healthy patients. METHODS: Four different investigators (two advanced (AR) and two beginners (BR)) examined 12 participants with healthy knees at two time points with regards to anterior tibial translation (ATT) and side-to-side difference (SSD). Test equivalence was assessed using the TOST (two-one-sided t test) procedure with ± 1 mm equivalence boundaries. Intraclass correlation coefficients (ICCs) were calculated using two-way mixed effects models. Furthermore, false positive-(SSD > 3 mm) and SEMs were assessed. RESULTS: A total of 2304 Lachman Tests were performed. Between-rater SSDs were equivalent between AR and BR raters for the Rolimeter only. Inter-rater ICC values (SSD, ATT) were graded as "poor" to "moderate" for all devices. Equivalent test-retest results were observed for all raters using the Rolimeter, KLT and KT-1000, whereas measurement consistency with KiRA was given in the advanced examiners group only. Intra-rater ICC values (Range: SSD, ATT) were graded as "poor" to "moderate" for SSD values and "moderate" to "good" for ATT. SEMs were lowest for the Rolimeter and highest for KiRA. FPM were never obtained with the Rolimeter (0%), twice (2.1%) with the KT-1000, three times (3.1%) with the KLT and 33 times (34.4%) using KiRA. CONCLUSION: There is acceptable intra-rater but poor inter-rater reliability with all tested arthrometers. Measures of knee laxity are comparable between Rolimeter, KLT and KT-1000 but higher for KiRA. Clinically, the present study shows that repeated arthrometry measurements should always be performed by the same investigators.
