Effects of polishing with paste containing surface pre-reacted glass-ionomer fillers on enamel remineralization after orthodontic bracket debonding.

Surface pre-reacted glass-ionomer (S-PRG) technology allows for the release of multiple ions. This study was performed to investigate the remineralization of etched enamel after removal of the bracket using a novel paste containing S-PRG filler. Surfaces of polished enamel were etched with phosphoric acid and then subdivided into two regions. Bracket bonding resin was thinly applied to one region. After 24-hr immersion in artificial saliva, the bonding resin on the enamel surfaces was removed by grinding with tungsten carbide bur at low-speed, followed by polishing with one of four different polishing systems: (a) nonfluoridated paste (NF); (b) fluoridated paste (F); (c) S-PRG filler-containing paste (S-PRG); or (d) nonfluoridated plus S-PRG filler-containing paste (NF + S-PRG) (n = 15). The polished specimens were then immersed in an artificial saliva solution for 7 days. Nanoindentation testing of enamel surfaces was performed and their mechanical properties were compared. Representative specimens were examined with scanning electron microscope. In all specimens, the mechanical properties of the enamel surfaces were markedly degraded by acid etching. However, the mechanical properties of both regions (etched and resin-infiltrated enamels) showed recovery after polishing and 7-day immersion. Polishing with NF + S-PRG paste led to significant recovery of mechanical properties compared to polishing with NF or S-PRG paste alone, and remineralization was equivalent to that seen with F paste. Porous etched enamel surfaces were filled with a remineralization layer after each polishing procedure and 7-day immersion in all polishing groups. Polishing using NF + S-PRG paste can facilitate enamel remineralization after bracket removal.

Wear characteristics and inhibition of enamel demineralization by resin-based coating materials.

In this study, wear and inhibition of enamel demineralization by resin-based coating materials were investigated. Seven commercially available coating materials, with and without fillers, were used. A mechanical wear test was performed, and the specimens were then examined with a scanning electron microscope. Hardness and elastic modulus measurements for each material were obtained by nanoindentation testing. Thin layers of each material were applied on human enamel surfaces, which were subjected to alternating immersion in demineralizing and remineralizing solutions. The inhibition ability of enamel demineralization adjacent to the coating was estimated with depth-dependent mechanical properties using the nanoindentation test. The non-filled coating material showed significantly lower hardness, lower elastic modulus, and higher weight loss. There were no significant differences in weight loss among the six filled coating materials. After the alternating immersion protocol, the enamel specimens having application of coating materials with ion-releasing ability were harder than those in the other groups in some locations 1-11 µm from the enamel surface and within 300 µm from the edge of the coating materials. In conclusion, clinical use of the resin-based coating materials with ion-releasing ability may prevent demineralization of exposed enamel adjacent to the coating during treatment.