ABSTRACT
Memristors are prominent passive circuit elements with promising futures for energy-efficient in-memory processing and revolutionary neuromorphic computation. State-of-the-art memristors based on two-dimensional (2D) materials exhibit enhanced tunability, scalability and electrical reliability. However, the fundamental of the switching is yet to be clarified before they can meet industrial standards in terms of endurance, variability, resistance ratio, and scalability. This new physical simulator based on the kinetic Monte Carlo (kMC) algorithm reproduces the defect migration process in 2D materials and sheds light on the operation of 2D memristors. The present work employs the simulator to study a two-dimensional 2H-MoS2 planar resistive switching (RS) device with an asymmetric defect concentration introduced by ion irradiation. The simulations unveil the non-filamentary RS process and propose routes to optimize the device's performance. For instance, the resistance ratio can be increased by 53% by controlling the concentration and distribution of defects, while the variability can be reduced by 55% by increasing 5-fold the device size from 10 to 50 nm. Our simulator also explains the trade-offs between the resistance ratio and variability, resistance ratio and scalability, and variability and scalability. Overall, the simulator may enable an understanding and optimization of devices to expedite cutting-edge applications.
ABSTRACT
Ultrasound imaging provides the means for non-invasive real-time diagnostics of the internal structure of soft tissue in living organisms. However, the majority of commercially available ultrasonic transducers have rigid interfaces which cannot conform to highly-curved surfaces. These geometric limitations can introduce a signal-quenching air gap for certain topographies, rendering accurate imaging difficult or impractical. Here, we demonstrate a 256-element flexible two-dimensional (2D) ultrasound piezoelectric transducer array with geometric phase correction. We show surface-conformable real-time B-mode imaging, down to an extreme radius of curvature of 1.5 cm, while maintaining desirable performance metrics such as high signal-to-noise ratio (SNR) and minimal elemental cross-talk at all stages of bending. We benchmark the array capabilities by resolving reflectors buried at known locations in a medical-grade tissue phantom, and demonstrate how phase correction can improve image reconstruction on curved surfaces. With the current array design, we achieve an axial resolution of ≈ 2 mm at clinically-relevant depths in tissue, while operating the array at 1.4 MHz with a bandwidth of ≈ 41%. We use our prototype to image the surface of the human humerus at different positions along the arm, demonstrating proof-of-concept applicability for real-time diagnostics using phase-corrected flexible ultrasound probes.
Subject(s)
Diagnostic Imaging , Transducers , Equipment Design , Humans , Phantoms, Imaging , UltrasonographyABSTRACT
Inverting a semiconducting channel is the basis of all field-effect transistors. In silicon-based metal-oxide-semiconductor field-effect transistors (MOSFETs), a gate dielectric mediates this inversion. Access to inversion layers may be granted by interfacing ultrathin low-dimensional semiconductors in heterojunctions to advance device downscaling. Here we demonstrate that monolayer molybdenum disulfide (MoS2) can directly invert a single-walled semiconducting carbon nanotube (SWCNT) transistor channel without the need for a gate dielectric. We fabricate and study this atomically thin one-dimensional/two-dimensional (1D/2D) van der Waals heterojunction and employ it as the gate of a 1D heterojunction field-effect transistor (1D-HFET) channel. Gate control is based on modulating the conductance through the channel by forming a lateral p-n junction within the CNT itself. In addition, we observe a region of operation exhibiting a negative static resistance after significant gate tunneling current passes through the junction. Technology computer-aided design (TCAD) simulations confirm the role of minority carrier drift-diffusion in enabling this behavior. The resulting van der Waals transistor architecture thus has the dual characteristics of both field-effect and tunneling transistors, and it advances the downscaling of heterostructures beyond the limits of dangling bonds and epitaxial constraints faced by III-V semiconductors.
ABSTRACT
Helium ion irradiation is a known method of tuning the electrical conductivity and charge carrier mobility of novel two-dimensional semiconductors. Here, we report a systematic study of the electrical performance of chemically synthesized monolayer molybdenum disulfide (MoS2) field-effect transistors irradiated with a focused helium ion beam as a function of increasing areal irradiation coverage. We determine an optimal coverage range of approx. 10%, which allows for the improvement of both the carrier mobility in the transistor channel and the electrical conductance of the MoS2, due to doping with ion beam-created sulfur vacancies. Larger areal irradiations introduce a higher concentration of scattering centers, hampering the electrical performance of the device. In addition, we find that irradiating the electrode-channel interface has a deleterious impact on charge transport when contrasted with irradiations confined only to the transistor channel.
ABSTRACT
There is growing interest in integrating piezoelectric materials with complementary metal-oxide-semiconductor (CMOS) technology to enable expanded applications. A promising material for ultrasound transducer applications is polyvinylidene fluoride (PVDF), a piezoelectric polymer. One of the challenges with PVDF is that its piezoelectric properties can deteriorate when exposed to temperatures in excess of 70 °C for extended periods of time during fabrication. Here, we report on the effects of both shortening annealing times and providing this heating non-uniformly, as is characteristic of some processing conditions, on the piezoelectric coefficient (d 33) of PVDF films for various thicknesses. In this case, no degradation in the d 33 was observed at temperatures below 100 °C for anneal times of under one minute when this heating is applied through one side of the film, making PVDF compatible with many bonding and photolithographic processing steps required for CMOS integration. More surprisingly, for one-sided heating to temperatures between 90 °C and 110 °C, we observed a transient enhancement of the d 33 by nearly 40% that lasted for several hours after these anneals. We attribute this effect to induced strain in these films.
ABSTRACT
Two-dimensional (2D) layered semiconductors have recently emerged as attractive building blocks for next-generation low-power nonvolatile memories. However, challenges remain in the controllable fabrication of bipolar resistive switching circuit components from these materials. Here, the experimental realization of lateral memtransistors from monolayer single-crystal molybdenum disulfide (MoS2) utilizing a focused helium ion beam is reported. Site-specific irradiation with the focused probe of a helium ion microscope creates a nanometer-scale defect-rich region, bisecting the MoS2 lattice. The reversible drift of these defects in the applied electric field modulates the resistance of the channel, enabling versatile memristive functionality. The device can reliably retain its resistance ratios and set/reset biases for 1180 switching cycles. Long-term potentiation and depression with sharp habituation are demonstrated. This work establishes the feasibility of ion irradiation for controllable fabrication of 2D memristive devices with promising key performance parameters, such as low power consumption. The applicability of these devices for synaptic emulation may address the demands of future neuromorphic architectures.
ABSTRACT
Precise tunability of electronic properties of two-dimensional (2D) nanomaterials is a key goal of current research in this field of materials science. Chemical modification of layered transition metal dichalcogenides leads to the creation of heterostructures of low-dimensional variants of these materials. In particular, the effect of oxygen-containing plasma treatment on molybdenum disulfide (MoS2) has long been thought to be detrimental to the electrical performance of the material. We show that the mobility and conductivity of MoS2 can be precisely controlled and improved by systematic exposure to oxygen/argon plasma and characterize the material using advanced spectroscopy and microscopy. Through complementary theoretical modeling, which confirms conductivity enhancement, we infer the role of a transient 2D substoichiometric phase of molybdenum trioxide (2D-MoO x ) in modulating the electronic behavior of the material. Deduction of the beneficial role of MoO x will serve to open the field to new approaches with regard to the tunability of 2D semiconductors by their low-dimensional oxides in nano-modified heterostructures.
ABSTRACT
Graphene is a promising candidate to succeed silicon based devices, and the conventional strategies for fabrication and testing of graphene-based electronics often utilise an electron beam. Here, we report on a systematic study of the effect of electron beam exposure on graphene devices. We realise reversible doping of on-chip graphene using a focused electron beam. Our results demonstrate site-specific control of carrier type and concentration achievable by modulating the charge distribution in the substrate. The effect of substrate-embedded charges on carrier mobility and conductivity of graphene is studied, with a dielectric screening model proposed to explain the effective n-type and p-type doping produced at different beam energies. Multiple logic operations are thus implemented in a single graphene sheet by using site-specific e-beam irradiation. We extend the phenomenon to MoS2, generalising it to conductive two-dimensional materials. Our results are of importance to imaging, in situ characterisation and lithographic techniques employed to investigate 2D materials.
ABSTRACT
A focused helium ion beam was used to introduce nano-sized gap chains in graphene. The effect of beam scanning strategies in the fabrication of the nano-gap chains was investigated. The tuning of graphene conductivity has been achieved by modulating the magnitude and uniformity of the ion dose and hence the morphology of the nano-gap chains. A model based on the site-specific and dose-dependent conductivity was built to understand the tuning of the conductivity, taking into account the nanoscale non-uniformity of irradiation.