Development of an aqueous ultrasound-assisted extraction process of bioactive compounds from beet leaves: a proposal for reducing losses and increasing biomass utilization.

BACKGROUND: Red beet plants are cultivated worldwide for the consumption of their roots, generating large amounts of unexploited by-products. In particular, beet leaves (BLs) represent about 50% of the whole plant and are usually discarded as waste. This constitutes not only an economic issue, since multiple resources invested in the production will be wasted, but also an environmental problem because of the pollution associated with their disposal. However, BLs comprise an important source of functional compounds (polyphenols and betalains) that could be recovered from the raw material, representing a sustainable solution for the underutilization of this by-product. This study proposes the recovery of polyphenols and betalains using an aqueous ultrasound-assisted extraction (UAE) process at different powers (35, 50, and 100 W) that was characterized and optimized. RESULTS: UAE significantly enhanced the recovery of bioactive compounds and shortened the time required for extraction in comparison with traditional macerations (35 < 50 < 100 W). During UAE, the temperature of the systems increased as a function of the power applied, favouring the recovery of these phytochemicals. Additionally, a Box-Behnken design and response surface methodology were employed to optimize UAE conditions (90 W ultrasound power, 1:20 solid:liquid ratio, 16 min extraction time), under which the yields were 14.9 mg g-1 (polyphenols), 949.1 µg g-1 (betaxanthins), and 562.2 µg g-1 (betacyanins), consistent with the values predicted by the models. CONCLUSION: This study enabled the development of a green-solvent UAE process that constitutes an effective post-harvest by-products strategy to minimize losses and increase biomass utilization through the recovery of bioactive compounds from BLs, promoting sustainability in the agri-food chain. © 2020 Society of Chemical Industry.

Effect of natamycin, nisin and glycerol on the physicochemical properties, roughness and hydrophobicity of tapioca starch edible films.

In this paper, films based on tapioca starch and containing nisin, natamycin and glycerol were characterized in relation to their physicochemical properties, roughness and hydrophobicity. The content of glycerol affected the mechanical properties of the films studied and the roughness and it was observed an increase in WVP with the increase in glycerol content. The addition of antimicrobials affected the mechanical properties, being nisin the one that produced the greater decrease in the Young modulus. The color was highly affected by the joint presence of natamycin and nisin, which increased the yellow index. The contact angle increased with antimicrobial addition indicating a decrease in hydrophilicity. Nisin also affected the roughness of the films. Water vapor permeability was slightly reduced by the presence of natamycin. It was observed that water vapor permeability and contact angle were correlated with the roughness of the films.