Attogram mass sensing based on silicon microbeam resonators.

Using doubly-clamped silicon (Si) microbeam resonators, we demonstrate sub-attogram per Hertz (ag/Hz) mass sensitivity, which is extremely high sensitivity achieved by micro-scale MEMS mass sensors. We also characterize unusual buckling phenomena of the resonators. The thin-film based resonator is composed of a Si microbeam surrounded by silicon nitride (SiN) anchors, which significantly improve performance by providing fixation on the microbeam and stabilizing oscillating motion. Here, we introduce two fabrication techniques to further improve the mass sensitivity. First, we minimize surface stress by depositing a sacrificial SiN layer, which prevents damage on the Si microbeam. Second, we modify anchor structure to find optimal design that allows the microbeam to oscillate in quasi-one dimensional mode while achieving high quality factor. Mass loading is conducted by depositing Au/Ti thin films on the local area of the microbeam surface. Using sequential mass loading, we test effects of changing beam dimensions, position of mass loading, and distribution of a metal film on the mass sensitivity. In addition, we demonstrate that microbeams suffer local micro-buckling and global buckling by excessive mass loading, which are induced by two different mechanisms. We also find that the critical buckling length is increased by additional support from the anchors.

Flexible Nonstick Replica Mold for Transfer Printing of Ag Ink.

We report the fabrication of flexible replica molds for transfer printing of Ag ink on a rigid glass substrate. As mold precursors, acrylic mixtures were prepared from silsesquioxane-based materials, silicone acrylate, poly(propylene glycol) diacrylate, 3,3,4,4,5,5,6,6,7,7,8,8, 9,9,10,10,10-heptadecafluorodecyl methacrylate, and photoinitiator. By using these materials, the replica molds were fabricated from a silicon master onto a flexible substrate by means of UV-assisted molding process at room temperature. The wettability of Ag ink decreased with increase in the water contact angle of replica molds. On the other hand, the transfer rate of Ag ink onto adhesive-modified substrates increased with increase in the water contact angle of replica molds. Transferred patterns were found to be thermally stable on the photocurable adhesive layer, whereas Ag-ink patterns transferred on non-photocurable adhesives were distorted by thermal treatment. We believe that these characteristics of replica molds and adhesives offer a new strategy for the development of the transfer printing of solution-based ink materials.

Renal actinomycosis with concomitant renal vein thrombosis.

Renal actinomycosis is a rare infection caused by fungi of the genus Actinomyces. A 74-year-old male was admitted to our hospital because of gross hematuria with urinary symptoms and intermittent chills. Computed tomography of the abdomen showed thrombosis in the left renal vein and diffuse, heterogeneous enlargement of the left kidney. After nephrectomy, sulfur granules with chronic suppurative inflammation were seen microscopically, and the histopathological diagnosis was renal actinomycosis. Our case is the first report of renal actinomycosis with renal vein thrombosis.

A case of urine leakage: an unusual complication after renal biopsy.

Renal biopsy is a crucial method in the diagnosis and treatment of acute renal failure of unknown origin, nephrotic syndrome, suspicious interstitial nephritis, and glomerulonephritis as a possible cause of hematuria or proteinuria. Complications occur in 2% to 8% of patients after percutaneous renal biopsy. Complications include gross hematuria, perirenal hematoma, arteriovenous fistula, aneurysm, injury of other organs, and urine leakage. Urine leakage as a complication after kidney biopsy is rare. We experienced a case of urine leakage into the intra-abdominal cavity after renal biopsy.