Structural Elucidation of Glycosaminoglycans in the Tissue of Flounder and Isolation of Chondroitin Sulfate C.

Glycosaminoglycans (GAGs) are valuable bioactive polysaccharides with promising biomedical and pharmaceutical applications. In this study, we analyzed GAGs using HPLC-MS/MS from the bone (B), muscle (M), skin (S), and viscera (V) of Scophthalmus maximus (SM), Paralichthysi (P), Limanda ferruginea (LF), Cleisthenes herzensteini (G), Platichthys bicoloratus (PB), Pleuronichthys cornutus (PC), and Cleisthenes herzensteini (CH). Unsaturated disaccharide products were obtained by enzymatic hydrolysis of the GAGs and subjected to compositional analysis of chondroitin sulfate (CS), heparin sulfate (HS), and hyaluronic acid (HA), including the sulfation degree of CS and HS, as well as the content of each GAG. The contents of GAGs in the tissues and the sulfation degree differed significantly among the fish. The bone of S. maximus contained more than 12 µg of CS per mg of dry tissue. Although the fish typically contained high levels of CSA (CS-4S), some fish bone tissue exhibited elevated levels of CSC (CS-6S). The HS content was found to range from 10-150 ug/g, primarily distributed in viscera, with a predominant non-sulfated structure (HS-0S). The structure of HA is well-defined without sulfation modification. These analytical results are independent of biological classification. We provide a high-throughput rapid detection method for tissue samples using HPLC-MS/MS to rapidly screen ideal sources of GAG. On this basis, four kinds of CS were prepared and purified from flounder bone, and their molecular weight was determined to be 23-28 kDa by HPGPC-MALLS, and the disaccharide component unit was dominated by CS-6S, which is a potential substitute for CSC derived from shark cartilage.

The giant flexoelectric effect in a luffa plant-based sponge for green devices and energy harvesters.

Soft materials that can produce electrical energy under mechanical stimulus or deform significantly via moderate electrical fields are important for applications ranging from soft robotics to biomedical science. Piezoelectricity, the property that would ostensibly promise such a realization, is notably absent from typical soft matter. Flexoelectricity is an alternative form of electromechanical coupling that universally exists in all dielectrics and can generate electricity under nonuniform deformation such as flexure and conversely, a deformation under inhomogeneous electrical fields. The flexoelectric coupling effect is, however, rather modest for most materials and thus remains a critical bottleneck. In this work, we argue that a significant emergent flexoelectric response can be obtained by leveraging a hierarchical porous structure found in biological materials. We experimentally illustrate our thesis for a natural dry luffa vegetable-based sponge and demonstrate an extraordinarily large mass- and deformability-specific electromechanical response with the highest-density-specific equivalent piezoelectric coefficient known for any material (50 times that of polyvinylidene fluoride and more than 10 times that of lead zirconate titanate). Finally, we demonstrate the application of the fabricated natural sponge as green, biodegradable flexible smart devices in the context of sensing (e.g., for speech, touch pressure) and electrical energy harvesting.

Monitoring of salicylic acid content in human saliva and its relationship with plasma concentrations.

Aspirin is a widely used anti-inflammatory drug. It is reported that a relationship may exist between salicylic acid content in plasma and saliva after taking aspirin. This study established a rapid, convenient, and safe method to assess salicylic acid concentration in human saliva. A novel HPLC-ultraviolet detector was used to measure salicylic acid concentrations in human saliva and plasma. A C18 reversed-phase column with an aqueous solution of 0.1% trifluoroacetic acid (TFA)-acetonitrile mobile phase was used, and drug peaks were recorded at 303 nm. Salicylic acid was completely separated in saliva and plasma. Excellent linearity and correlation (r2 ≥ 0.9999) was observed between 0.1 and 2.0 µg/mL. The detection limit (S/N = 3) was 33 ng/mL, and intra- and inter-day recoveries were 103.5-113.3% and 101.1-109.5%, respectively. Salicylic acid was measured within nine hours after administration of acetylsalicylic acid tablets. A positive correlation between salicylic acid content in saliva and plasma was found (r = 0.867, p < 0.001). The proposed method was used successfully to measure salicylic acid concentration in human saliva. Meanwhile, we explored the relationship between salicylic acid levels in plasma and saliva. Saliva might replace blood for monitoring aspirin treatment. In addition, the research provides a reference for application to saliva samples.

Candida glycerinogenes Strains Overexpressing Transcription Factors have Improved Furfural Tolerance in Ethanol Production from Non-detoxified Cellulose Hydrolysate.

Cellulose is one of the main raw materials for production of green ethanol, but the presence of the growth inhibitor furfural in non-detoxified lignocellulosic hydrolysates often seriously affects their utilization. In a previous study, we obtained strains of Candida glycerinogenes that were tolerant to furfural, but at concentrations above 2.5 g L-1 there was a significant increase in the growth lag phase. In this work, transcription factor genes (SEF1, STB5, CAS5, and ETP1) associated with furfural tolerance were identified and employed to obtain modified strains permitting ethanol fermentation of concentrated and non-detoxified cellulose hydrolysates containing more than 2.5 g L-1 furfural. Tolerance to furfural could be increased to 4.5 g L-1 by overexpression of either STB5 or ETP1, which have different regulation patterns. Moreover, in non-detoxified and concentrated cellulose hydrolysate, overexpression of ETP1 significantly shortened the growth lag phase and ethanol fermentation time was reduced by 17-20%. In batch fermentations fed with concentrated non-detoxified lignocellulose hydrolysate, ethanol productivity and maximum ethanol concentration reached 2.4 g L-1 h-1 and 72.5 g L-1, increases of 26.1% and 6.6%, respectively. The results provided a route for the economic use of lignocellulose for chemical production.