In vitro and in situ caries-preventive effect of a new combined fluoride and calcium experimental nanocomposite solution.

To assess the in vitro and in situ effect of experimental combined fluoride and calcium nanocomposite solutions on dental caries prevention. Nanocompound mesoporous silica (MS) with calcium (Ca) and sodium fluoride (NaF) - (MSCaNaF); MS with NaF (MSNaF), NaF solution (positive control), and deionized water (negative control - CG) were studied. The specimens (n=130) were submitted in vitro to a multispecies biofilm in the presence of 2% sucrose. After 24 h and 48 h, the culture medium pH, the percent of surface mineral loss (%SML), and lesion depth (ΔZ) were analyzed. In the in situ study, 10 volunteers participated in four phases of 7-days each. The products were applied on the specimens (n=240) before 20% sucrose solution drips. The polysaccharides (SEPS and IEPS), %SML and roughness (Sa) were evaluated. There was an in vitro decrease in pH values in 24h and 48h, compared to baseline. The MSCaNaF and MSNaF groups obtained lower values of %SML and ΔZ (p < 0.05) than CG and NaF after 24h and were similar to NaF after 48h (p<0.05). In situ results showed similar SEPS and IEPS among all groups after 48h. An after 7-days, the nanocomposites had similar values (p>0.05), while NaF was similar to CG (p>0.05). After 48h, the MSCaNaF and MSNaF reduced the %SML (p<0.05). After 7-days, both experimental nanocomposites were similar to NaF (p>0.05). Regarding Sa, MSCaNaF was better than NaF for both periods (p<0.05). The nanocomposites controlled the in vitro and in situ enamel demineralization, mainly in the initial periods.

In vitro and in situ caries-preventive effect of a new combined fluoride and calcium experimental nanocomposite solution

Abstract To assess the in vitro and in situ effect of experimental combined fluoride and calcium nanocomposite solutions on dental caries prevention. Nanocompound mesoporous silica (MS) with calcium (Ca) and sodium fluoride (NaF) - (MSCaNaF); MS with NaF (MSNaF), NaF solution (positive control), and deionized water (negative control - CG) were studied. The specimens (n=130) were submitted in vitro to a multispecies biofilm in the presence of 2% sucrose. After 24 h and 48 h, the culture medium pH, the percent of surface mineral loss (%SML), and lesion depth (ΔZ) were analyzed. In the in situ study, 10 volunteers participated in four phases of 7-days each. The products were applied on the specimens (n=240) before 20% sucrose solution drips. The polysaccharides (SEPS and IEPS), %SML and roughness (Sa) were evaluated. There was an in vitro decrease in pH values in 24h and 48h, compared to baseline. The MSCaNaF and MSNaF groups obtained lower values of %SML and ΔZ (p < 0.05) than CG and NaF after 24h and were similar to NaF after 48h (p<0.05). In situ results showed similar SEPS and IEPS among all groups after 48h. An after 7-days, the nanocomposites had similar values (p>0.05), while NaF was similar to CG (p>0.05). After 48h, the MSCaNaF and MSNaF reduced the %SML (p<0.05). After 7-days, both experimental nanocomposites were similar to NaF (p>0.05). Regarding Sa, MSCaNaF was better than NaF for both periods (p<0.05). The nanocomposites controlled the in vitro and in situ enamel demineralization, mainly in the initial periods.

Comparative Effect of Calcium Mesoporous Silica Versus Calcium and/or Fluoride Products Against Dental Erosion.

The aim of this study was to compare the effects of a single application of a new calcium mesoporous silica nanoparticle (Ca2+-MSN) versus other calcium and/or fluoride products against dental erosion. Enamel blocks were half-covered and assigned to six groups (n = 10): Ca2+-MSNs; casein phosphopeptide-amorphous calcium phosphate mousse (CPP-ACP); CPP-ACP/F- (900 ppm F-); titanium tetrafluoride (TiF4 1%); sodium fluoride (NaF 1.36%); and Milli-Q® water (negative control). A single application for each product was completed on the exposed areas of the blocks and were submitted to an erosive challenge. Differences in volumetric roughness (Sa), and tooth structure loss (TSL) by use of three-dimensional noncontact optical profilometry were evaluate. Scanning electron microscopy (SEM) was performed. Analysis of variance and Tukey's test for Sa and the Kruskal-Wallis and Mann-Whitney U tests (p< 0.05) for TSL, respectively. Results: When evaluating Sa, all products presented differences in roughness when compared with the control group (p< 0.05) but not with each other (p > 0.05). However, when analyzing the TSL, it was observed that Ca2+-MSNs, TiF4, and NaF were more effective in preventing dental erosion versus CPP-ACP, CPP-ACP/F-, and Milli-Q® water (p< 0.05). In the SEM images, the negative control presented the worst loss of dental structure, with more porous enamel. Ca2+-MSNs were as effective as TiF4 and NaF to reduce the tooth structure loss.

Comparative effect of calcium mesoporous silica versus calcium and/or fluoride products against dental erosion

Abstract The aim of this study was to compare the effects of a single application of a new calcium mesoporous silica nanoparticle (Ca2+-MSN) versus other calcium and/or fluoride products against dental erosion. Enamel blocks were half-covered and assigned to six groups (n = 10): Ca2+-MSNs; casein phosphopeptide-amorphous calcium phosphate mousse (CPP-ACP); CPP-ACP/F− (900 ppm F−); titanium tetrafluoride (TiF4 1%); sodium fluoride (NaF 1.36%); and Milli-Q® water (negative control). A single application for each product was completed on the exposed areas of the blocks and were submitted to an erosive challenge. Differences in volumetric roughness (Sa), and tooth structure loss (TSL) by use of three-dimensional noncontact optical profilometry were evaluate. Scanning electron microscopy (SEM) was performed. Analysis of variance and Tukey's test for Sa and the Kruskal-Wallis and Mann-Whitney U tests (p< 0.05) for TSL, respectively. Results: When evaluating Sa, all products presented differences in roughness when compared with the control group (p< 0.05) but not with each other (p > 0.05). However, when analyzing the TSL, it was observed that Ca2+-MSNs, TiF4, and NaF were more effective in preventing dental erosion versus CPP-ACP, CPP-ACP/F−, and Milli-Q® water (p< 0.05). In the SEM images, the negative control presented the worst loss of dental structure, with more porous enamel. Ca2+-MSNs were as effective as TiF4 and NaF to reduce the tooth structure loss.

Resumo O objetivo deste estudo foi comparar os efeitos de uma única aplicação de uma nova nanopartícula de sílica mesoporosa de cálcio (Ca2+ -MSN) versus outros produtos à base de cálcio e / ou fluoreto contra a erosão dentária. Blocos de esmalte foram parcialmente cobertos e distribuídos em seis grupos (n = 10): Ca2+ -MSNs; fosfopeptídeos de caseína/fosfato de cálcio amorfo (CPP-ACP); CPP-ACP / F- (900 ppm F-); tetrafluoreto de titânio (TiF4 1%); fluoreto de sódio (NaF 1,36%); e água Milli-Q® (controle negativo). Uma única aplicação para cada produto foi realizada nas áreas expostas dos blocos e submetida a desafio erosivo. Diferenças na rugosidade volumétrica (Sa) e na perda de estrutura dentária (TSL) por meio de perfilometria tridimensional de não contato foram avaliadas. Microscopia eletrônica de varredura (MEV) foi realizada. Foram realizadas análise de variância e teste de Tukey para os testes Sa e Kruskal-Wallis e Mann-Whitney (p<0,05) para TSL, respectivamente. Na avaliação de Sa, todos os produtos apresentaram diferenças de rugosidade quando comparados ao grupo controle (p<0,05), mas não entre si (p> 0,05). No entanto, ao analisar o TSL, observou-se que Ca2+ -MSNs, TiF4 e NaF foram mais eficazes na prevenção da erosão dental versus CPP-ACP, CPP-ACP / F- e Milli-Q® (p<0,05). Nas imagens de MEV, o controle negativo apresentou a pior perda de estrutura dentária, com o esmalte mais poroso. A Ca2+ -MSNs foi tão eficaz quanto o TiF4 e o NaF para reduzir a perda da estrutura dentária.

Comparative Effect of Calcium Mesoporous Silica Versus Calcium and/or Fluoride Products on the Reduction of Erosive Tooth Wear and Abrasive Enamel Lesion

Abstract Objective: To evaluate the effect of a calcium nanocompound on the reduction of erosive tooth wear and abrasion. Material and Methods: Bovine enamel specimens (BE), were randomly assigned to the following groups (n = 10): G1 = Calcium mesoporous silica nanoparticles (Ca2+MSNs); G2 = casein phosphopeptide-amorphous calcium phosphate (CPP-ACP, 2% CPP-ACP, GC®); G3 = casein phosphopeptide-amorphous calcium fluoride phosphate (CPP-ACFP, 2% CPP-ACP + 900 ppm F-, GC®); G4 = sodium fluoride NaF (900 ppm F-, positive control); and G5 = distilled and deionized water (negative control). Each product was applied to the exposed area for one minute, three times per day for three consecutive days, and followed by the immersion of the specimens in Sprite Zero™ - a low-pH solution (2.58) for five minutes (Coca-Cola™). After the first and last erosive challenges of the day, the specimens were submitted to abrasion in a toothbrush machine for 15 seconds (200 g/BE). The specimens were analysed using 3D non-contact optical profilometry, with tooth structure loss (TSL) measurements and scanning electron microscopy (SEM). TSL values were analysed by Kruskal-Wallis and Mann-Whitney tests (p<0.05). Results: There were no significant differences between G1 (10.95 µm) and G3 (10.80 µm) treatments for TSL values; however both resulted in significantly reduced TSL values compared with the G5 (16.00 µm) (p<0.05). The G4 (12.26 µm) showed no statistically significant difference when compared to the G5 (16.00 µm). The groups G1 and G3 presented higher surface preservation than the G5. Conclusion: Ca2+MSNs was effective for reducing tooth surface loss caused by erosive tooth wear and abrasion.