Dual Piezoelectric Energy Investing and Harvesting Interface for High-Voltage Input.

A novel harvesting interface for multiple piezoelectric transducers (PZTs) is proposed for high-voltage energy harvesting. Pre-biasing a PZT prior to its mechanical deformation increases its damping force, resulting in higher energy extraction. Unlike the conventional harvesters where a PZT-generated output is assumed to be continuous sinusoidal and output polarity is assumed to be alternating every cycle, PZT-generated output from human motion is expected to be random. Therefore, in the proposed approach, energy is invested to the PZT only when PZT deformation is detected. Upon the motion detection, energy stored at a storage capacitor (CSTOR) from earlier energy harvesting cycle is invested to pre-bias PZT, enhancing energy extraction. The harvested energy is transferred to back CSTOR for energy investment on the next cycle and then excess energy is transferred to the battery. In addition, partial electric charge extraction (PECE) is adapted to extract a partial amount of charges from the PZT every time its voltage approaches the process limit of 40 V. Simulations with 0.35 µm BCD process show 7.61× (with PECE only) and 8.38× (with PECE and energy investment) improvement compared to the conventional rectifier-based harvesting scheme Proposed harvesting interface successfully harvests energy from excitations with open-circuit voltages up to 100 V.

A High-Voltage Energy-Harvesting Interface for Irregular Kinetic Energy Harvesting in IoT Systems with 1365% Improvement Using All-NMOS Power Switches and Ultra-low Quiescent Current Controller.

An energy-harvesting interface for kinetic energy harvesting from high-voltage piezoelectric and triboelectric generators is proposed in this paper. Unlike the conventional kinetic energy-harvesting interfaces optimized for continuous sinusoidal input, the proposed harvesting interface can efficiently handle irregular and random high voltage energy inputs. An N-type mosfet (NMOS)-only power stage design is introduced to simplify power switch drivers and minimize conduction loss. Controller active mode power is also reduced by introducing a new voltage peak detector. For efficient operation with potentially long intervals between random kinetic energy inputs, standby power consumption is minimized by monitoring the input with a 43 pW wake-up controller and power-gating all other circuits during the standby intervals. The proposed harvesting interface can harvest energy from a wide range of energy inputs, 10 s of nJ to 10 s of µJ energy/pulse, with an input voltage range of 5-200 V and an output range of 2.4-4 V under discontinuous as well as continuous excitation. The proposed interface is examined in two scenarios, with integrated power stage devices (maximum input 45 V) and with discrete power stage devices (maximum input 200 V), and the harvesting efficiency is improved by up to 600% and 1350%, respectively, compared to the case when harvesting is performed with a full bridge rectifier.