Biomineralisation of manganese on titanium surfaces exposed to seawater.

A 2-year long study was carried out to isolate and characterise various bacterial species present in the biofilm formed on titanium surfaces exposed to seawater and to assess the manganese oxidizing potential of the marine isolates. The amount of manganese present in the biofilm was also measured using atomic absorption spectrometry (AAS). The results showed that titanium was susceptible to biofouling. More than 50% of the culturable marine bacterial isolates were capable of bringing about oxidation of Mn(II). All these manganese oxidizing bacteria were heterotrophic. Autotrophic manganese oxidizing bacteria such as Leptothrix was not isolated in the present study. The AAS results confirmed that the manganese content in the biofilms increased with increasing exposure time. Hence, the study indicates that the titanium surfaces when exposed to seawater were colonised by a large number of heterotrophic bacteria, which have the ability of bringing about biomineralisation of manganese.

Photocatalytic inhibition of microbial adhesion by anodized titanium.

Biofouling is one of the concerns in the use of titanium for seawater cooled condensers of power plants. Earlier studies have shown that anodized titanium and its alloys with a thin film of anatase (TiO(2)) on its surface can inhibit attachment of Pseudomonas sp. when illuminated with near-UV light (350 - 380 nm). In the present study, a comparison of the photocatalytic inhibition of microbial attachment on titanium surfaces anodized at different voltages was carried out. Thin films of anatase of varying thickness were produced on titanium grade-2 by anodizing in dilute orthophosphoric acid solution at 30 V, 50 V and 100 V. The photocatalytic efficiency of these anodized surfaces was measured by the methylene blue degradation method. The anodised surfaces were exposed to liquid cultures of Gram-negative Pseudomonas sp., Gram-positive Micrococcus sp. and to a mixed algal culture. Photocatalytic inhibition of microbial attachment was maximum on the titanium surface anodized at 30 V, followed by the surface anodized at 50 V and then at 100 V. The photocatalytic inhibition of microbial attachment was also found to be dependent on the cell wall characteristics of the organism. The Gram-negative Pseudomonas sp. with a lipoproteinaceous outer membrane was the most susceptible to the photocatalytic effect, while the Gram-positive Micrococcus sp. with peptidoglycan cell wall showed moderate susceptibility and the algae with siliceous cell wall showed no susceptibility at all.

Influence of surface characteristics and microstructure on adhesion of bacterial cells onto a type 304 stainless steel.

A study was carried out to understand the influence of the surface characteristics/microstructure of a type 304 stainless steel on bacterial adhesion by exposing solution-annealed, sensitized and air-oxidized stainless steel specimens in a culture of Pseudomonas sp. in dilute nutrient broth. Epifluorescence microscopy of the exposed surfaces revealed that the pattern of adhesion as well as number density of bacterial cells was different depending on the metallurgical condition of the substratum. Among the specimens with different microstructures, the sensitized specimens had the highest bacterial density, followed by the solution annealed and the oxidized specimens. The same trend was shown by the total viable counts on the various surfaces, estimated by a plate count technique. The study assumes significance in the context of the widely reported observation of preferential attack of the welded region during microbiologically influenced corrosion of fabricated components.