ABSTRACT
PURPOSE: Considering the suggested advantages of cold atmospheric plasma (CAP) in increasing the fluoride uptake by the enamel, this study aimed to assess enamel erosion following the application of helium CAP and two types of fluoride varnishes. METHODS: The microhardness of 70 bovine enamel specimens was measured using a Vickers hardness tester. The specimens were randomly divided into 7 groups (n = 10): control, CAP (P), resin-containing fluoride varnish (RF), CAP + resin-containing fluoride varnish (PRF), fluoride varnish (F), CAP + fluoride varnish (PF), and erosion (E). The specimens in the control and erosion groups did not receive CAP or fluoride varnish. All specimens underwent erosive challenge 4 times/day using hydrochloric acid and artificial saliva except for the control specimens that remained in distilled water during the course of the study. After 5 days of erosive challenge, microhardness was measured again, and the percentage of microhardness change was calculated. Surface roughness of two specimens in each group was assessed by atomic force microscopy (AFM). Data were analyzed using one-way ANOVA followed by Tamhane's post-hoc test. RESULTS: The percentage of microhardness change in all groups was significantly higher than that of the control group. All groups showed significantly lower percentage of microhardness change compared with the E group except for the P group; no significant difference was noted in microhardness change of P and E groups. Other experimental groups had no significant difference with each other. Surface roughness was the highest in PRF and the lowest in the F group. CONCLUSION: CAP application had no significant effect on increasing the enamel resistance to erosion. However, enamel resistance to erosion increased significantly after fluoride varnish application alone or fluoride varnish application combined with CAP. No significant difference was noted between the two types of varnishes in this regard. CAP increased the surface roughness while fluoride varnish application alone decreased the roughness.
ABSTRACT
Introduction: Tooth hypersensitivity is among the most common patient complaints caused by the response of exposed dentin to external stimuli. No definite treatment has been suggested so far for dentin hypersensitivity (DH). This study aimed to compare the efficacy of the diode laser alone and in combination with Gluma and chromophore in occluding opened dentine tubules and the treatment of DH. Methods: This in vitro study was conducted on 30 extracted human third molars kept in 0.1% thymol solution. The teeth were mounted in transparent acrylic resin and the buccal enamel was cut to expose the outer third of dentin. The samples were then divided into 6 groups of negative control (no smear layer removal), positive control (smear layer removal with 6% citric acid application), 810 nm diode laser irradiation (energy density 55.55 J/cm2 , 1 W for 20 seconds in a continuous mode), chromophore (1 mg/mL indocyanine green, ICG) plus diode laser irradiation (1 W, 20 seconds), Gluma plus diode laser irradiation, and Gluma + chromophore + diode laser. Dentinal tubules were evaluated under a scanning electron microscope at x2000 magnification. The mean percentage of the obstruction of dentinal tubules was reported as mean and standard deviation. Considering the normal distribution of the data, two-way ANOVA was applied to compare the efficacy of treatments, and an independent-samples t test was used for pairwise comparisons at P<0.05 level of significance. Results: The highest mean percentage of the obstruction of dentinal tubules was noted in the diode laser/chromophore/Gluma group (65.68±12.31%) while the lowest value was noted in the diode laser/Gluma group (24.33±5.90%). Pairwise comparisons revealed significant differences between all groups (P <0.05) except for the difference between the laser/Gluma/chromophore and laser/ chromophore groups (P =0.20). Conclusion: It seems that chromophore increases the efficacy of the diode laser for the obstruction of dentinal tubules.
