ABSTRACT
We present our method to calculate the meteor limiting magnitude. The limiting meteor magnitude defines the faintest magnitude at which all meteors are still detected by a given system. An accurate measurement of the limiting magnitude is important in order to calculate the meteoroid flux from a meteor shower or sporadic source. Since meteor brightness is linked to meteor mass, the limiting magnitude is needed to calculate the limiting mass of the meteor flux measurement. The mass distribution of meteoroids is thought to follow a power law, thus being slightly off in the limiting magnitude can have a significant effect on the measured flux. Sky conditions can change on fairly short timescales; therefore one must monitor the meteor limiting magnitude at regular intervals throughout the night, rather than just measuring it once. We use the stellar limiting magnitude as a proxy of the meteor limiting magnitude. Our method for determining the stellar limiting magnitude and how we transform it into the meteor limiting magnitude is presented. These methods are currently applied to NASA's wide-field meteor camera network to determine nightly fluxes, but are applicable to other camera networks.
ABSTRACT
Most large (over a kilometre in diameter) near-Earth asteroids are now known, but recognition that airbursts (or fireballs resulting from nuclear-weapon-sized detonations of meteoroids in the atmosphere) have the potential to do greater damage than previously thought has shifted an increasing portion of the residual impact risk (the risk of impact from an unknown object) to smaller objects. Above the threshold size of impactor at which the atmosphere absorbs sufficient energy to prevent a ground impact, most of the damage is thought to be caused by the airburst shock wave, but owing to lack of observations this is uncertain. Here we report an analysis of the damage from the airburst of an asteroid about 19 metres (17 to 20 metres) in diameter southeast of Chelyabinsk, Russia, on 15 February 2013, estimated to have an energy equivalent of approximately 500 (±100) kilotons of trinitrotoluene (TNT, where 1 kiloton of TNT = 4.185×10(12) joules). We show that a widely referenced technique of estimating airburst damage does not reproduce the observations, and that the mathematical relations based on the effects of nuclear weapons--almost always used with this technique--overestimate blast damage. This suggests that earlier damage estimates near the threshold impactor size are too high. We performed a global survey of airbursts of a kiloton or more (including Chelyabinsk), and find that the number of impactors with diameters of tens of metres may be an order of magnitude higher than estimates based on other techniques. This suggests a non-equilibrium (if the population were in a long-term collisional steady state the size-frequency distribution would either follow a single power law or there must be a size-dependent bias in other surveys) in the near-Earth asteroid population for objects 10 to 50 metres in diameter, and shifts more of the residual impact risk to these sizes.
