ABSTRACT
OBJECTIVES: To evaluate ex vivo the efficacy of the integrated motor Tri Auto ZX2 in controlling the apical extent of preparation compared to conventional visual control (CVC) of the working length (WL). MATERIALS AND METHODS: Eighty standardized mandibular premolars were divided into five groups (n = 16). In the CVC group, instruments were used in continuous rotation (CR) and visual control performed by means of rubber stoppers. For each of the remaining groups, it was assigned a combination of a motion (CR or optimal torque reverse (OTR)), and an apical function (Auto Apical Reverse (AAR) or Optimum Apical Stop (OAS)). Root canals were prepared using the apical functions at 0.5 mark using an alginate model. Difference between the final WL and the actual length post-instrumentation was calculated. Data were analyzed statistically with the significance set at 5% (ANOVA, Tukey HSD). RESULTS: There was no difference in the mean WL among the groups, except between the CR combined to OAS compared to CVC (P > 0.05). Although CVC resulted in two cases beyond the foramen, no significant difference was found among the groups when comparing the distributions of measurements (P > 0.05). CONCLUSIONS: All combinations of motion and apical control functions of Tri Auto ZX2 provided an adequate apical limit ex vivo, similar to the visual control using rubber stoppers. CLINICAL RELEVANCE: TriAuto ZX2 was efficient to control the apical extent of preparation dispensing the need for calibrating the files, regardless of the different settings. This motor might potentially prevent over-instrumentation by continuously monitoring the apical limit.
Subject(s)
Dental Instruments , Root Canal Preparation , Dental Pulp Cavity , Electronics , Equipment Design , Odontometry , Tooth ApexABSTRACT
The aim of this study was to evaluate tubular dentin sealer penetration, comparing different final irrigation protocols using a conventional needle (CONV), EndoActivator system (EAS), EndoVac system (EVS), and ultrasound (PUI). Initially, fifty-two first maxillary molars with a single canal in the palatal root, without abrupt curvatures, resorptive processes, or previous endodontic treatment were selected for this study. Then, the crowns were sectioned to obtain palatal roots 15 mm in length. The root canals were prepared with the ProTaper Universal System and irrigated with 5% NaOCl. Afterwards, the specimens were divided into four groups (n. 13), according to the final irrigation protocol: CONV, EAS, EVS, and PUI. After filling, slices at 3 mm and 5 mm from the apex were obtained for analysis by confocal laser scanning microscopy. Two-way comparisons between the groups and the levels were performed with Games Howell's test (p < .05). Tubular dentin sealer penetration was higher at 5 mm compared with 3 mm from the apex (p < .05). The EAS group showed a higher percentage of tubular dentin sealer penetration, compared with the CONV group, at both levels. At 3 mm, there was no statistically significant difference among EAS, EVS, and PUI; however, these groups showed better performance, compared with the CONV group. At 5 mm, there was no statistically significant difference between the EAS and EVS groups, but both showed higher sealer penetration than the PUI group (p < .05). The EAS and EVS groups achieved better degrees of tubular dentin sealer penetration, compared with the other groups.