The effect of polymer properties on direct compression and drug release from water-insoluble controlled release matrix tablets.

The objective of this study was to identify and evaluate key polymer properties affecting direct compression and drug release from water-insoluble matrices. Commonly used polymers, such as Kollidon(®) SR, Eudragit(®) RS and ethyl cellulose, were characterized, formulated into tablets and compared with regard to their properties in dry and wet state. A similar site percolation threshold of 65% v/v was found for all polymers in dry state. Key parameters influencing polymer compactibility were the surface properties and the glass transition temperature (T(g)), affecting polymer elasticity and particle size-dependent binding. The important properties observed in dry state also governed matrix characteristics and therefore drug release in wet state. A low T(g) (Kollidon(®) SR

In situ forming implants for the delivery of metronidazole to periodontal pockets: formulation and drug release studies.

This study was performed to obtain prolonged drug release with biodegradable in situ forming implants for the local delivery of metronidazole to periodontal pockets. The effect of polymer type (capped and uncapped PLGA), solvent type (water-miscible and water-immiscible) and the polymer/drug ratio on in vitro drug release studies were investigated. In situ implants with sustained metronidazole release and low initial burst consisted of capped PLGA and N-methyl-2-pyrolidone as solvent. Mucoadhesive polymers were incorporated into the in situ implants in order to modify the properties of the delivery systems towards longer residence times in vivo. Addition of the polymers changed the adhesiveness and increased the viscosity and drug release of the formulations. However, sustained drug release over 10 days was achievable. Biodegradable in situ forming implants are therefore an attractive delivery system to achieve prolonged release of metronidazole at periodontal therapy.

PLGA in situ implants formed by phase inversion: critical physicochemical parameters to modulate drug release.

In situ forming implants (ISI) based on phase separation by solvent exchange represent an attractive alternative to conventional preformed implants and microparticles for parenteral applications. They are indeed easier to manufacture and their administration does not require surgery, therefore improving patient compliance. They consist of polymeric solutions precipitating at the site of injection and thus forming a drug eluting depot. Drug release from ISI is typically divided into three phases: burst during precipitation of the depot, diffusion of drug through the polymeric matrix and finally drug release by system degradation. This review gives a comprehensive overview on (i) the theoretical bases of these three phases, (ii) the parameters influencing them and (iii) the remaining drawbacks which have to be addressed to enlarge their commercial opportunities. Indeed, although some of them are already commercialized, ISI still suffer from limitations: mainly lack of reproducibility in depot shape, burst during solidification and potential toxicity. Nevertheless, depending on the targeted therapeutic application, these shortcomings may be transformed into advantages. As a result, keys are given in order to tailor these formulations in view of the desired application so that ISI could gain further clinical importance in the following years.