Assessment of polycyclic aromatic hydrocarbons in three environmental components from a tropical estuary in Northeast Brazil.

The evaluation of occurrence, risk quotient (RQ), bioaccumulation factor (BAF), and sources of PAH was conducted in Sergipe-Poxim estuarine system. PAH distribution that ranged from 7.1 to 30.9 ng L-1 (surface water, SW), 5.4 to 19.5 ng g-1 (sediment, S), and 4.3 to 18.1 ng g-1 (oyster, O), characterized the environment with low contamination; 2-3 (SW), 5-6 (S), and 4 (O) PAH rings accounted for 54.5%, 68.7%, and 87.7%, respectively, along with naphthalene (SW), dibenzo(a,h)anthracene (S), and pyrene (O) as the prevailing compounds. PCA suggested the predominance of particular groups related to SW (LMW-PAH), S (HMW-PAH), and O (pyrene and fluoranthene). Furthermore, one sample of O presented a high PAH bioavailability as shown through the BAF, with emphasis on pyrene (BAF = 26.8). The RQ showed a low to moderate range in SW and S; hence, in-depth information about the possible toxic effect in organisms of this region is required.

Application of Bar Adsorptive Microextraction for the Determination of Levels of Tricyclic Antidepressants in Urine Samples.

This work entailed the development, optimization, validation, and application of a novel analytical approach, using the bar adsorptive microextraction technique (BAµE), for the determination of the six most common tricyclic antidepressants (TCAs; amitriptyline, mianserin, trimipramine, imipramine, mirtazapine and dosulepin) in urine matrices. To achieve this goal, we employed, for the first time, new generation microextraction devices coated with convenient sorbent phases, polymers and novel activated carbons prepared from biomaterial waste, in combination with large-volume-injection gas chromatography-mass spectrometry operating in selected-ion monitoring mode (LVI-GC-MS(SIM)). Preliminary assays on sorbent coatings, showed that the polymeric phases present a much more effective performance, as the tested biosorbents exhibited low efficiency for application in microextraction techniques. By using BAµE coated with C18 polymer, under optimized experimental conditions, the detection limits achieved for the six TCAs ranged from 0.2 to 1.6 µg L-1 and, weighted linear regressions resulted in remarkable linearity (r2 > 0.9960) between 10.0 and 1000.0 µg L-1. The developed analytical methodology (BAµE(C18)/LVI-GC-MS(SIM)) provided suitable matrix effects (90.2-112.9%, RSD ≤ 13.9%), high recovery yields (92.3-111.5%, RSD ≤ 12.3%) and a remarkable overall process efficiency (ranging from 84.9% to 124.3%, RSD ≤ 13.9%). The developed and validated methodology was successfully applied for screening the six TCAs in real urine matrices. The proposed analytical methodology proved to be an eco-user-friendly approach to monitor trace levels of TCAs in complex urine matrices and an outstanding analytical alternative in comparison with other microextraction-based techniques.

Production of low-calorie structured lipids from spent coffee grounds or olive pomace crude oils catalyzed by immobilized lipase in magnetic nanoparticles.

In this study, crude oils extracted from spent coffee grounds (SCG) and olive pomace (OP) were used as raw-material to synthesize low-calorie triacylglycerols, either by acidolysis with capric acid, or by interesterification with ethyl caprate, in solvent-free media, catalyzed by sn-1,3 regioselective lipases. The Rhizopus oryzae lipase (ROL) was immobilized in magnetite nanoparticles (MNP-ROL) and tested as novel biocatalyst. MNP-ROL performance was compared with that of the commercial immobilized Thermomyces lanuginosus lipase (Lipozyme TL IM). For both oils, Lipozyme TL IM preferred interesterification over acidolysis. MNP-ROL catalyzed reactions were faster and acidolysis was preferred with yields of c.a. 50% new triacylglycerols after 3 h acidolysis of OP or SCG oils. MNP-ROL was very stable following the Sadana deactivation model with half-lives of 163 h and 220 h when reused in batch acidolysis and interesterification of OP oil, respectively.

Continuous flow reactor based with an immobilized biocatalyst for the continuous enzymatic transesterification of crude coconut oil.

Here, we have assessed the use of one packed bed or two packed bed reactors in series in which Burkholderia cepacia lipase (BCL) was immobilized on protic ionic liquid (PIL)-modified silica and used as a biocatalyst for the transesterification of crude coconut oil. Reaction parameters including volumetric flow, temperature, and molar ratio were evaluated. The conversion of transesterification reaction products (ethyl esters) was determined using gas chromatography and the quantities of intermediate products (diglyceride and monoglyceride [MG]) were assessed using high-performance liquid chromatography. Packed bed reactors in series produced ethyl esters with the greatest efficiency, achieving 65.27% conversion after 96 H at a volumetric flow rate of 0.50 mL Min-1 at 40 °C and a 1:9 molar ratio of oil to ethanol. Further, within the first 24 H of the reaction, increased MG (54.5%) production was observed. Molecular docking analyses were performed to evaluate the catalytic step of coconut oil transesterification in the presence of BCL. Molecular docking analysis showed that triglycerides have a higher affinity energy (-5.7 kcal mol-1 ) than the smallest MG (-6.0 kcal mol-1 ), therefore, BCL catalyzes the conversion of triglycerides rather than MG, which is consistent with experimental results.

Chemical characterisation of Piper amalago (Piperaceae) essential oil by comprehensive two-dimensional gas chromatography coupled with rapid-scanning quadrupole mass spectrometry (GC×GC/qMS) and their antilithiasic activity and acute toxicity.

INTRODUCTION: Piper amalago has a distribution from Mexico to Brazil; their aerial parts have been used in folk medicine to treat diuretic and kidney diseases. OBJECTIVE: The purpose of this study was to obtain a deeper understanding of the chemical composition of essential oils (EOs) extracted from both the leaves and stems of P. amalago, compare them, and evaluate their antilithiasic activity and acute toxicity. METHODOLOGY: Extraction was performed by hydrodistillation, whereas chemical characterisation by two-dimensional gas chromatography coupled with rapid-scanning quadrupole mass spectrometry (GC×GC/qMS). The antilithiasic activity was evaluated by the effect of the EOs on calcium oxalate crystallisation in vitro. The turbidity index and the number of crystals formed were determined and used as an estimative of the activity. In the acute toxicity assay, the effects of a single oral dose of the EOs in Wistar rats were determined. General behaviour, adverse effects, and mortality were determined. RESULTS: A total of 322 compounds were identified in the EOs. The sesquiterpenes displayed the highest contribution in leaves EOs among which included bicyclogermacrene and δ-cadinene. Sesquiterpenes and oxygenated sesquiterpenes displayed the highest contribution in EOs from stems, among which included bicyclogermacrene and α-cadinol. The EOs demonstrated an excellent action on the crystals growth inhibition, and the oral dose tested did not induce significant changes in the parameters for acute toxicity. CONCLUSION: The oils have a high chemical complexity, and there are differences between their compositions, which could explain the observed differences in antilithiasic activity. The findings support the use of this plant in folk medicine to treat kidney diseases.

Electrochemical and/or microbiological treatment of pyrolysis wastewater.

Electrochemical oxidation may be used as treatment to decompose partially or completely organic pollutants (wastewater) from industrial processes such as pyrolysis. Pyrolysis is a thermochemical process used to obtain bio-oil from biomasses, generating a liquid waste rich in organic compounds including aldehydes and phenols, which can be submitted to biological and electrochemical treatments in order to minimize its environmental impact. Thus, electrochemical systems employing dimensionally stable anodes (DSAs) have been proposed to enable biodegradation processes in subsurface environments. In order to investigate the organic compound degradation from residual coconut pyrolysis wastewater, ternary DSAs containing ruthenium, iridium and cerium synthetized by the 'ionic liquid method' at different calcination temperatures (500, 550, 600 and 700 °C) for the pretreatment of these compounds, were developed in order to allow posterior degradation by Pseudomonas sp., Bacillus sp. or Acinetobacter sp. bacteria. The electrode synthesized applying 500 °C displayed the highest voltammetric charge and was used in the pretreatment of pyrolysis effluent prior to microbial treatment. Regarding biological treatment, the Pseudomonas sp. exhibited high furfural degradation in wastewater samples electrochemically pretreated at 2.0 V. On the other hand, the use of Acinetobacter efficiently degraded phenolic compounds such as phenol, 4-methylphenol, 2,5-methylphenol, 4-ethylphenol and 3,5-methylphenol in both wastewater samples, with and without electrochemical pretreatment. Overall, the results indicate that the combination of both processes used in this study is relevant for the treatment of pyrolysis wastewater.

Quantification of nitrogen compounds in diesel fuel samples by comprehensive two-dimensional gas chromatography coupled with quadrupole mass spectrometry.

Although several methods for the analysis of nitrogen compounds in diesel fuel have been described in the literature, the demand for rapid, sensitive, and robust analyses has increased in recent years. In this study, a comprehensive two-dimensional gas chromatographic method was developed for the identification and quantification of nitrogen compounds in diesel fuel samples. The quantification was performed using the standard addition method and the analysis was conducted using comprehensive two-dimensional gas chromatography coupled with fast quadrupole mass spectrometry. This study is the first to report quantification of nitrogen compounds in diesel fuel samples using the standard addition method without fractionation. This type of analysis was previously performed using many laborious separation steps, which can lead to errors and losses. The proposed method shows good linearity for target nitrogen compounds evaluated (m-toluidine, 4-ethylaniline, indole, 7-methylindole, 7-ethylindole, carbazole, isoquinoline, 4-methylquinoline, benzo[h]quinolone, and acridine) over a range from 0.05 to 2.0 mg/L, and limits of detection and quantification of <0.06 and 0.16 mg/L, respectively, for all nitrogen compounds studied.

Preliminary studies of bio-oil from fast pyrolysis of coconut fibers.

This work studied fast pyrolysis as a way to use the residual fiber obtained from the shells of coconut ( Cocos nucifera L. var. Dwarf, from Aracaju, northeastern Brazil). The bio-oil produced by fast pyrolysis and the aqueous phase (formed during the pyrolysis) were characterized by GC/qMS and GC×GC/TOF-MS. Many oxygenated compounds such as phenols, aldehydes, and ketones were identified in the extracts obtained in both phases, with a high predominance of phenolic compounds, mainly alkylphenols. Eighty-one compounds were identified in the bio-oil and 42 in the aqueous phase using GC/qMS, and 95 and 68 in the same samples were identified by GC×GC/TOF-MS. The better performance of GC×GC/TOF-MS was due to the possibility of resolving some coeluted peaks in the one-dimension gas chromatography. Semiquantitative analysis of the samples verified that 59% of the area on the chromatogram of bio-oil is composed by phenols and 12% by aldehydes, mainly furfural. Using the same criterion, 77% of the organic compounds in the aqueous phase are phenols. Therefore, this preliminary assessment indicates that coconut fibers have the potential to be a cost-effective and promising alternative to obtain new products and minimize environmental impact.