Evaluation of serum and urine biomarkers for severe COVID-19.

Introduction: The new coronavirus disease, COVID-19, poses complex challenges exacerbated by several factors, with respiratory tissue lesions being notably significant among them. Consequently, there is a pressing need to identify informative biological markers that can indicate the severity of the disease. Several studies have highlighted the involvement of proteins such as APOA1, XPNPEP2, ORP150, CUBN, HCII, and CREB3L3 in these respiratory tissue lesions. However, there is a lack of information regarding antibodies to these proteins in the human body, which could potentially serve as valuable diagnostic markers for COVID-19. Simultaneously, it is relevant to select biological fluids that can be obtained without invasive procedures. Urine is one such fluid, but its effect on clinical laboratory analysis is not yet fully understood due to lack of study on its composition. Methods: Methods used in this study are as follows: total serum protein analysis; ELISA on moderate and severe COVID-19 patients' serum and urine; bioinformatic methods: ROC analysis, PCA, SVM. Results and discussion: The levels of antiAPOA1, antiXPNPEP2, antiORP150, antiCUBN, antiHCII, and antiCREB3L3 exhibit gradual fluctuations ranging from moderate to severe in both the serum and urine of COVID-19 patients. However, the diagnostic value of individual anti-protein antibodies is low, in both blood serum and urine. On the contrary, joint detection of these antibodies in patients' serum significantly increases the diagnostic value as demonstrated by the results of principal component analysis (PCA) and support vector machine (SVM). The non-linear regression model achieved an accuracy of 0.833. Furthermore, PCA aided in identifying serum protein markers that have the greatest impact on patient group discrimination. The study revealed that serum serves as a superior analyte for describing protein quantification due to its consistent composition and lack of organic salts and drug residues, which can otherwise affect protein stability.

Materials and Methods for All-Ceramic Dental Restorations Using Computer-Aided Design (CAD) and Computer-Aided Manufacturing (CAM) Technologies-A Brief Review.

The materials used in dentistry for the fabrication of all-ceramic restorations have undergone great and rapid developments over the last two decades. Among the most common ceramic materials in dentistry are those based on zirconium and lithium disilicate. Due to the properties of these materials, they are in great demand in the field of dental restoration production. Thus, dental restorations that will use those materials are commonly machined in CAD/CAM systems, which offer the possibility of manufacturing all-ceramic dental restorations in a very short period of time. This article reviews the modern materials in the field of all-ceramic dental restorations, their manufacturing processes, as well as what determines which ceramic materials are used for the production of CAD/CAM blanks and their production technology.

3Y-TZP/Ta Biocermet as a Dental Material: An Analysis of the In Vitro Adherence of Streptococcus Oralis Biofilm and an In Vivo Pilot Study in Dogs.

The surface adhesion of bacterial cells and the in vivo biocompatibility of a new ceramic-metal composite made of zirconium dioxide and tantalum were evaluated. Within the framework of an in vitro study using the crystal violet staining and colony counting methods, a relatively similar adhesion of Streptococcus oralis to the 3Y-TZP/Ta biocermet (roughness Ra = 0.12 ± 0.04 µm) and Ti-Al6-V4 titanium alloy (Ra = 0.04 ± 0.01 µm) was found. In addition, in an in vivo preliminary study focused on the histological analysis of a series of rods implanted in the jaws of beagle dogs for a six-month period, the absence of any fibrous tissue or inflammatory reaction at the interface between the implanted 3Y-TZP/Ta biocermets and the new bone was found. Thus, it can be concluded that the developed ceramic-metal biocomposite may be a promising new material for use in dentistry.

Adsorption Ability of Graphene Aerogel and Reduced Graphene Aerogel toward 2,4-D Herbicide and Salicylic Acid.

Within this work, new aerogels based on graphene oxide are proposed to adsorb salicylic acid (SA) and herbicide 2,4-Dichlorophenoxyacetic acid (2,4-D) from aqueous media. Graphene oxide aerogel (GOA) and reduced graphene oxide aerogel (rGOA) were obtained by freeze-drying processes and then studied by Raman spectroscopy, Fourier-transform infrared spectroscopy (FT-IR), and Brunauer-Emmett-Teller (BET) analysis. The influence of contact time and the concentration of the adsorbates were also assessed. It was found that equilibrium for high adsorption is reached in 150 min. In a single system, the pseudo-first-order, pseudo-second-order kinetic models, Intraparticle diffusion, and Elovich models were used to discuss the detail of the aerogel adsorbing pollutant. Moreover, the Langmuir, Freundlich, and Temkin adsorption models were applied to describe the equilibrium isotherms and calculate the isotherm constants.

Investigation of Tribological Characteristics of PEO Coatings Formed on Ti6Al4V Titanium Alloy in Electrolytes with Graphene Oxide Additives.

Coatings with a thickness from ~40 to ~50 µm on Ti6Al4V titanium alloys were formed by plasma electrolytic oxidation (PEO) in a silicate-hypophosphite electrolyte with the addition of graphene oxide. The PEO treatment was carried out in the anode-cathode mode (50 Hz) at a ratio of anode and cathode currents of 1:1; their sum density was 20 A/dm2, and the treatment's duration was 30 min. The effect of the graphene oxide's concentration in the electrolyte on the thickness, roughness, hardness, surface morphology, structure, composition, and tribological characteristics of the PEO coatings was studied. Wear experiments, under dry conditions, were carried out in a ball-on-disk tribotester with an applied load of 5 N, a sliding speed of 0.1 m·s-1, and a sliding distance of 1000 m. According to the obtained results, the addition of graphene oxide (GO) into the base silicate-hypophosphite electrolyte leads to a slight decrease in the coefficient of friction (from 0.73 to 0.69) and a reduction in the wear rate by more than 1.5 times (from 8.04 to 5.2 mm3/N·m), with an increase in the GO's concentration from 0 to 0.5 kg/m3, respectively. This occurs due to the formation of a GO-containing lubricating tribolayer upon contact with the coating of the counter-body in the friction pair. Delamination of the coatings during wear occurs due to contact fatigue; with an increase in the concentration of GO in the electrolyte from 0 to 0.5 kg/m3, this process slows down by more than four times.

Risk Factors for Heart Disease in Working Railwaymen.

Heart diseases are the most common non-communicable diseases worldwide. We examined the prevalence of risk factors for heart disease among a sub-population of working men. In total, 11,059 railway crew workers of the Russian Railways Company were included in the study. We also asked participants to answer several questions based on the WHO STEPwise approach to surveillance (STEPS) translated into Russian. Only 30% of drivers had normal body mass index (BMI), whereas 70% were overweight or obese. In 12% of subjects, total cholesterol was higher than 5 mmol/L. In 15% of participants, glucose level was higher than 5.5 mmol/L. 38% of drivers reported smoking. Physical inactivity was registered in 54% of persons. Only 29% ate according to the key principles of good diet quality. 24% of respondents had a family history of heart disease. MANOVA demonstrated that BMI was determined by age, profession, smoking, physical inactivity, and diet quality. As age increased, the number of people with normal cholesterol levels decreased. It was demonstrated that a correlation existed between glucose levels and BMI. In the total group, the correlation was 0.46 (p < .05). The correlation between those parameters increased due to age, from 0.33 in the <30 years of age group up to 0.52 in the >50 years of age group. This study demonstrated that there is a high prevalence of risk factors for heart disease in train drivers in the Russian Federation.

The study of the relevance of macro- and microelements in the hair of young wrestlers depending on the style of wrestling.

While participating in an intensive training process, the athlete's body requires not only energy, but also specific macro- and microelements. The purpose of this study was to show the meaning of monitoring the level of mineral trace elements in athletes-wrestlers during physical activity. As an experimental group, 66 male wrestlers aged 18-20 years with at least 3 years of intensive wrestling experience were examined. The control group consisted of 92 young cadets of military school aged 18-20 years, who had previous sports training, but were not engaged in wrestling. To determine the quantitative content of trace elements, the hair was cut from the back of the head for the entire length in an amount of at least 0.1 g. an examined using the mass spectrometer ICP-MS Agilent 7900. Strong positive correlations were found for sodium with potassium and rubidium, magnesium with calcium, potassium with rubidium, and rubidium with caesium among wrestlers. Wrestlers were found to have higher levels of a number of macro- and microelements, including toxic ones.

Investigation of MAO Coatings Characteristics on Titanium Products Obtained by EBM Method Using Additive Manufacturing.

Coatings with a thickness from 27 to 62 µm on electron beam melted Ti-6Al-4V have been formed by micro-arc oxidation (MAO) in a silicate-hypophosphite electrolyte. MAO tests in the anode-cathode mode (50 Hz) with an anode-to-cathode current ratio of 1:1 and sum current densities 10 and 20 A/dm2 were carried out. The duration of the MAO treatment was 30 and 60 min. The effect of the processing parameters on the structural properties of the MAO treated coatings was studied. The current density and treatment time significantly affect the coating thickness and surface roughness. The values of these characteristics increase as the current density increases. The effect of thermal cycling tests on surface morphology, thickness and roughness, and elemental and phase composition of MAO coatings was analyzed. After 50 cycles of thermal cycling from +200 °C to -50 °C, no cracking or delamination of coatings was observed. Coatings formed in 30 min at a current density of 20 A/dm2 turned out to be the best in terms of such indicators as surface morphology, thickness, and roughness.

Prevalence and Risk of Dental Erosion in Patients with Gastroesophageal Reflux Disease: A Meta-Analysis.

AIM: The present paper aims to systematize data concerning the prevalence and risk of dental erosion (DE) in adult patients with gastroesophageal reflux disease (GERD) compared to controls. MATERIALS AND METHODS: Core electronic databases, i.e., MEDLINE/PubMed, EMBASE, Cochrane, Google Scholar, and the Russian Science Citation Index (RSCI), were searched for studies assessing the prevalence and risk of DE in adult GERD patients with publication dates ranging from 1 January 1985 to 20 January 2022. Publications with detailed descriptive statistics (the total sample size of patients with GERD, the total sample size of controls (if available), the number of patients with DE in the sample of GERD patients, the number of patients with DE in the controls (if available)) were selected for the final analysis. RESULTS: The final analysis included 28 studies involving 4379 people (2309 GERD patients and 2070 control subjects). The pooled prevalence of DE was 51.524% (95 CI: 39.742-63.221) in GERD patients and 21.351% (95 CI: 9.234-36.807) in controls. An association was found between the presence of DE and GERD using the random-effects model (OR 5.000, 95% CI: 2.995-8.345; I2 = 79.78%) compared with controls. When analyzing studies that only used validated instrumental methods for diagnosing GERD, alongside validated DE criteria (studies that did not specify the methodologies used were excluded), a significant association between the presence of DE and GERD was revealed (OR 5.586, 95% CI: 2.311-13.503; I2 = 85.14%). CONCLUSION: The meta-analysis demonstrated that DE is quite often associated with GERD and is observed in about half of patients with this extremely common disease of the upper gastrointestinal tract.

Risk Factors for Locomotive Crew Members Depending on Their Place of Work.

PURPOSE: The purpose of this study is to examine the prevalence of workplace exposure, behavior, and individual health conditions, along with resulting medical activity among locomotive crew members depending on their place of work. PATIENTS AND METHODS: Participants included 5585 train drivers and 3723 train drivers' assistants (7% of the total train operators in the Russian Federation). Measured height and weight were used to calculate body mass index (BMI), and waist circumference, pulse rate, and blood pressure were also measured. The risk assessment was conducted using the STEPS tool. The level of commitment to a Healthy Lifestyle was assessed based on World Health Organization recommendations. Occupational risk factors were surveyed. Morbidity was analyzed over the past year. RESULTS: The lowest frequency of work exposure risk factors was found for employees of the Trans-Baikal railway; the highest was among Krasnoyarsk, North, and South-East. The participants from the Far East and October Railways had the lowest self-reported frequency of behavioral risk factors. The participants from the Eastern Siberian, October, and Southern Urals railways had the lowest occurrence of individual health conditions. The participants from the East Siberian, Far East, Kuibyshev, and Sverdlovsk railways were the least likely to visit their doctor, take temporary disability leave, or be hospitalized. The total assessed Healthy Lifestyle commitment index was higher for participants from the Far Eastern and Southern Urals railways. The participants from the Moscow and October railways were the least committed to a Healthy Lifestyle. CONCLUSIONS: Significant differences exist between risk factors and Healthy Lifestyle commitment between railways. Future research should examine changes due to a new corporate health program introduced in 2020.