The Impact of Intergrain Phases on the Ionic Conductivity of the LAGP Solid Electrolyte Material Prepared by Spark Plasma Sintering.

Li1.5Al0.5Ge1.5(PO4)3 (LAGP) is a promising oxide solid electrolyte for all-solid-state batteries due to its excellent air stability, acceptable electrochemical stability window, and cost-effective precursor materials. However, further improvement in the ionic conductivity performance of oxide solid-state electrolytes is hindered by the presence of grain boundaries and their associated morphologies and composition. These key factors thus represent a major obstacle to the improved design of modern oxide based solid-state electrolytes. This study establishes a correlation between the influence of the grain boundary phases, their 3D morphology, and compositions formed under different sintering conditions on the overall LAGP ionic conductivity. Spark plasma sintering has been employed to sinter oxide solid electrolyte material at different temperatures with high compacity values, whereas a combined potentiostatic electrochemical impedance spectroscopy, 3D FIB-SEM tomography, XRD, and solid-state NMR/materials modeling approach provides an in-depth analysis of the influence of the morphology, structure, and composition of the grain boundary phases that impact the total ionic conductivity. This work establishes the first 3D FIB-SEM tomography analysis of the LAGP morphology and the secondary phases formed in the grain boundaries at the nanoscale level, whereas the associated 31P and 27Al MAS NMR study coupled with materials modeling reveals that the grain boundary material is composed of Li4P2O7 and disordered Li9Al3(P2O7)3(PO4)2 phases. Quantitative 31P MAS NMR measurements demonstrate that optimal ionic conductivity for the LAGP system is achieved for the 680 °C SPS preparation when the disordered Li9Al3(P2O7)3(PO4)2 phase dominates the grain boundary composition with reduced contributions from the highly ordered Li4P2O7 phases, whereas the 27Al MAS NMR data reveal that minimal structural change is experienced by each phase throughout this suite of sintering temperatures.

Synthesis of Mesoporous Lithium Titanate Thin Films and Monoliths as an Anode Material for High-Rate Lithium-Ion Batteries.

Mesoporous Li4 Ti5 O12 (LTO) thin film is an important anode material for lithium-ion batteries (LIBs). Mesoporous films could be prepared by self-assembly processes. A molten-salt-assisted self-assembly (MASA) process is used to prepare mesoporous thin films of LTOs. Clear solutions of CTAB, P123, LiNO3 , HNO3 , and Ti(OC4 H9 )4 in ethanol form gel-like meso-ordered films upon either spin or spray coating. In the assembly process, the CTAB/P123 molar ratio of 14 is required to accommodate enough salt species in the mesophase, in which the LiI /P123 ratio can be varied between molar ratios of 28 and 72. Calcination of the meso-ordered films produces transparent mesoporous spinel LTO films that are abbreviated as Cxx-yyy-zzz or CAxx-yyy-zzz (C=calcined, CA=calcined-annealed, xx=LiI /P123 molar ratio, and yyy=calcination and zzz=annealing temperatures in Celsius) herein. All samples were characterized by using XRD, TEM, N2 -sorption, and Raman techniques and it was found that, at all compositions, the LTO spinel phase formed with or without an anatase phase as an impurity. Electrochemical characterization of the films shows excellent performance at different current rates. The CA40-350-450 sample performs best among all samples tested, yielding an average discharge capacity of (176±1) mA h g-1 at C/2 and (139±4) mA h g-1 at 50 C and keeping 92 % of its initial discharge capacity upon 50 cycles at C/2.