ABSTRACT
Co-extrusion is commonly used to produce polymer multilayer products with different materials tailoring the property profiles. Adhesion between the individual layers is crucial to the overall performance of the final structure. Layer adhesion is determined by the compatibility of the polymers at the interface and their interaction forces, causing for example the formation of adhesive or chemical bonds or an interdiffusion layer. Additionally, the processing conditions, such as temperature, residence time, cooling rate, and interfacial shear stress, have a major influence on the interactions and hence resulting layer adhesion. Influences of temperature and residence time are already quite well studied, but influence of shear load on the formation of an adhesion layer is less explored and controversially discussed in existing literature. In this work, we investigated the influence of different processing conditions causing various shear loads on layer adhesion for a two-layer co-extruded polymer sheet using a polypropylene and polypropylene talc compound system. Therefore, we varied the flow rates and the flow geometry of the die. Under specific conditions interfacial flow instabilities are triggered that form micro layers in the transition regime between the two layers causing a major increase in layer adhesion. This structure was analyzed using confocal Raman microscopy. Making use of these interfacial flow instabilities in a controlled way enables completely new opportunities and potentials for multi-layer products.
ABSTRACT
Co-extrusion is a widely used processing technique for combining various polymers with different properties into a tailored multilayer product. Individual melt streams are combined in a die to form the desired shape. Under certain conditions, interfacial flow instabilities are observed; however, fundamental knowledge about their onset and about critical conditions in science and industry is scarce. Since reliable identification of interfacial co-extrusion flow instabilities is essential for successful operation, this work presents in situ measurement approaches using a novel co-extrusion demonstrator die, which is fed by two separate melt streams that form a well-controlled two-layer co-extrusion polymer melt flow. An interchangeable cover allows installation of an optical coherence tomography (OCT) sensor and of an ultrasonic (US) measurement system, where the former requires an optical window and the latter good direct coupling with the cover for assessment of the flow situation. The feasibility of both approaches was proven for a material combination that is typically found in multilayer packaging applications. Based on the measurement signals, various parameters are proposed for distinguishing reliably between stable and unstable flow conditions in both measurement systems. The approaches presented are well suited to monitoring for and systematically investigating co-extrusion flow instabilities and, thus, contribute to improving the fundamental knowledge about instability onset and critical conditions.