ABSTRACT
The ion beam optics for the neutral beam injection system on HL-2A Tokomak is studied by two- dimensional numerical simulation program firstly, where the emitting surface is taken at 100 Debye lengths from the plasma electrode. The mathematical formulation, computation techniques are described. Typical ion orbits, equipotential contours, and emittance diagram are shown. For a fixed geometry electrode, the effect of plasma density, plasma potential and plasma electron temperature on ion beam optics is examined, and the calculation reliability is confirmed by experimental results. In order to improve ion beam optics, the application of a small pre-acceleration voltage (â¼100 V) between the plasma electrode and the arc discharge anode is reasonable, and a lower plasma electron temperature is desired. The results allow optimization of the ion beam optics in the neutral beam injection system on HL-2A Tokomak and provide guidelines for designing future neutral beam injection system on HL-2M Tokomak.
ABSTRACT
The discharge gas pressure is a key factor to influence the extracted current of ion source. In this paper, the dependence of extracted current on discharge gas pressure was investigated in detail at different arc discharge currents. The discharge gas pressure with a very broad range (0.1 Pa-2.7 Pa) was scanned for the first time. It is turned out that, with the increasing of discharge gas pressure, the extracted current increases and the arc voltage decreases at different arc currents; however, when the discharge gas pressure exceeds a certain value, the extracted current decreases. For the same discharge gas pressure, the higher the arc current, the higher the arc voltage and the extracted current are. The arc efficiency was also calculated, and its dependence on gas pressure was almost the same with the dependence of extracted current on gas pressure, but at the same discharge gas pressure, the lower the arc current, the higher the arc efficiency is and the lower the extracted current is.
