ABSTRACT
The objective of this study is to optimize the ultrasonic-assisted extraction process of Ku Shen (Sophorae Flavescentis Radix) extracts (KSE) against Vibrio parahaemolyticus and explore their anti-biofilm activity and mechanism of action. The ultrasonic-assisted extraction process of KSE optimized by single factor experiment, Box-Behnken design and response surface methodology was as follows: 93% ethanol as solvent, liquid/material ratio of 30 mL/g, ultrasonic power of 500 W, extraction temperature of 80°C and time of 30 min. Under these conditions, the diameter of inhibition circle of KSE was 15.60 ± 0.17 mm, which had no significant difference with the predicted value. The yield of dried KSE is 32.32 ± 0.57% and the content of total flavonoids in KSE was 57.02 ± 5.54%. The minimum inhibitory concentration (MIC) and minimum bactericidal concentration (MBC) of KSE against V. parahaemolyticus were 0.25 and 0.5 mg/mL, respectively. Crystal violet staining, Congo red plate, spectrophotometry, CCK-8 and scanning electron microscopy were used to investigate the activity and mechanism of action of KSE against V. parahaemolyticus biofilm. The results showed that the sub-MIC of KSE could significantly inhibit biofilm formation, reduce the synthesis of polysaccharide intercellular adhesin (PIA) and the secretion of extracellular DNA. In addition, the inhibition rate of biofilm formation and clearance rate of mature biofilm of 1.0 mg/mL KSE were 85.32 and 74.04%, and the reduction rate of metabolic activity of developing and mature biofilm were 77.98 and 74.46%, respectively. These results were confirmed by visual images obtained by scanning electron microscopy. Therefore, KSE has the potential to further isolate the anti-biofilm agent and evaluate it for the preservation process of aquatic products.
ABSTRACT
Polymer creep can significantly reduce the safety and dependability of composite applications, restricting their development and use in additional fields. In this study, single-factor and multi-factor analysis techniques were employed to systematically explore the impacts of nickel powder and graphene on the resistive creep of sensing units. The creep model between the rate of resistance changes and the pressure was established, and the material ratio was optimized to obtain a high creep resistance. The results demonstrated that the creep resistance was best when the filling particle was 10 wt.% and the ratio of nickel powder to graphene was 4:21, which was approximately 60% and 45% lower than the filling alone and the composite filling before optimization, respectively; the R2 of the theoretical value of the resistance creep model and the experimental value of the creep before and after optimization was 0.9736 and 0.9812, indicating that the resistance creep model was highly accurate. Consequently, the addition of filler particles with acceptable proportions, varied shapes, and different characteristics to polymers can effectively reduce polymer creep and has significant potential for the manufacture of sensing units for tactile sensors.
