ABSTRACT
We have designed a method of harvesting electrical energy using plasmon-enhanced light pressure. A device was fabricated as a cut cone structure that optimizes light collection so that the weak incident light pressure can be sufficiently enhanced inside the cut cone to generate electrical energy. An increase in the device's current output is a strong indication that the pressure of incident light has been enhanced by the surface plasmons on a platinum layer inside the cut cone. The electrical energy harvested in a few minutes by irradiating pulsed laser light on a single micro device was possible to illuminate a blue LED.
ABSTRACT
In this paper, we demonstrated a multiscale micro- and nano-structured magneto-mechano-triboelectric nanogenerator (MMTENG) enabled by a salt particle imprinting process to power an internet of thing (IoT) sensor. The fine salt particles were utilized to form a multiscale structure on a triboelectric polymer film by mechanical pressure via an eco-friendly, low-cost, and simple process, thereby reinforcing the contact triboelectrification and electrostatic induction. The surface modified MMTENG can generate an open-circuit peak-to-peak voltage of 851 V, a short-circuit current of 155 µA, and a maximum peak power of 10.3 mW under an AC magnetic field of 8 Oe. The energy device also presented output stability over 124 million operating cycles. Finally, the electricity of the surface enhanced MMTENG device was directly utilized to power an IoT temperature sensor with integration of an energy harvester, energy conversion circuit, and storage capacitor.
ABSTRACT
Dielectric ceramic film capacitors, which store energy in the form of electric polarization, are promising for miniature pulsed power electronic device applications. For a superior energy storage performance of the capacitors, large recoverable energy density, along with high efficiency, high power density, fast charge/discharge rate, and good thermal/fatigue stability, is desired. Herein, we present highly dense lead-free 0.942[Na0.535K0.480NbO3]-0.058LiNbO3 (KNNLN) ferroelectric ceramic thick films (â¼5 µm) demonstrating remarkable energy storage performance. The nanocrystalline KNNLN thick film fabricated by aerosol deposition (AD) process and annealed at 600 °C displayed a quasi-relaxor ferroelectric behavior, which is in contrast to the typical ferroelectric nature of the KNNLN ceramic in its bulk form. The AD film exhibited a large recoverable energy density of 23.4 J/cm3, with an efficiency of over 70% under the electric field of 1400 kV/cm. Besides, an ultrahigh power density of 38.8 MW/cm3 together with a fast discharge speed of 0.45 µs, good fatigue endurance (up to 106 cycles), and thermal stability in a wide temperature range of 20-160 °C was also observed. Using the AD process, we could make a highly dense microstructure of the film containing nano-sized grains, which gave rise to the quasi-relaxor ferroelectric characteristics and the remarkable energy storage properties.
