In Situ Electrochemical Recovery: Sediment Transformation under Chromium Poisoning in Reversible Solid Oxide Cells with La0.6Sr0.4Co0.2Fe0.8O3-σ-Based Oxygen Electrodes.

Reversible solid oxide cells (RSOCs) are an all-solid-state electrochemical device, which can convert H2 into electricity in the fuel cell (SOFC) mode and electrolyze H2O into fuel gas in the electrolytic cell (SOEC) mode, exhibiting good application prospect in the development of carbon neutrality. However, the degradation of the air electrode caused by Cr-containing steel interconnects is a major obstacle that limits the broader application of RSOCs. Herein, the Cr poisoning effect on La0.6Sr0.4Co0.2Fe0.8O3-σ (LSCF)-based oxygen electrodes under the electrolysis mode was systematically investigated. The phase transition of the sediment during the chromium poisoning process was captured and monitored. When tested under the presence of Fe-Cr interconnects at 800 °C for 40 h, SrCrO4 on the surface of LSCF was clearly identified through XRD and Raman analysis as the main deposition, and with the prolonged operating time, LaCrO3 slowly emerged. Due to the much higher electrical conductivity of LaCrO3 compared to SrCrO4, the negative effect induced by Cr poisoning was offset along with test progressing due to the deposition transition phenomenon. Inspired by the interesting discoveries, transition from SrCrO4 to LaCrO3 can be artificially facilitated by switching the operating mode to the SOEC mode, which can partially recover the dramatic degradation caused by the Cr poisoning effect under the SOFC mode. The feasibility of the in situ electrochemical recovery method was also verified by the experimental results. The peak power density of the cells decreased from 0.829 to 0.505 W/cm2 when operating under the SOFC mode with an Fe-Cr metal connector, and after in situ electrochemical recovery in the SOEC mode, the peak power density recovered to 0.630 W/cm2. This study provides a new strategy for achieving high performance and stability of RSOCs.

A Pyrene-Fused Dimerized Acceptor for Ternary Organic Solar Cells with 19% Efficiency and High Thermal Stability.

A pyrene-fused dimerized electron acceptor has been successfully synthesized and subsequently incorporated as the third component in ternary organic solar cells (OSCs). Diverging from the traditional dimerized acceptors with a linear configuration, this novel electron acceptor displays a distinctive "butterfly-like" structure, comprising two Y-acceptors as wings fused with a pyrene-based backbone. The extended π-conjugated backbone and the electron-donating nature of pyrene enable the new acceptor to show low solubility, elevated glass transition temperature (Tg ), and low-lying frontier energy levels. Consequently, the new dimerized acceptor seamlessly integrates as the third component into ternary OSCs, enhancing electron transporting properties, reducing non-radiative voltage loss, and elevating open-circuit voltage. These merits have enabled the ternary OSCs to show an exceptional efficiency of 19.07%, a marked improvement compared to the 17.6% attained in binary OSCs. More importantly, the high Tg exhibited by the pyrene-fused electron acceptor helps to stabilize the morphology of the photoactive layer thermal-treated at 70 °C, retaining 88.7% efficiency over 600 hours. For comparison, binary OSCs experience a decline to 73.7% efficiency after the same duration. These results indicate that the "butterfly-like" design and the incorporation of a pyrene unit is a promising strategy in the development of dimerized electron acceptors for OSCs.