ABSTRACT
Mixed films containing a conjugated "molecular wire" candidate and an "insulating" fatty acid have been prepared by the Langmuir-Blodgett technique. Specifically, this paper reports the fabrication of mixed films as well as miscibility studies of 4-[4-(4-hexyloxyphenylethynyl)phenylethynyl]benzoic acid (HBPEB) and docosanoic (or behenic) acid (BA). Surface pressure vs. area per molecule isotherms were recorded, with excess area and excess Gibbs energy of mixing calculated. Surface potential-area per molecule isotherms were also recorded for mixtures over the whole range of mole fractions, with negative deviations from the additivity rule revealing orientational changes induced in the HBPEB molecules. The Langmuir films were transferred onto solid supports and characterized by SPM techniques, with atomic force microscopy (AFM) revealing that well-ordered, defect-free films are obtained. The use of scanning polarization force microscopy (SPFM), which provides non-contact imaging based on differences in surface charge distribution, i.e., surface potential, provides complimentary information regarding distribution of the components within the mixed films. From the comprehensive miscibility study performed, which includes thermodynamic and imaging methods, it can be concluded that the wire-like molecule and the fatty acid are miscible over the 0-0.1 and 0.8-1 ranges of HBPEB mole fraction while phase separation occurs for HBPEB mole fractions over the 0.1-0.8 range.
ABSTRACT
This paper reports the fabrication and characterization of Langmuir and Langmuir-Blodgett (LB) films incorporating an oligo(phenylene-ethynylene) (OPE) derivative, namely, 4-[4-(4-hexyloxyphenylethynyl)-phenylethynyl]-benzoic acid (HBPEB). Conditions appropriate for deposition of monolayers of HBPEB at the air-water interface have been established and the resulting Langmuir films characterized by a combination of surface pressure and surface potential versus area per molecule isotherms, Brewster angle microscopy, and ultraviolet reflection spectroscopy. The Langmuir films are readily transferred onto solid substrates, and one-layer LB films transferred at several surface pressures onto mica substrates have been analyzed by means of atomic force microscopy, from which it can be concluded that 14 mN/m is an optimum surface pressure of transference, giving well-ordered homogeneous films without three-dimensional defects and a low surface roughness. The optical and emissive properties of the LB films have been determined with significant blue-shifted absorption spectra indicating formation of two-dimensional H aggregates and a Stokes shift illustrating the effects of the solid-like environment on the molecular chromophore.
ABSTRACT
A molecular dyad has been synthesized in which the main chromophore is a 1,4-diethynylated benzene residue terminated with pyrene moieties, this latter unit acting as a single chromophore. A spiropyran group has been condensed to the central phenylene ring so as to position a weak electron donor close to the pyrene unit. Illumination of the pyrene-based chromophore leads to formation of a fluorescent exciplex in polar solvents but pyrene-like fluorescence is observed in nonpolar solvents. The exciplex has a lifetime of a few nanoseconds and undergoes intersystem crossing to the pyrene-like triplet state with low efficiency. Attaching a 4-nitrobenzene group to the open end of the spiropyran unit creates a new route for decay of the exciplex whereby the triplet state of the spiropyran is formed. Nonradiative decay of this latter species results in ring opening to form the corresponding merocyanine species. Rate constants for the various steps have been obtained from time-resolved fluorescence spectroscopy carried out over a modest temperature range. Under visible light illumination, the merocyanine form reverts to the original spiropyran geometry so that the cycle is closed. Energy transfer from the pyrene chromophore to the merocyanine unit leads to an increased rate of ring closure and serves to push the steady-state composition in favor of the spiropyran form.
ABSTRACT
The torsional motions of jet-cooled 1,4-bis(phenylethynyl)benzene (BPEB), a prototype molecular wire, were studied using cavity ring-down spectroscopy in the first UV absorption band (316-321 nm). The torsional spectrum of 1,4-bis(phenylethynyl)-2,3,5,6-tetradeuteriobenzene was also recorded in the gas phase. Both spectra were successfully simulated using simple cosine potentials to describe the torsional motions. The ground-state barrier to rotation was estimated to be 220-235 cm(-1), which is similar to that of diphenylacetylene (tolane). Complementary DFT calculations were found to overestimate the torsional barrier.
ABSTRACT
Donor-acceptor phenylene ethynylene systems containing the 6-methylpyran-2-one group, synthesized via classic or microwave-assisted Sonogashira cross-coupling, exhibit pronounced solvatochromism in fluorescence suggesting a highly polar excited state; 4-[4-(4-N,N-dihexylaminophenylethynyl)phenylethynyl]-6-methylpyran-2-one has a fluorescence quantum yield >0.9 in cyclohexane.
