Validation of the Manufacturing Methodology of Prestressed Fiber-Reinforced Polymer Concrete by the Variation of Process Parameters.

Polymer concrete has proved to be advantageous in machine building for many years thanks to its excellent damping properties. Until now, its use was limited to machine beds due to its comparatively low tensile strength. Its use in moving structural components has not been possible until now. Recent research results have shown that this challenge can be met by integrating prestressed carbon fibers. Until now, the production of samples out of prestressed fiber-reinforced polymer concrete has been carried out according to fixed specifications. It is not yet clear whether these specifications are suitable to fully exploit the potential of the material. Samples manufactured to these specifications show at least a large scatter in bending stiffness. Within the scope of this paper, the existing manufacturing process is validated by the variation of process steps. Specifically, this involved the use of a shaker, variation of the dwell time in the mold, variation of the resin content, and the procedure for impregnating the fibers. The characterization of the samples showed that the scatter could only be reduced by increasing the dwell time. However, this leads to a decrease in bending stiffness and, thus, is not suitable for further improvement of the novel material.

Determination of the Tool-Chip Contact Length for the Cutting Processes.

The thermomechanical interaction of the tool with the chip in the most loaded secondary cutting zone depends on the contact length of the tool rake face with the chip. Experimental studies of the dependency of the contact length on the cutting speed, the undeformed chip thickness, and the tool rake angle, performed by the optical method, are used for comparison with the contact length obtained by the FE modeling of the orthogonal cutting process. To determine the parameters of the constitutive Johnson-Cook equation, which serves as a material model of the FE cutting model that has a predominant influence on the contact length, a software-implemented algorithm was developed. This algorithm is based on determining the generalized parameters of the constitutive equation through finding the intersection of these parameter sets. The plurality intersection of the parameter sets of the constitutive equation is determined by means of the design of experiments and refined by subsequent multiple iterations. The comparison of the contact length values, obtained by simulating the cutting process using the generalized parameters of the constitutive equation as a material model with their experimental values, does not exceed 12% for a wide range of cutting speeds and depths of cut, as well as for the tool rake angle.

Inverse Determination of Johnson-Cook Parameters of Additively Produced Anisotropic Maraging Steel.

In powder bed-based additive manufacturing (AM), complex geometries can be produced in a layer-wise approach. Results of material science experiments regarding material property identification, e.g., tensile strength, show interdependencies between the test load direction and the layer orientation. This goes hand-in-hand with the measured cutting force, changing with the relative angle between cutting direction and layer orientation in orthogonal cutting tests. However, due to the specific process characteristics, the layer orientation results in anisotropic material properties. Therefore, during machining, the material behaves depending on the buildup direction, which influences the cutting process. To predict this behavior, a simplified inverse approach is developed to determine the buildup direction-dependent parameters of a modified Johnson-Cook model for cutting simulation. To qualify these cutting models, mainly the cutting force and additionally the chip formation examined during orthogonal cuts are used. In the present paper, the influence of the laser-powder-bed-fusion (LPBF) process parameters on subtractive post-processing are shown. A good agreement between verification experiments and simulations is achieved.