Mallampati score in patients with temporomandibular joint disorders: A pilot case-control study.

OBJECTIVES: Temporomandibular joint disorder (TMD) is defined as any functional abnormalities in different parts of the face and neck. The Mallampati index is an indicator for determining the extent of airway blockage. No study has examined the relationship between TMD and Mallampati score. Most studies have investigated the relationship between temporomandibular joint problems and sleep problems. This pilot study aimed to assess the Mallampati index scores among TMD patients. MATERIAL AND METHODS: Eighty-four people were divided into the case (based on RDC/TMD) and control groups. Demographic information, neck circumference, tongue size, Mallampati score, and other variables were asked of people. STOP-BANG and Pittsburgh Sleep Quality Index (PSQI) were also completed for each patient. Data were analyzed with Chi-square, Fisher's exact, and Mann-Whitney tests. RESULTS: The Mallampati and PSQI questionnaire scores in the case group were significantly higher than those in the control group (p < 0.001). The results showed that larger tongue and neck circumference patients had a higher Mallampati score. Pearson correlation coefficient showed that the Mallampati score had a direct and significant relationship with body mass index and PSQI (p < 0.001). CONCLUSIONS: The results of this study show that Mallampati scores were significantly higher among patients with TMD than among healthy individuals.

Efficacy and clinical predictors of response to rTMS treatment in pharmacoresistant obsessive-compulsive disorder (OCD): a retrospective study.

BACKGROUND: Application of repetitive transcranial magnetic stimulation (rTMS) for treating obsessive-compulsive disorder (OCD) has been promising and approved by the Food and Drug Administration in 2018, but effects differ between patients. Knowledge about clinical predictors of rTMS response may help to increase clinical efficacy but is not available so far. METHODS: In a retrospective study, we investigated the efficacy of rTMS over the dorsolateral prefrontal cortex (DLPFC) or supplementary motor area (SMA) in 65 pharmaco-resistant OCD outpatients recruited for rTMS treatment from July 2015 to May 2017. Patients received either SMA rTMS (n = 38) or bilateral DLPFC rTMS (n = 27) in case of reporting higher affective and depressive symptoms in addition to the primary OCD symptoms. OCD symptoms and depression/anxiety states were measured at baseline (before the 1st session) and after the 20th session of rTMS. Additionally, we performed a binary logistic regression analysis on the demographic and clinical variables based on the Yale-Brown Obsessive-Compulsive Scale (Y-BOCS) 3-factor and 2-factor models and individual items to investigate potential predictors of rTMS response. RESULTS: Patients' scores in Y-BOCS and Beck anxiety/depression inventories were significantly decreased following rTMS treatment. 46.2% of all patients responded to rTMS, based on the criterion of at least a 30% reduction in Y-BOCS scores. There was no significant difference between response rates of patients in DLPFC and SMA groups. No significant demographic predictors of rTMS efficacy were identified. The factors "obsession severity", "resistance" and "disturbance" and the "interference due to obsessions" and "resistance against compulsions" items of the Y-BOCS significantly predicted response to rTMS. CONCLUSIONS: In patients with less intrusive/interfering thoughts, and low scores in the "obsession severity", "disturbance", and "resistance" factors, rTMS might have superior effects. Identifying clinical and non-clinical predictors of response is relevant to personalize and adapt rTMS protocols in pharmaco-resistant OCD patients. Interpretation of rTMS efficacy should be done with caution due to the lack of a sham intervention condition.

Evaluation of condylar positions in patients with temporomandibular disorders: A cone-beam computed tomographic study.

PURPOSE: This study was performed to compare the condylar position in patients with temporomandibular joint disorders (TMDs) and a normal group by using cone-beam computed tomography (CBCT). MATERIALS AND METHODS: In the TMD group, 25 patients (5 men and 20 women) were randomly selected among the ones suffering from TMD according to the Research Diagnostic Criteria for Temporomandibular Disorders (RDC/TMD). The control group consisted of 25 patients (8 men and 17 women) with normal temporomandibular joints (TMJs) who were referred to the radiology department in order to undergo CBCT scanning for implant treatment in the posterior maxilla. Linear measurements from the superior, anterior, and posterior joint spaces between the condyle and glenoid fossa were made through defined landmarks in the sagittal view. The inclination of articular eminence was also determined. RESULTS: The mean anterior joint space was 2.3 mm in the normal group and 2.8 mm in the TMD group, respectively. The results showed that there was a significant correlation between the superior and posterior joint spaces in both the normal and TMD groups, but it was only in the TMD group that the correlation coefficient among the dimensions of anterior and superior spaces was significant. There was a significant correlation between the inclination of articular eminence and the size of the superior and posterior spaces in the normal group. CONCLUSION: The average dimension of the anterior joint space was different between the two groups. CBCT could be considered a useful diagnostic imaging modality for TMD patients.

Clinical evaluation of fiber-reinforced composite crowns in pulp-treated primary molars: 12-month results.

OBJECTIVE: The aim of this study was to evaluate the clinical performance of tooth-colored fiber-reinforced composite (FRC) crowns in pulp-treated second primary mandibular teeth. MATERIALS AND METHODS: This split-mouth randomized, clinical trial performed on 67 children between 3 and 6 years with two primary mandibular second molars requiring pulp treatment. After pulp therapy, the teeth were randomly assigned to stainless steel crown (SSC) or FRC crown groups. Modified United States Public Health Service criteria were used to evaluate marginal integrity, marginal discoloration, and secondary caries in FRC crowns at intervals of 3, 6, and 12 months. Retention rate and gingival health were also compared between the two groups. The data were analyzed using Friedman, Cochran, and McNemar's tests at a significance level of 0.05. RESULTS: Intact marginal integrity in FRC crowns at 3, 6, and 12 months were 93.2%, 94.8%, and 94.2%, respectively. Marginal discoloration and secondary caries were not found at any of the FRC crowns. The retention rates of the FRC crowns were 100%, 98.3%, and 89.7% at 3, 6 and 12 months, respectively, whereas all the SSCs were found to be present and intact after 12 months (P = 0.016). There was no statistically significant difference between the two groups in gingival health. CONCLUSION: According to the results of this study, it seems that when esthetics is a concern, in cooperative patients with good oral hygiene, FRC crowns can be considered as a valuable procedure.

Periodontal changes following molar intrusion with miniscrews.

BACKGROUND: With the introduction of skeletal anchorage system, recently it is possible to successfully intrude molar teeth. On the other hand, there have been concerns about periodontal changes associated with intrusion and there are few studies on this topic, especially for posterior teeth. MATERIALS AND METHODS: Ten female patients were enrolled in this study. Maxillary molar intrusion was achieved by inserting two miniscrews and a 17 × 25 titanium molybdenum alloy spring. Crestal height changes were evaluated at three intervals including: Baseline (T0), end of active treatment (T1) and 6 months after retention (T2). Other variables including probing depth, gingival recession, attachment level and bleeding on probing were evaluated by clinical measurements in the three above mentioned intervals. One-sample Kolmogrov-Smirnov test ascertained the normality of the data. For all patients, the changes in tooth position and crestal height were evaluated using one-sample t-test. (P < 0.05). RESULTS: Supra-erupted molars were successfully intruded a mean of 2.1 ± 0.9 mm during active treatment (T0-T1). A mean bone resorption of 0.9 ± 0.9 mm in mesial crest and 1 ± 0.8 mm in distal crest had occurred in total treatment (T0-T2). A mean of 0.6 ± 1.4 mm bone was deposited on mesial crest during the retention period (T1-T2) following tooth relapse. On average, 0.8 ± 0.4 mm attachment gain was obtained. Gingival margin coronalized a mean of 0.8 ± 0.6 mm throughout the entire treatment. Probing depth showed no significant change during treatment. CONCLUSION: Within the limitations of this study, these results suggest that not only periodontal status was not negatively affected by intrusion, but also there were signs of periodontal improvement including attachment gain and shortening of clinical crown height.

Ultrasonographic findings of masseter muscle in females with temporomandibular disorders.

OBJECTIVES: The aim of this study was to evaluate of ultrasonographic findings of masseter muscle in females with temporomandibular disorders. Sonographic features were compared in those with myofacial pain disorder (MPD) and temporomandibular click, as well as healthy women. METHODS: Sixty-three females referred to the Prosthetic Department of Dental Faculty of Mashhad University of Medical Sciences (22 with MPD, 21 with click, and 20 control subjects) aged from 20 to 40 years were evaluated. The masseter muscle thickness in each group was measured bilaterally at rest and maximum contraction by a real-time ultrasound imaging technique. The type of the internal pattern of the masseter muscle in sonography was classified to 3 types (I, II, and III) according to the visibility, widths, and echogenicity of internal echogenic bands. RESULTS: In the right-side masseter, thickness in the control group was greater than that in the MPD group (P = 0.033). There was no significant difference about the thickness of the masseter at rest and at maximum contraction between both sides in control and MPD groups; however, in the click group, the difference was significant. Also, the muscle thickness of either right or left side at rest and at maximum contraction was significant. There was a significant difference between control and MPD groups (P < 0.001) as well as MPD and click groups (P < 0.001) in the type of the internal pattern. CONCLUSIONS: There were obvious ultrasonographic changes of the masseter muscle in females with MPD, which might be related to the muscle inflammation.

The efficacy of gabapentin versus stabilization splint in management of sleep bruxism.

PURPOSE: This study aimed to determine if the use of gabapentin is more efficacious than a stabilization splint with regard to the intensity of masseter muscle contractions and/or sleep quality for patients experiencing sleep bruxism (SB). MATERIALS AND METHODS: Twenty patients with SB participated in this clinical study. They were randomly divided into two treatment groups: stabilization splint group (n = 10) and gabapentin group (n = 10). The first polysomnographic examination was performed before the beginning of the experiment for all the participants. At the end of a 2-month period of stabilization splint therapy or gabapentin usage, a second polysomnographic recording was made. RESULTS: Statistically significant reductions in the number of SB episodes per hour and per night, bruxism time index, total duration of SB episodes per night and number of SB episodes in stages NR I and NR II (p < 0.05) were observed in both groups after treatment. Both treatments significantly reduced the mean intensity of masseter muscle contractions during SB episodes. Moreover, the participants treated with gabapentin showed a significant improvement in total sleep time, slow wave sleep (stage III), and sleep efficiency (p < 0.05). CONCLUSIONS: Gabapentin could be an effective treatment modality in SBs, especially in those with poor sleep quality.

Evaluation of the relationship between vertical facial height and the morphology of the temporomandibular joint in skeletal class 3 patients.

Class 3 patients may have relatively high prevalences of temporomandibular disorders; therefore, joint morphology can be important for their orthodontic-surgical treatments. The aim of this study was to evaluate the relationship between facial height and TMJ morphology in skeletal class 3 patients.

Intrusion of supra-erupted molars using miniscrews: clinical success and root resorption.

INTRODUCTION: Conventional orthodontic techniques do not intrude posterior teeth effectively, and almost all methods result in anterior extrusion rather than posterior intrusion. New absolute anchorages (miniscrews and miniplates) are said to make posterior tooth intrusion possible. The aim of this study was to evaluate the clinical success of a new method for molar intrusion with miniscrews and its probable accompanying side effects. MATERIAL AND METHODS: Ten women with overerupted upper first molars participated in this study. Upper molar bands with brackets were cemented. Two miniscrews were placed, 1 in the mesiopalatal and another in the mesiobuccal aspect of the upper first molars; a spring made of 0.017 × 0.25-in titanium-molybdenum alloy (TMA) wire was used to apply 100 g of force through the attachments (50 g each side). Molar intrusion and external apical root resorption were evaluated by comparing parallel periapical radiographs with bite blocks at 3 intervals: beginning of treatment (T0), at the end of active treatment (T1), and 6 months after treatment completion (T2). RESULTS: The mean value of intrusion was 2.1 mm after completion of active treatment. On average, 0.4 ± 0.2 mm relapse had occurred during 6 months of retention, and the mean residual intrusion was 1.7 mm, which was statistically significant. Mean root resorption of 0.3 ± 0.2 mm for palatal root and 0.4 mm for mesiobuccal and distobuccal root was measured. CONCLUSIONS: Statistically significant intrusion (2.1 ± 0.9 mm) was obtained during active treatment. The mean value of relapse was 0.4 ± 0.2 mm, and the mean value for residual intrusion was 1.7 ± 0.6 mm. Minor apical root resorption occurred during treatment.

Occlusal rehabilitation in a partially edentulous patient with lost vertical dimension using dental implants: a clinical report.

AIM: This clinical report describes the occlusal rehabilitation of a partially edentulous patient with lost vertical dimension. BACKGROUND: The patient did not want a removable partial denture. Implants, fixed restorations with occlusal plane correction, were used to restore the anterior and posterior support and treat the severely worn dentition. However, a partially edentulous patient may be unable to recover normal function, esthetics, comfort, or phonetics with a conventional removable dental prosthesis. The use of dental implants-supported fixed prosthesis offers a multitude of benefits over a tooth-soft tissue supported removable partial denture prosthesis. SUMMARY: This clinical report describes an organized approach to an occlusal reconstruction of a severely worn dentition, partially edentulous patient with fixed restorations, implants, occlusal plane correction, and recovery of the vertical dimension. The treatment offered the patient improved esthetics and the restoration of oral function. CLINICAL SIGNIFICANCE: The main indications for implant-supported restorations in a partially edentulous patient are the elimination of the free-end distal extension and the benefit from fixed restorations. Success with implant-supported prosthodontics needs the same or more attention to detail and careful treatment planning for conventional fixed prosthodontics; a team approach is recommended.

An evaluation of color stability of reinforced composite resin compared with dental porcelain in commonly consumed beverages.

The effect of tea, cola, orange juice, and distilled water on the color stability of a porcelain (VITA VMK 95) and a reinforced composite rein (GC Gradia) was evaluated. Standardized specimens for each material was prepared. Specimens from each group were immersed in staining solutions at 50 degree Celsius for 30 days. Tea caused the most significant color change. DeltaE of all of the materials was changed after the immersion in all of the staining solutions during the experimental process.