ABSTRACT
We investigate the mass transfer and membrane growth processes during capsule formation by the interaction of the biopolymer xanthan gum with CnTAB surfactants. When a drop of xanthan gum polymer solution is added to the surfactant solution, a membrane is formed by coacervation. It encapsulates the polymer drop in the surfactant solution. The underlying mechanisms and dynamic processes during capsule formation are not yet understood in detail. Therefore, we characterized the polymer-surfactant complex formation during coacervation by measuring the surface tension and surface elasticity at the solution-air interface for different surfactant chain lengths and concentrations. The adsorption behavior of the mixed polymer-surfactant system at the solution-air interface supports the understanding of observed trends during the capsule formation. We further measured the change in capsule pressure over time and simultaneously imaged the membrane growth via confocal microscopy. The cross-linking and shrinkage during the membrane formation by coacervation leads to an increasing tensile stress in the elastic membrane, resulting in a rapid pressure rise. Afterward, the pressure gradually decreases and the capsule shrinks as water diffuses out. This is not only due to the initial capsule overpressure but also due to osmosis caused by the higher ionic strength of the surfactant solution outside the capsule compared to the polymer solution inside the capsule. The influence of polymer concentration and surfactant type and concentration on the pressure changes and the membrane structure are studied in this work, providing detailed insights into the dynamic membrane formation process by coacervation. This knowledge can be used to produce capsules with tailored membrane properties and to develop a suitable encapsulation protocol in technological applications. The obtained insights into the mass transfer of water across the capsule membrane are important for future usage in separation techniques and the food industry and allow us to better predict the capsule time stability.
ABSTRACT
The self-assembly of nanoparticles (NPs) at interfaces is currently a topic of increasing interest due to numerous applications in food technology, pharmaceuticals, cosmetology, and oil recovery. It is possible to create tunable interfacial structures with desired characteristics using tailored nanoparticles that can be precisely controlled with respect to shape, size, and surface chemistry. To address these functionalities, it is essential to develop techniques to study the properties of the underlying structure. In this work, we propose an experimental approach utilizing the standard deviation of drop profiles calculated by the Laplace equation from experimental drop profiles (STD), as an alternative to the Langmuir trough or precise microscopic methods, to detect the initiation of closely packed conditions and the collapse of the adsorbed layers of CTAB-nanosilica complexes. The experiments consist of dynamic surface/interfacial tension measurements using drop profile analysis tensiometry (PAT) and large-amplitude drop surface area compression/expansion cycles. The results demonstrate significant changes in STD values at the onset of the closely packed state of nanoparticle-surfactant complexes and the monolayer collapse. The STD trend was explained in detail and shown to be a powerful tool for analyzing the adsorption and interfacial structuring of nanoparticles. Different collapse mechanisms were reported for NP monolayers at the liquid/liquid and air/liquid interfaces. We show that the interfacial tension (IFT) is solely dependent on the extent of interfacial coverage by nanoparticles, while the surfactants regulate only the hydrophobicity of the self-assembled complexes. Also, the irreversible adsorption of nanoparticles and the increasing number of adsorbed complexes after the collapse were observed by performing consecutive drop surface compression/expansion cycles. In addition to a qualitative characterization of adsorption layers, the potential of a quantitative calculation of the parameter STD such as the number of adsorbed nanoparticles at the interface and the distance between them at different states of the interfacial layer was discussed.