ABSTRACT
A series of novel renewable copolymers based on poly(ethylene succinate) (PESu) and poly(isosorbide succinate) (PISSu), with the Isosorbide (Is)/PESu molar ratio varying from 5/95 to 75/25, were synthesized in-situ and studied in this work. A sum of characterization techniques was employed here for the structural and thermo-dynamical characterization. The sophisticated technique of dielectric spectroscopy, along with proper analysis, enabled the molecular dynamics mapping of both the local and segmental types, which is presented for such materials for the first time. With increasing the Is fraction, shorter copolymeric entities were gradually formed. Based on the overall findings, the systems were found to be homogeneous, e.g., exhibiting single glass transitions, with the two polymer segments being found to be excellently distributed. The latter is indirect, although strong, evidence for the successful copolymerization. The thermal degradation mechanism for the copolymers was exhaustingly explored employing analytical pyrolysis. The systems exhibited, in general, good thermal stability, according to the thermogravimetric analysis. Confirming one of the initial scopes for the present systems, isosorbide plays here the role of hardener (PISSu) over the soft polymer (PESu), and this is reflected in the monotonic increase of the glass transition temperature, Tg, from -16 to ~56 °C. The introduction of Is results in an increase in constraints (hardening of the matrix), while there seems to be an overall densification of the polymer (decrease of the free volume).
ABSTRACT
The beneficial effects of lanthanide incorporation into 0.94Na0.5Bi0.5TiO3-0.06BaTiO3 (BNT-BT) matrix on its functional properties were investigated. The conventional solid-state method was used for synthesizing samples. The structural refinement revealed that all samples crystallized in R3c rhombohedral symmetry. Raman spectroscopy study was carried out using green laser excitation and revealed that no clear perceptible variation in frequency is observed. Dielectric measurements unveiled that the introduction of rare earth obstructed the depolarization temperature promoted in BNT-BT, the diffusive phase transition decreasing with increasing lanthanide size. Only dysprosium addition showed comparable diffusion constant and dielectric behavior as the unmodified composition. Further, the comparison of the obtained ferroelectric hysteresis and strain-electric field loops revealed that only Dy-phase exhibited interesting properties comparing parent composition. In addition, the incorporation of lanthanides Ln3+ into the BNT-BT matrix led to the development of luminescence characteristics in the visible and near infrared regions, depending on the excitation wavelengths. The simultaneous occurrence of photoluminescence and ferroelectric/piezoelectric properties opens up possibilities for BNT-BT-Ln to exhibit multifunctionality in a wide range of applications.
ABSTRACT
The aim of this study was to investigate the effect of side chain size on the optical and charge transport properties of thin films prepared from novel conjugated polysulfide-based polymers. Three polymers, labeled P1, P2, and P3, were derived from polysulfide derivatives and had different arylene groups (5,5'- biphenylene, 4,4'-biphenylene, and 2,6-pyridylene). Optical analysis was performed using photoluminescence (PL) and UV-visible absorption spectroscopy, revealing an energy band gap of 2.41-3.02 eV; P1 emitted yellow, P2 blue-green, and P3 green. Cyclic voltammetry measurements of the electrochemical band gap and HOMO and LUMO energy levels revealed that the polymer exhibited p-type semiconductor activity; the electrical properties of diodes based on the ITO/polysulfide derivative/Al structure were explored through analysis of current-voltage characteristics. The current space charge limitation (SCLC) mechanism was used to model the behavior of these diodes; the P2 thin film layer exhibited higher mobility than the other layers. The relationship between the geometry of the polymer thin films and their optical and electrical properties was thoroughly investigated.