ABSTRACT
The anomalous Nernst effect (ANE) is a thermomagnetic phenomenon with potential applications in thermal energy harvesting. While many recent works studied the approaches to increase the ANE coefficient of materials, relatively little effort was devoted to increasing the power supplied by the effect. Here, we demonstrate a nanofabricated device with record power density generated by the ANE. To accomplish this, we fabricate micrometer-sized devices in which the thermal gradient is 3 orders of magnitude higher than conventional macroscopic devices. In addition, we use Co/Pt multilayers, a system characterized by a high ANE thermopower (â¼1 µV/K), low electrical resistivity, and perpendicular magnetic anisotropy. These innovations allow us to obtain power densities of around 13 ± 2 W/cm3. We believe that this design may find uses in harvesting wasted energy, e.g., in electronic devices.
ABSTRACT
Cylindrical magnetic nanowires are promising materials that have the potential to be used in a wide range of applications. The versatility of these nanostructures is based on the tunability of their magnetic properties, which is achieved by appropriately selecting their composition and morphology. In addition, stochastic behavior has attracted attention in the development of neuromorphic devices relying on probabilistic magnetization switching. Here, we present a study of the magnetization reversal process in multisegmented CoNi/Cu nanowires. Nonstandard 2D magnetic maps, recorded under an in-plane magnetic field, produce datasets that correlate with magnetoresistance measurements and micromagnetic simulations. From this process, the contribution of the individual segments to the demagnetization process can be distinguished. The results show that the magnetization reversal in these nanowires does not occur through a single Barkhausen jump, but rather by multistep switching, as individual CoNi segments in the NW undergo a magnetization reversal. The existence of vortex states is confirmed by their footprint in the magnetoresistance and 2D MFM maps. In addition, the stochasticity of the magnetization reversal is analysed. On the one hand, we observe different switching fields among the segments due to a slight variation in geometrical parameters or magnetic anisotropy. On the other hand, the stochasticity is observed in a series of repetitions of the magnetization reversal processes for the same NW under the same conditions.
ABSTRACT
Bacteria are simple organisms with a remarkable capacity for survival by adapting to different environments, which is a result of their long evolutionary history. Taking into consideration these adapting mechanisms, this work now investigates the effect of electrically active microenvironments on bacteria and on how this stimulation may trigger bacteria growth inhibition or proliferation. Electrical microenvironments are generated via stimulation of a piezoelectric polymer with a mechanical cue, thus developing an electrical response and a variation on the surface charge of the polymeric material. Specifically, Gram-positive Staphylococcus epidermidis and Gram-negative Escherichia coli were grown overnight under static and dynamic conditions on piezoelectric poly(vinylidene) fluoride (PVDF) films to further study bacteria behavior under: (i) the effect of the material surface charge in static conditions, (ii) the mechanical effect, and (iii) the piezoelectric effect, the last two performed under dynamic conditions. Bacteria viability in planktonic and biofilm forms was measured, and the microorganism morphology was characterized. Whereas E. coli responds little to any of the stimuli application, S. epidermidis growth can be regulated through the material surface charge and by the applied frequency. Positively charged PVDF induces bacterial growth inhibition in planktonic and adhered cells in static conditions, whereas antifouling properties are obtained when a mechanical or piezoelectric effect at 4 Hz stimuli is applied. By increasing the stimuli to 40 Hz, however, the adhesion of bacteria is promoted. In conclusion, the behavior of certain bacteria species is tailored through the application of piezoelectric materials, which provide sufficient mechanoelectrical stimuli for growth or inhibition of bacteria, allowing for the design of suitable anti- and promicrobial strategies. Such strategies are only found in studies related to mammalian cells, whereas in bacterial cells this type of stimuli are still unknown. Thus, this work provides one of the first insights on the effect of piezoelectric stimuli on bacterial cells.
