ABSTRACT
Physicochemical and formulation factors influencing penetration of drugs from topical products into the skin and mechanisms of drug permeation are well investigated and reported in the literature. However, mechanisms of drug absorption during short-term exposure have not been given sufficient importance. In this project, the extent of absorption of drug molecules into the skin from aqueous and ethanolic solutions following a 5-min application period was investigated. The experiments demonstrated measurable magnitude of absorption into the skin for all the molecules tested despite the duration of exposure being only few minutes. Among the two solvents used, absorption was greater from aqueous than ethanolic solution. The results suggest that an alternative penetration pathway, herein referred to as the convective transport pathway, is likely responsible for the rapid, significant uptake of drug molecules during initial few minutes of exposure. Additionally, absorption through the convective transport pathways is a function of the physicochemical nature of the formulation vehicle rather than the API.
Subject(s)
Skin Absorption , Skin , Administration, Cutaneous , Biological Transport , Ethanol , Excipients/metabolism , Skin/metabolism , Solvents/chemistryABSTRACT
Cefuroxime Axetil (CA) is a poorly soluble, broad spectrum antibiotic which undergoes enzymatic degradation in gastrointestinal tract. The objective of the present study was to develop lipid-based gastro-retentive floating drug delivery systems containing CA using hot-melt extrusion (HME) to improve absorption. Selected formulations of CA and lipids were extruded using a twin screw hot-melt extruder. Milled extrudates were characterized for dissolution, floating strength, and micromeritic properties. Solid-state characterization was performed using differential scanning calorimetry (DSC), scanning electron microscopy (SEM), Fourier transform infrared (FTIR) spectroscopy, and hot-stage microscopy. In vitro characterization demonstrated that the formulations exhibited a sustained drug release profile for 12â¯h. All formulations showed desired floating and flow properties. Solid-state characterization revealed no phase separation and no chemical interactions between the drug and excipients. Based on in vitro study results, an optimized formulation (F8) was further evaluated for in vivo performance. Oral bioavailability (Cmax and AUC0-24h) of F8 was significantly higher than that of pure CA. This study describes the use of lipid-based gastro-retentive floating drug delivery systems to achieve desired sustained release profile for more complete dissolution which could potentially reduce enzymatic degradation. This study also highlights the effectiveness of HME technology to improve dissolution and bioavailability.
Subject(s)
Anti-Bacterial Agents/administration & dosage , Cefuroxime/analogs & derivatives , Drug Delivery Systems , Administration, Oral , Animals , Anti-Bacterial Agents/blood , Anti-Bacterial Agents/chemistry , Anti-Bacterial Agents/pharmacokinetics , Biological Availability , Cefuroxime/administration & dosage , Cefuroxime/blood , Cefuroxime/chemistry , Cefuroxime/pharmacokinetics , Drug Compounding , Drug Liberation , Hot Melt Extrusion Technology , Male , Polyethylene Glycols/administration & dosage , Polyethylene Glycols/chemistry , Polyethylene Glycols/pharmacokinetics , Rats, Sprague-Dawley , Stomach/physiologyABSTRACT
The use of opioids for treating acute and chronic pain condition is a common clinical practice. When delivered systemically, the analgesic activity is mediated through the central pathway, which although effective, leads to various adverse effects such as dependence, abuse and respiratory depression. Fentanyl is an opioid analgesic that is available as injection and transdermal patch products for the management of acute and chronic pain. These products require stringent regulatory controls and label warnings on disposal due to the abuse potential associated. This research project evaluated the regional antinociceptive efficacy of fentanyl delivered from soluble microneedles. The microneedle patches were formulated with relatively less drug loading as compared to patches intended for systemic delivery and were tested for their antinociceptive activity in rats by measuring the paw withdrawal latency when exposed to a thermal stimulus. The results indicate that regional delivery of fentanyl mediated through soluble microneedles provides an effective antinociceptive activity. The onset of analgesic activity was faster with microneedle patch (0.5â¯h) when compared to the adhesive dermal patch (6â¯h). This study thus demonstrates the effectiveness of microneedle mediated pain management for immediate pain relief.
Subject(s)
Analgesics, Opioid/administration & dosage , Fentanyl/administration & dosage , Microinjections , Needles , Pain/drug therapy , Transdermal Patch , Analgesics, Opioid/chemistry , Animals , Drug Liberation , Fentanyl/chemistry , Male , Rats, Sprague-Dawley , Skin/metabolismABSTRACT
The prevalence of iron deficiency anemia (IDA) is predominant in women and children especially in developing countries. The disorder affects cognitive functions and physical activity. Although oral iron supplementation and parenteral therapy remains the preferred choice of treatment, gastric side effects and risk of iron overload decreases adherence to therapy. Transdermal route is an established approach, which circumvents the side effects associated with conventional therapy. In this project, an attempt was made to investigate the use of rapidly dissolving microneedles loaded with ferric pyrophosphate (FPP) as a potential therapeutic approach for management of IDA. Microneedle array patches were made using the micromolding technique and tested in vitro using rat skin to check the duration required for dissolution/disappearance of needles. The ability of FPP-loaded microneedles to replenish iron was investigated in anemic rats. Rats were fed iron-deficient diet for 5 weeks to induce IDA following which microneedle treatment was initiated. Recovery of rats from anemic state was monitored by measuring hematological and biochemical parameters. Results from in vivo study displayed significant improvements in hemoglobin and serum iron levels after 2-week treatment with FPP-loaded microneedles. The study effectively demonstrated the potential of microneedle-mediated iron replenishment for treatment of IDA.
Subject(s)
Anemia, Iron-Deficiency/drug therapy , Diphosphates/administration & dosage , Diphosphates/therapeutic use , Drug Delivery Systems/instrumentation , Iron/administration & dosage , Iron/therapeutic use , Transdermal Patch , Administration, Cutaneous , Animals , Diphosphates/pharmacokinetics , Humans , Iron/pharmacokinetics , Male , Needles , Rats , Rats, Sprague-Dawley , Skin Absorption , SolubilityABSTRACT
The main objective of this novel study was to develop chlorpheniramine maleate orally disintegrating films (ODF) using hot-melt extrusion technology and evaluate the characteristics of the formulation using in vitro and in vivo methods. Modified starch with glycerol was used as a polymer matrix for melt extrusion. Sweetening and saliva-simulating agents were incorporated to improve palatability and lower the disintegration time of film formulations. A standard screw configuration was applied, and the last zone of the barrel was opened to discharge water vapors, which helped to manufacture non-sticky, clear, and uniform films. The film formulations demonstrated rapid disintegration times (6-11s) and more than 95% dissolution in 5min. In addition, the films had characteristic mechanical properties that were helpful in handling and storage. An animal model was employed to determine the taste masking of melt-extruded films. The lead film formulation was subjected to a human panel for evaluation of extent of taste masking and disintegration.
Subject(s)
Anti-Allergic Agents/administration & dosage , Chlorpheniramine/administration & dosage , Drug Carriers/administration & dosage , Hot Temperature , Technology, Pharmaceutical/methods , Administration, Oral , Adolescent , Adult , Animals , Anti-Allergic Agents/chemical synthesis , Anti-Allergic Agents/metabolism , Chlorpheniramine/chemical synthesis , Chlorpheniramine/metabolism , Drug Carriers/chemical synthesis , Drug Carriers/metabolism , Drug Evaluation, Preclinical/methods , Female , Humans , Male , Rats , Rats, Sprague-Dawley , Solubility , Taste Perception/drug effects , Taste Perception/physiology , X-Ray Diffraction/methods , Young AdultABSTRACT
Ointments are generally prepared either by fusion or by levigation methods. The current study proposes the use of hot-melt extrusion (HME) processing for the preparation of a polyethylene glycol base ointment. Lidocaine was used as a model drug. A modified screw design was used in this process, and parameters such as feeding rate, barrel temperature, and screw speed were optimized to obtain a uniform product. The product characteristics were compared with an ointment of similar composition prepared by conventional fusion method. The rheological properties, drug release profile, and texture characteristics of the hot-melt extruded product were similar to the conventionally prepared product. This study demonstrates a novel application of the hot-melt extrusion process in the manufacturing of topical semi-solids.
Subject(s)
Chemistry, Pharmaceutical/methods , Drug Compounding/methods , Ointments/chemistry , Drug Carriers/chemistry , Drug Liberation , Hot Temperature , RheologyABSTRACT
A novel redox-responsive amphiphilic polymer was synthesized with bioreductive trimethyl-locked quinone propionic acid for a potential triggered drug delivery application. The aim of this study was to synthesize and characterize the redox-responsive amphiphilic block copolymer micelles containing pendant bioreductive quinone propionic acid (QPA) switches. The redox-responsive hydrophobic block (polyQPA), synthesized from QPA-serinol and adipoyl chloride, was end-capped with methoxy poly(ethylene glycol) of molecular weight 750 (mPEG750) to achieve a redox-responsive amphiphilic block copolymer, polyQPA-mPEG750. PolyQPA-mPEG750 was able to self-assemble as micelles to show a critical micelle concentration (CMC) of 0.039% w/v (0.39 mg/ml, 0.107 mM) determined by a dye solubilization method using 1,6-diphenyl-1,3,5-hexatriene (DPH) in phosphate-buffered saline (PBS). The mean diameter of polymeric micelles was found to be 27.50 nm (PI = 0.064) by dynamic light scattering. Furthermore, redox-triggered destabilization of the polymeric micelles was confirmed by (1)H-NMR spectroscopy and particle size measurements in a simulated redox state. PolyQPA-mPEG750 underwent triggered reduction to shed pendant redox-responsive QPA groups and its polymeric micelles were swollen to be dissembled in the presence of a reducing agent, thereby enabling the release of loaded model drug, paclitaxel. The redox-responsive polyQPA-mPEG750 polymer micelles would be useful as a drug delivery system allowing triggered drug release in an altered redox state such as tumor microenvironments with an altered redox potential and/or redox enzyme upregulation.
Subject(s)
Drug Delivery Systems/methods , Micelles , Polymers/chemical synthesis , Surface-Active Agents/chemical synthesis , Benzoquinones/administration & dosage , Benzoquinones/chemical synthesis , Benzoquinones/metabolism , Cell Line, Tumor , Humans , Oxidation-Reduction , Polyethylene Glycols/administration & dosage , Polyethylene Glycols/chemical synthesis , Polyethylene Glycols/metabolism , Polymers/administration & dosage , Polymers/metabolism , Propionates/administration & dosage , Propionates/chemical synthesis , Propionates/metabolism , Surface-Active Agents/administration & dosage , Surface-Active Agents/metabolismABSTRACT
The use of chemical penetration enhancers (CPEs) is one of the most common approaches to improve the dermal and transdermal delivery of drugs. However, often, incorporation of CPEs in the formulation poses compatibility and stability challenges. Moreover, incorporation of enhancers in the formulation leads to prolonged exposure to skin increasing the concern of causing skin reactions. This study was undertaken to assess whether pretreatment with CPEs is a rational approach to enhance the permeation of diclofenac sodium. In vitro experiments were performed across porcine epidermis pretreated with propylene glycol or oleic acid or their combinations for 0.5, 2, and 4 h, respectively. Pretreatment with combination of oleic acid in propylene glycol was found to enhance the permeation of diclofenac sodium significantly only at 10% and 20% (v/v) level, and only when the pretreatment duration was 0.5 h. Longer durations of pretreatment and higher concentration of oleic acid in propylene glycol did not enhance the permeation of diclofenac sodium. In vivo dermatokinetic studies were carried out on Sprague-Dawley rats. A twofold increase in AUC and Cmax was observed in case of rats pretreated with enhancers over the group that was pretreated with buffer. In conclusion, this study showed that composition of the enhancers and duration of pretreatment are crucial in determining the efficacy of CPEs.