Spray drying Eudragit® E-PO with acetaminophen using 2- and 3-fluid nozzles for taste masking.

Conventional spray drying using a 2-fluid nozzle forms matrix microparticles, where drug is distributed throughout the particle and may not effectively mask taste. In contrast, spray drying using a 3-fluid nozzle has been reported to encapsulate material. The objective of this study was to spray dry Eudragit® E-PO (EE) with acetaminophen (APAP), a water-soluble model drug with a bitter taste, using 2- and 3-fluid nozzles for taste masking. Spray drying EE with APAP, however, resulted in yields of ≤ 13 %, irrespective of nozzle configuration. Yields improved when Eudragit® L 100-55 (EL) or Methocel® E6 (HPMC) was used in the inner fluid stream of the 3-fluid nozzle or in place of EE for the 2-fluid nozzle. Drug release from microparticles prepared with the 2-fluid nozzle was relatively rapid. Using EE in the outer fluid stream of the 3-fluid nozzle resulted in comparatively slower drug release, although drug release was observed, indicating that encapsulation was incomplete. Results from these studies also show that miscible polymers used in the two fluid streams mix during the spray drying process. In addition, findings from this study indicate that the polymer used in the inner fluid stream can impact drug release.

Pulmonary delivery of spray-dried Nisin ZP antimicrobial peptide for non-small cell lung cancer (NSCLC) treatment.

Nisin ZP is an antimicrobial peptide (AMP) produced by the bacterium Lactococcus lactis, and we have previously demonstrated anticancer activity in NSCLC (A549) cells. In this study, we formulated a nisin ZP dry powder (NZSD) using a spray dryer to facilitate inhaled delivery for the treatment of NSCLC. Nisin ZP was spray-dried with mannitol, l-leucine, and trehalose in a ratio of 75:15:10 using Büchi mini spray-dryer B-290 in different drug loadings (10, 20, and 30% w/w). NZSD powder revealed a good powder yield of >55% w/w with ≤3 % w/w moisture content and high nisin ZP drug loading for all the peptide ratios. The NZSD powder particles were irregularly shaped with corrugated morphology. The presence of an endothermic peak in DSC thermograms and attenuated crystalline peaks in PXRD diffractograms confirmed the semi-crystalline powder nature of NZSD. The anticancer activity of nisin ZP was maintained after fabricating it into NZSD powder and showed a similar inhibitory concentration to free nisin ZP. Stability studies indicated that NZSD powders were stable for three months at 4 and 25 ℃ with more than 90% drug content and semi-crystalline nature, as confirmed by DSC and PXRD. Aerosolization studies performed using NGI indicated an aerodynamic diameter (MMAD) within the desired range (1-5 µm) and a high fine particle fraction (FPF > 75%) for all peptide ratios, suggesting powder deposition in the lung's respiratory airways. In conclusion, a dry powder of nisin ZP was formulated using a spray dryer with enhanced storage stability and suitable for inhaled delivery.

Clinical Utility of Cytology from Preoperative Percutaneous Fine Needle Aspirates of Solitary Liver Masses in 220 Dogs: A Retrospective Study (2009-2019).

When a solitary liver mass is identified in a dog, a fine-needle aspirate (FNA) is commonly employed to attempt to obtain a diagnosis. Little information is provided in the literature evaluating the sensitivity/specificity of FNA cytology for solitary liver masses. We hypothesized that liver lesion size nor the presence of cavitation would impact the success of cytological diagnosis. Medical records were obtained for 220 client-owned dogs. Inclusion criteria included preoperative abdominal imaging, percutaneous FNA of a solitary hepatic mass with cytologic interpretation by a board-certified pathologist, and a surgical biopsy or mass excision yielding a histopathological diagnosis. Six dogs (2.7%) experienced a complication after FNA, none considered severe. The agreement rate for correct cytologic diagnosis was 22.9% (49/220). Of the neoplastic masses 18.9% (35/185) were correctly diagnosed via cytology. The overall sensitivity was 60%, and the specificity was 68.6%. Neither institution (P = 0.16), lesion size (P = 0.88), cavitation (P = 0.34), or needle gauge (P = 0.20) had an association with correct diagnosis. This study demonstrates that, although there is a low risk of complications following FNA of a hepatic mass, overall success rate for correct cytologic diagnosis based on FNA was low compared to histopathologic diagnosis.

Evaluation of depth gauge accuracy in a canine tibial plateau leveling osteotomy model.

OBJECTIVE: To evaluate the accuracy of six depth gauges used in three tibial plateau leveling osteotomy (TPLO) plate holes. STUDY DESIGN: Ex vivo experimental study. ANIMALS AND SAMPLE POPULATION: Cadaveric canine limbs (n = 10), one 25-mm-thick wood board, and one 33.8-mm-diameter polyvinyl chloride (PVC) pipe. METHODS: A TPLO was performed on 10 canine cadaveric pelvic limbs. Three 3.5-mm plate holes were filled with screws. The remaining three plate holes: a compression hole, a combination compression-locking hole, and a stacked combination compression-locking hole were measured by three observers using six commercial depth gauges and using a micrometer as gold standard. The process was repeated on one wood board and one PVC pipe. RESULTS: Bone measurements collected using two depth gauges with base diameter < 5 mm were smaller than measurements collected using the four depth gauges with base diameter > 5.5 mm (p ranging from < .001 to .038). Mean depth gauge measurements were smaller than micrometer measurements by 2.20 mm for the compression hole, 0.82 mm for the combination hole, and 3.57 mm for the stacked combination hole. Measurement differences among depth gauges were also present for wood board and PVC pipe measurements. Bone measurement variability between depth gauges was less for the combination and compression holes than for the stacked combination hole. CONCLUSION: Depth gauges lacked accuracy. Measurements differed among gauges and measurement variability varied based on plate hole geometry. CLINICAL RELEVANCE: Depth gauge measurement accuracy varies based on measuring devices and on 3.5-mm plate hole geometry.