Chronicles of plutonium peroxides: spectroscopic characterization of a new peroxo compound of Pu(IV).

Although hydrogen peroxide (H2O2) has been highly used in nuclear chemistry for more than 75 years, the preparation and literature description of tetravalent actinide peroxides remain surprisingly scarce. A new insight is given in this topic through the synthesis and thorough structural characterization of a new peroxo compound of Pu(IV).

Incorporation of U(IV) in monazite-cheralite ceramics under oxidizing and inert atmospheres.

This work is the first attempt to prepare Nd1-xCaxUxPO4 monazite-cheralite with 0 < x ≤ 0.1 by a wet chemistry method. This method relies on the precipitation under hydrothermal conditions (T = 110 °C for four days) of the Nd1-xCaxUxPO4·nH2O rhabdophane precursor, followed by its thermal conversion for 6 h at 1100 °C in air or Ar atmosphere. The optimized synthesis protocol led to the incorporation of U and Ca in the rhabdophane structure. After heating at 1100 °C for 6 h in air, single-phase monazite-cheralite samples were obtained. However, α-UP2O7 was identified as a secondary minor phase in the samples heated under Ar atmosphere. The U speciation in the samples converted in an oxidising atmosphere was carefully characterized using synchrotron radiation by combining HERFD-XANES and XRD. These results showed the presence of a minor secondary phase containing hexavalent uranium and phosphate with a stoichiometry of U : P = 0.78. This highly labile uranyl phosphate phase incorporated 21 mol% of the uranium initially precipitated with the rhabdophane precursor. This phase was completely removed by a washing protocol. Thus, single-phase monazite-cheralite was obtained through the wet chemistry route described in this work with a maximum U loading of x = 0.08.

Interaction Between the Transferrin Protein and Plutonium (and Thorium), What's New?

Transferrin (Tf) is a glycoprotein that transports iron from the serum to the various organs. Several studies have highlighted that Tf can interact with metals other than Fe(III), including actinides that are chemical and radiological toxics. We propose here to report on the behavior of Th(IV) and Pu(IV) in comparison with Fe(III) upon Tf complexation. We considered UV-Vis and IR data of the M2 Tf complex (M=Fe, Th, Pu) and combined experimental EXAFS data with MD models. EXAFS data of the first M-O coordination sphere are consistent with the MD model considering 1 synergistic carbonate. Further EXAFS data analysis strongly suggests that contamination by Th/Pu colloids seems to occur upon Tf complexation, but it seems limited. SAXS data have also been recorded for all complexes and also after the addition of Deferoxamine-B (DFOB) in the medium. The Rg values are very close for apoTf, ThTf and PuTf, but slightly larger than for holoTf. Data suggest that the structure of the protein is more ellipsoidal than spherical, with a flattened oblate form. From this data, the following order of conformation size might be considered:holoTf

How hydrothermal synthesis improves the synthesis of (Zr,Ce)SiO4 solid solutions.

Although ZrSiO4 is the most well-known compound in the zircon-structured family (space group I41/amd), the experimental conditions for preparing pure and well-crystallized phases that are doped with a tetravalent element via hydrothermal synthesis have never been clearly discussed in the literature. With the aim to answer this question, the experimental conditions of the preparation of ZrSiO4 and (Zr,Ce)SiO4 were investigated in order to synthesize well-crystallized and pure phases. A multiparametric study has been carried out using soft hydrothermal conditions with variables including reactant concentration, initial pH of the reactive medium, and duration of the hydrothermal treatment. Pure ZrSiO4 was obtained through hydrothermal treatment for 7 days at 250 °C, within a large acidity range (1.0 ≤ pH ≤ 9.0) and starting from CSi ≈ CZr ≥ 0.2 mol L-1. As hydrothermally prepared zircon structured phases can be both hydrated and hydroxylated, its annealed form was also studied after heating to 1000 °C. Based on these results, the synthesis of (Zr,Ce)SiO4 solid solutions was also investigated. The optimal hydrothermal conditions to acquire pure and crystallized phases were as follows: 7 days at 250 °C with initial pH = 1 and concentration of the reactants equal to 0.2 mol L-1. This led to Zr1-xCexSiO4 solid solutions with the incorporated Ce content up to 40 mol%. Samples were characterized using multiple methods, including laboratory and synchrotron PXRD, IR and Raman spectroscopies, SEM, and TGA. Moreover, it was found that these phases were thermally stable in air up to at least 1000 °C.

First observation of [Pu6(OH)4O4]12+ cluster during the hydrolytic formation of PuO2 nanoparticles using H/D kinetic isotope effect.

New insights are provided about the formation mechanism of PuO2 nanoparticles (NPs) by investigating an unprecedented kinetic isotope effect observed during their hydrolytic synthesis in H2O or D2O and attributed to OH/OD zero point energy difference. The signature of a Pu(IV) oxo-hydroxo hexanuclear cluster, appearing as an important intermediate during the formation of the 2 nm PuO2 NPs (synchrotron SAXS/XAS), is further revealed indicating that their formation is controlled by H-transfer reactions occurring during hydroxo to oxo-bridge conversions.

Size and structure of hexanuclear plutonium oxo-hydroxo clusters in aqueous solution from synchrotron analysis.

The size and shape of a water-soluble hexanuclear plutonium cluster were probed by combining synchrotron small-angle X-ray scattering (SAXS) and extended X-ray absorption fine structure (EXAFS). A specific setup coupling both techniques and dedicated to radioactive samples on the MARS beamline endstation at Synchrotron SOLEIL is described. The plutonium hexanuclear cores are well stabilized by the 1,4,7,10-tetraazacyclododecane-1,4,7,10-tetraacetic acid ligands and this allows a good evaluation of the setup to probe the very small plutonium core. The results show that, in spite of the constrained conditions required to avoid any risk of sample dispersion, the flux and the sample environment are optimized to obtain a very good signal-to-noise ratio, allowing the detection of small plutonium aggregates in an aqueous phase. The structure of the well defined hexanuclear cluster has been confirmed by EXAFS measurements in solution and correlated with SAXS data processing and modelling. An iterative comparison of classical fit models (Guinier or sphere form factor) with the experimental results allowed a better interpretation of the SAXS signal that will be relevant for future work under environmentally relevant conditions.

Local-Disorder-Induced Low Thermal Conductivity in Degenerate Semiconductor Cu22Sn10S32.

S-based semiconductors are attracting attention as environmentally friendly materials for energy-conversion applications because of their structural complexity and chemical flexibility. Here, we show that the delicate interplay between the chemical composition and cationic order/disorder allows one to stabilize a new sphalerite derivative phase of cubic symmetry in the Cu-Sn-S diagram: Cu22Sn10S32. Interestingly, its crystal structure is characterized by a semiordered cationic distribution, with the Cu-Sn disorder being localized on one crystallographic site in a long-range-ordered matrix. The origin of the partial disorder and its influence on the electronic and thermal transport properties are addressed in detail using a combination of synchrotron X-ray diffraction, Mössbauer spectroscopy, transmission electron microscopy, theoretical modeling, and transport property measurements. These measurements evidence that this compound behaves as a pseudogap, degenerate p-type material with very low lattice thermal conductivity (0.5 W m-1 K-1 at 700 K). We show that localized disorder is very effective in lowering κL without compromising the integrity of the conductive framework. Substituting pentavalent Sb for tetravalent Sn is exploited to lower the hole concentration and doubles the thermoelectric figure of merit ZT to 0.55 at 700 K with respect to the pristine compound. The discovery of this semiordered cubic sphalerite derivative Cu22Sn10S32 furthers the understanding of the structure-property relationships in the Cu-Sn-S system and more generally in ternary and quaternary Cu-based systems.

Analysis by laser-induced breakdown spectroscopy of complex solids, liquids, and powders with an echelle spectrometer.

One of the most promising approaches to laser-induced breakdown spectroscopy (LIBS) experiments involves the use of an echelle spectrometer coupled with an intensified CCD. Even if drawbacks remain with its use, the echelle spectrometer facilitates a multielemental analysis that is more rapid than can be obtained with the more-conventional Czerny-Turner spectrometer and, moreover, does not sacrifice reliability. Quantitative results obtained with such apparatus for solids, liquids, powders, and gases are described and when possible compared with results from Czerny-Turner spectrometers. Liquid analysis by LIBS with echelle spectrometers has allowed a spectral database to be compiled. Once the qualitative spectra of pure elements in aqueous solutions, are obtained, they can be used for qualitative analysis of unknown samples.

Micro-laser-induced breakdown spectroscopy technique: a powerful method for performing quantitative surface mapping on conductive and nonconductive samples.

Laser-induced breakdown spectroscopy (LIBS) has been applied mainly to bulk analysis of solids, liquids, and gases and less frequently for elemental microanalysis of solid surfaces. A micro-LIBS device devoted to analysis of the distribution of elements on surfaces is described. This device offers rapid access with a 3-microm spatial resolution to the microchemical structures of both conductive and nonconductive samples. Quantitative microchemical results of applications to ceramics are reported. By the use of a time-resolved acquisition spectrum, cerium in a uranium matrix was characterized with a cerium detection limit of 1.14%. Calibration curves obtained with manipulations during 1 year facilitated evaluations of reproducibility and repeatability. A 2% single-shot repeatability with a calibration reproducibility of approximately 7% is reported.