DNA Penetration into a Lysozyme Layer at the Surface of Aqueous Solutions.

The interactions of DNA with lysozyme in the surface layer were studied by performing infrared reflection-absorption spectroscopy (IRRAS), ellipsometry, surface tensiometry, surface dilational rheology, and atomic force microscopy (AFM). A concentrated DNA solution was injected into an aqueous subphase underneath a spread lysozyme layer. While the optical properties of the surface layer changed fast after DNA injection, the dynamic dilational surface elasticity almost did not change, thereby indicating no continuous network formation of DNA/lysozyme complexes, unlike the case of DNA interactions with a monolayer of a cationic synthetic polyelectrolyte. A relatively fast increase in optical signals after a DNA injection under a lysozyme layer indicates that DNA penetration is controlled by diffusion. At low surface pressures, the AFM images show the formation of long strands in the surface layer. Increased surface compression does not lead to the formation of a network of DNA/lysozyme aggregates as in the case of a mixed layer of DNA and synthetic polyelectrolytes, but to the appearance of some folds and ridges in the layer. The formation of more disordered aggregates is presumably a consequence of weaker interactions of lysozyme with duplex DNA and the stabilization, at the same time, of loops of unpaired nucleotides at high local lysozyme concentrations in the surface layer.

Spread Layers of Lysozyme Microgel at Liquid Surface.

The spread layers of lysozyme (LYS) microgel particles were studied by surface dilational rheology, infrared reflection-absorption spectra, Brewster angle microscopy, atomic force microscopy, and scanning electron microscopy. It is shown that the properties of LYS microgel layers differ significantly from those of ß-lactoglobulin (BLG) microgel layers. In the latter case, the spread protein layer is mainly a monolayer, and the interactions between particles lead to the increase in the dynamic surface elasticity by up to 140 mN/m. In contrast, the dynamic elasticity of the LYS microgel layer does not exceed the values for pure protein layers. The compression isotherms also do not exhibit specific features of the layer collapse that are characteristic for the layers of BLG aggregates. LYS aggregates form trough three-dimensional clusters directly during the spreading process, and protein spherulites do not spread further along the interface. As a result, the liquid surface contains large, almost empty regions and some patches of high local concentration of the microgel particles.

DNA Interaction with a Polyelectrolyte Monolayer at Solution-Air Interface.

The formation of ordered 2D nanostructures of double stranded DNA molecules at various interfaces attracts more and more focus in medical and engineering research, but the underlying intermolecular interactions still require elucidation. Recently, it has been revealed that mixtures of DNA with a series of hydrophobic cationic polyelectrolytes including poly(N,N-diallyl-N-hexyl-N-methylammonium) chloride (PDAHMAC) form a network of ribbonlike or threadlike aggregates at the solution-air interface. In the present work, we adopt a novel approach to confine the same polyelectrolyte at the solution-air interface by spreading it on a subphase with elevated ionic strength. A suite of techniques-rheology, microscopy, ellipsometry, and spectroscopy-are applied to gain insight into main steps of the adsorption layer formation, which results in non-monotonic kinetic dependencies of various surface properties. A long induction period of the kinetic dependencies after DNA is exposed to the surface film results only if the initial surface pressure corresponds to a quasiplateau region of the compression isotherm of a PDAHMAC monolayer. Despite the different aggregation mechanisms, the micromorphology of the mixed PDAHMAC/DNA does not depend noticeably on the initial surface pressure. The results provide new perspective on nanostructure formation involving nucleic acids building blocks.

Impact of denaturing agents on surface properties of myoglobin solutions.

The addition of denaturants strongly influences the surface properties of aqueous myoglobin solutions. The effect differs from the results for mixed solutions of the denaturants and other globular proteins, for example, bovine serum albumin (BSA), lysozyme and ß-lactoglobulin (BLG), although the surface properties of the solutions of the pure proteins are similar. The kinetic dependencies of the dynamic surface elasticity of myoglobin solutions with guanidine hydrochloride (GuHCl) reveal at least two adsorption steps at denaturant concentrations higher than 1 M: a very fast increase of the dynamic surface elasticity to approximately 30 mN/m at the beginning of adsorption, and a slower growth to abnormally high values of 250-300 mN/m. At the same time, the surface elasticity of BSA/GuHCl, BLG/GuHCl and lysozyme/GuHCl solutions is a non-monotonic function of the surface age, and does not exceed 50 mN/m close to equilibrium. The high surface elasticity of myoglobin/GuHCl solutions may be associated with protein aggregation in the surface layer. The formation of aggregates is confirmed by ellipsometry and Brewster angle microscopy. The addition of ionic surfactants to protein solutions leads to the formation of myoglobin/surfactant complexes, and the kinetic dependencies of the dynamic surface elasticity display local maxima indicating multistep adsorption kinetics, unlike the corresponding results for solutions of other globular proteins mixed with ionic surfactants. Ellipsometry and infrared reflection-absorption spectroscopy allow tracing the adsorption of the complexes and their displacement from the interface at high surfactant concentrations.

Phase Transitions in DNA/Surfactant Adsorption Layers.

The adsorption layers of complexes between DNA and oppositely charged surfactants dodecyltrimethylammonium bromide (DTAB) and cetyltrimethylammonium bromide (CTAB) at the solution/air interface were studied with surface tensiometry, dilational surface rheology, atomic force microscopy, Brewster angle microscopy, infrared absorption-reflection spectroscopy, and ellipsometry. Measurements of the kinetic dependencies of the surface properties gave a possibility to discover the time intervals corresponding to the coexistence of two-dimensional phases. One can assume that the observed phase transition is of the first order, unlike the formation of microaggregates in the adsorption layers of mixed solutions of synthetic polyelectrolytes and surfactants. The multitechniques approach together with the calculations of the adsorption kinetics allowed the elucidation of the structure of coexisting surface phases and the distinguishing of four main steps of adsorption layer formation at the surface of DNA/surfactant solutions.