Your browser doesn't support javascript.
loading
Show: 20 | 50 | 100
Results 1 - 8 de 8
Filter
Add more filters










Database
Language
Publication year range
1.
Phys Chem Chem Phys ; 21(29): 16252-16257, 2019 Jul 24.
Article in English | MEDLINE | ID: mdl-31304492

ABSTRACT

We present the results of an experimental study of methane sorption in ZIF-8. We measured isotherms at five different temperatures between 87 K and 107 K. We have observed three sub-steps in each of the isotherms. The intermediate sub-step had not been observed experimentally in previous studies of this system. This newly determined experimental feature suggests that a transition is taking place in the sorbed system (this newly observed sub-step occurs over a loading interval where published computer simulation results for CH4 in ZIF-8 had identified a structural transition occurring in the sorbent). We have studied the kinetics of adsorption for this system (we measure the time required for the system to reach equilibrium after gas is added to the experimental cell as a function of sorbent loading). We observed a sharp peak in the equilibration time at high loadings, below saturation. We have explored the isosteric heat of adsorption, and its dependence on sorbent loading, for this system. We found a broad peak in the isosteric heat at loadings corresponding to the intermediate isotherm sub-step. Previously reported computer simulations for the isosteric heat dependence on loading for CH4 in ZIF-8 are in good agreement with our experimental results for this quantity.

2.
Phys Chem Chem Phys ; 18(22): 15436-46, 2016 Jun 01.
Article in English | MEDLINE | ID: mdl-27218414

ABSTRACT

This is a report on a study of the adsorption characteristics of ethane on aggregates of unopened dahlia-like carbon nanohorns. This sorbent presents two main groups of adsorption sites: the outside surface of individual nanohorns and deep, interstitial spaces between neighbouring nanohorns towards the interior of the aggregates. We have explored the equilibrium properties of the adsorbed ethane films by determining the adsorption isotherms and isosteric heat of adsorption. Computer simulations performed on different model structures indicate that the majority of ethane adsorption occurs on the outer region of the aggregates, near the ends of the nanohorns. We have also measured the kinetics of adsorption of ethane on this sorbent. The measurements and simulations were conducted along several isotherms spanning the range between 120 K and 220 K.

3.
Molecules ; 21(4): 521, 2016 Apr 21.
Article in English | MEDLINE | ID: mdl-27110748

ABSTRACT

We present the results of a study of the kinetics of adsorption on aggregates of open carbon nanohorns using argon and CF4 sorbates. We measured the equilibration times for each value of the sorbent loading along eight adsorption isotherms (four isotherms for each sorbate species). We found that: the equilibration times decrease as the sorbent loading (and the equilibrium pressure of the coexisting gas) increases, for a given temperature; and, that, for a given value of the sorbent loading, the equilibration times decrease with increasing temperature. When considering the effect of scaling of the temperatures by the respective critical temperatures we found that, at the same scaled temperature and at comparable loadings, the equilibration times for CF4 were longer than those for argon. We discuss a possible explanation for this result.


Subject(s)
Argon/chemistry , Carbon/chemistry , Fluorocarbons/chemistry , Adsorption , Hydrogen-Ion Concentration , Kinetics , Models, Chemical , Temperature , Water Pollutants, Chemical
4.
Langmuir ; 29(30): 9388-97, 2013 Jul 30.
Article in English | MEDLINE | ID: mdl-23802764

ABSTRACT

We present the results of a thermodynamics and kinetics study of the adsorption of neon and carbon dioxide on aggregates of chemically opened carbon nanohorns. Both the equilibrium adsorption characteristics, as well as the dependence of the kinetic behavior on sorbent loading, are different for these two adsorbates. For neon the adsorption isotherms display two steps before reaching the saturated vapor pressure, corresponding to adsorption on strong and on weak binding sites; the isosteric heat of adsorption is a decreasing function of sorbent loading (this quantity varies by about a factor of 2 on the range of loadings studied), and the speed of the adsorption kinetics increases with increasing loading. By contrast, for carbon dioxide there are no substeps in the adsorption isotherms; the isosteric heat is a nonmonotonic function of loading, the value of the isosteric heat never differs from the bulk heat of sublimation by more than 15%, and the kinetic behavior is opposite to that of neon, with equilibration times increasing for higher sorbent loadings. We explain the difference in the equilibrium properties observed for neon and carbon dioxide in terms of differences in the relative strengths of adsorbate-adsorbate to adsorbate-sorbent interaction for these species.

5.
Langmuir ; 28(3): 1824-32, 2012 Jan 24.
Article in English | MEDLINE | ID: mdl-22168522

ABSTRACT

We present the results of Monte Carlo simulations of the adsorption of single-component ethane and ethylene and of equimolar mixtures of these two gases on bundles of closed, single-walled carbon nanotubes. Two types of nanotube bundles were used in the simulations: homogeneous (i.e., those in which all the nanotubes have identical diameters) and heterogeneous (those in which nanotubes of different diameters are allowed). We found that at the same pressure and temperature more ethane than ethylene adsorbs on the bundles over the entire range of pressures and temperatures explored. The simulation results for the equimolar mixtures show that the pressure at which maximum separation is attained is a very sensitive function of the diameter of the nanotubes present in the bundles. Simulations using heterogeneous bundles yield better agreement with single-component experimental data for isotherms and isosteric heats than those obtained from simulations using homogeneous bundles. Possible applications of nanotubes in gas separation are discussed. We explored the effect of the diameter of the nanotubes on the separation ability of these sorbents, both for the internal and for the external sites. We found that substrate selectivity is a decreasing function of temperature.

6.
J Phys Chem B ; 110(25): 12597-602, 2006 Jun 29.
Article in English | MEDLINE | ID: mdl-16800589

ABSTRACT

We present the combined results of a computer simulation and adsorption isotherm investigation of CF4 films on purified HiPco nanotubes. The experimental measurements found two substeps in the adsorption data. The specific surface area of the sample and the coverage dependence of the isosteric heat of adsorption of the films were determined from the measurements. The simulations, conducted for homogeneous bundles of close-ended tubes, also found two substeps in the first layer data: one corresponding to adsorption on the grooves and a second one, at higher pressures, corresponding to adsorption on the outside surface of the tubes. Our computer simulations are in very good agreement with the experimental data.

7.
Langmuir ; 22(1): 234-8, 2006 Jan 03.
Article in English | MEDLINE | ID: mdl-16378426

ABSTRACT

We have measured adsorption of xenon on purified HiPco single-walled carbon nanotubes (SWNTs) for coverages in the first layer. We compare the results on this substrate to those our group obtained in earlier measurements on lower purity arc-discharge produced nanotubes. To obtain an estimate for the binding energy of Xe, we measured five low-coverage isotherms for temperatures between 220 and 260 K. We determined a value of 256 meV for the binding energy; this value is 9% lower than the value we found for arc discharge nanotubes and is 1.59 times the value found for this quantity on planar graphite. We have measured five full monolayer isotherms between 150 and 175 K. We have used these data to obtain the coverage dependence of the isosteric heat. The experimental values obtained are compared with previously published computer simulation results for this quantity.

8.
J Phys Chem B ; 109(19): 9317-20, 2005 May 19.
Article in English | MEDLINE | ID: mdl-16852115

ABSTRACT

We have measured 21 adsorption isotherms for argon on single-walled carbon nanotubes produced by laser ablation. We explored temperatures between 40 and 153 K to obtain the coverage dependence of the isosteric heat of adsorption for films in the first and second layers. Our data are compared to results obtained in computer simulation studies and to data obtained in previous experimental investigations of this system.

SELECTION OF CITATIONS
SEARCH DETAIL