Low-fat and fat-free spindle cell lipomas in the oral cavity: Immunohistochemical analysis and review of the literature.

The low-fat and fat-free spindle cell lipomas (SCLs) are rare and often mistaken for other benign and malignant morphological mimics, because of the fact that the diagnosis relies on its non-lipogenic component analysis. Here, we report the clinicopathological features of two oral SCLs (low-fat and fat-free variants). Both lesions presented clinically as an asymptomatic nodule, which initially yielded diagnostic difficulties on the morphological analysis alone. One case was diagnosed as low-fat SCL on the lower lip in a 29-year-old man, and the other as fat-free SCL on the buccal mucosa in a 46-year-old man. In both cases, immunohistochemistry showed strong positivity for CD34 and, remarkably, retinoblastoma (Rb) protein was deficient. Mast cell (MC) tryptase and toluidine blue stain highlighted numerous MCs distributed throughout all tumor stroma. Alpha-SMA and desmin were negative. S100 evidenced scarce adipocytes only in the low-fat SCL case. Conservative surgical treatment was performed and no recurrence was noticed in about 2-year of follow-up in both cases. Because of the potential pitfalls, careful morphological analysis of the tumor stroma in the low-fat/fat-free SCL diagnosis, supported by immunohistochemistry (especially CD34, Rb and MC tryptase), is strongly recommended. To the best of our knowledge, these are the first and second cases reported of fat-free and low-fat SCL in the oral cavity.

Surface properties of Ti-35Nb-7Zr-5Ta: Effects of long-term immersion in artificial saliva and fluoride solution.

STATEMENT OF PROBLEM: The mechanical properties of new titanium alloys with an elastic modulus closest to cortical bone have been studied. However, potentially damaging conditions experienced in the oral cavity, such as fluoride ions, can initiate a localized or crevice process of corrosive degradation in the alloy surfaces. PURPOSE: The purpose of this in vitro study was to evaluate the effects of long-term immersion in artificial saliva or in fluoride solution on mean roughness (Ra), Vickers hardness, and topography of the new titanium alloy Ti-35Nb-7Zr-5Ta (TNZT) compared with those of cp Ti and Ti-6Al-4V (TAV). MATERIAL AND METHODS: Disks (N=210) were divided into cp Ti, TAV, and TNZT and subdivided according to the following treatments: no immersion (N(-), control), immersion in artificial saliva (S), and immersion in fluoride (F) during periods equivalent to 5, 10, 15, and 20 years. The Ra and Vickers hardness were measured with a profilometer and a hardness tester. The topography was analyzed by scanning electronic microscopy. Data were compared using the Kruskal-Wallis and Dunn tests (α=.05). RESULTS: Values of Ra and hardness were significantly different among the metals (Ra: TAV