Phototriggered Cytotoxicity of Ferrocene-Based Micelles - A Nonconventional Approach to Phototherapy.

We report the design, synthesis, and in vitro evaluation of stimuli-responsive nanoscale micelles that can be activated by light to induce a cytotoxic effect. Micelles were assembled from amphiphilic units made of a photoactivatable ferrocenyl linker, connected on one side to a lipophilic chain, and on the other side to a hydrophilic pegylated chain. In vitro experiments indicated that pristine micelles ("off" state) were nontoxic to MCF-7 cancer cells, even at high concentrations, but became potent upon photoactivation ("on" state). The illumination process led to the dissociation of the micelles and the concomitant release of iron species, triggering cytotoxicity.

Continuous Flow Photocatalytic Hydrogen Production from Water Synergistically Activated by TiO2, Gold Nanoparticles, and Carbon Nanotubes.

Titanium dioxide nanoparticles were combined with carbon nanotubes and gold to develop improved photocatalysts for the production of hydrogen from water. The entangled nature of the nanotubes allowed for the integration of the photoactive hybrid catalyst, as a packed-bed, in a microfluidic photoreactor, and the chips were studied in the photocatalyzed continuous flow production of hydrogen. The combination of titanium dioxide with carbon nanotubes and gold significantly improved hydrogen production due to a synergistic effect between the multi-component system and the stabilization of the active catalytic species. The titanium dioxide/carbon nanotubes/gold system permitted a 2.5-fold increase in hydrogen production, compared to that of titanium dioxide/carbon nanotubes, and a 20-fold increase, compared to that of titanium dioxide.

Safe-by-design strategies for lowering the genotoxicity and pulmonary inflammation of multiwalled carbon nanotubes: Reduction of length and the introduction of COOH groups.

Potentially, the toxicity of multiwalled carbon nanotubes (MWCNTs) can be reduced in a safe-by-design strategy. We investigated if genotoxicity and pulmonary inflammation of MWCNTs from the same batch were lowered by a) reducing length and b) introducing COOH-groups into the structure. Mice were administered: 1) long and pristine MWCNT (CNT-long) (3.9 µm); 2) short and pristine CNT (CNT-short) (1 µm); 3) CNT modified with high ratio COOH-groups (CNT-COOH-high); 4) CNT modified with low ratio COOH-groups (CNT-COOH-low). MWCNTs were dosed by intratracheal instillation at 18 or 54 µg/mouse (∼0.9 and 2.7 mg/kg bw). Neutrophils numbers were highest after CNT-long exposure, and both shortening the MWCNT and addition of COOH-groups lowered pulmonary inflammation (day 1 and 28). Likewise, CNT-long induced genotoxicity, which was absent with CNT-short and after introduction of COOH groups. In conclusion, genotoxicity and pulmonary inflammation of MWCNTs were lowered, but not eliminated, by shortening the fibres or introducing COOH-groups.

Coffinite formation from UO2+x.

Most of the highly radioactive spent nuclear fuel (SNF) around the world is destined for final disposal in deep-mined geological repositories. At the end of the fuel's useful life in a reactor, about 96% of the SNF is still UO2. Thus, the behaviour of UO2 in SNF must be understood and evaluated under the weathering conditions of geologic disposal, which extend to periods of hundreds of thousands of years. There is ample evidence from nature that many uranium deposits have experienced conditions for which the formation of coffinite, USiO4, has been favoured over uraninite, UO2+x, during subsequent alteration events. Thus, coffinite is an important alteration product of the UO2 in SNF. Here, we present the first evidence of the formation of coffinite on the surface of UO2 at the time scale of laboratory experiments in a solution saturated with respect to amorphous silica at pH = 9, room temperature and under anoxic conditions.

Carbon nanotube-copper ferrite-catalyzed aqueous 1,3-dipolar cycloaddition of in situ-generated organic azides with alkynes.

A novel nanohybrid catalyst was developed by assembling copper ferrite nanoparticles on carbon nanotubes. The supramolecular catalyst was applied to the one-pot azidation/1,3-dipolar cycloaddition of various substrates, at room temperature, and in an aqueous medium. The nanohybrid could also be recycled and reused by means of magnetic recovery.

Characterization of palladium species after γ-irradiation of a TBP-alkane-Pd(NO3)2 system.

The γ-irradiation of a biphasic system composed of tri-n-butylphosphate in tetrapropylene hydrogen (TPH) in contact with palladium(ii) nitrate in nitric acid aqueous solution led to the formation of two precipitates. A thorough characterization of these solids was performed by means of various analytical techniques including X-Ray Diffraction (XRD), Thermal Gravimetric Analysis coupled with a Differential Scanning Calorimeter (TGA-DSC), X-ray Photoelectron Spectroscopy (XPS), InfraRed (IR), RAMAN and Nuclear Magnetic Resonance (NMR) Spectroscopy, and ElectroSpray Ionization Mass Spectrometry (ESI-MS). Investigations showed that the two precipitates exhibit quite similar structures. They are composed at least of two compounds: palladium cyanide and palladium species containing ammonium, phosphorous or carbonyl groups. Several mechanisms are proposed to explain the formation of Pd(CN)2.

Engineering the magnetic coupling and anisotropy at the molecule-magnetic surface interface in molecular spintronic devices.

A challenge in molecular spintronics is to control the magnetic coupling between magnetic molecules and magnetic electrodes to build efficient devices. Here we show that the nature of the magnetic ion of anchored metal complexes highly impacts the exchange coupling of the molecules with magnetic substrates. Surface anchoring alters the magnetic anisotropy of the cobalt(II)-containing complex (Co(Pyipa)2), and results in blocking of its magnetization due to the presence of a magnetic hysteresis loop. In contrast, no hysteresis loop is observed in the isostructural nickel(II)-containing complex (Ni(Pyipa)2). Through XMCD experiments and theoretical calculations we find that Co(Pyipa)2 is strongly ferromagnetically coupled to the surface, while Ni(Pyipa)2 is either not coupled or weakly antiferromagnetically coupled to the substrate. These results highlight the importance of the synergistic effect that the electronic structure of a metal ion and the organic ligands has on the exchange interaction and anisotropy occurring at the molecule-electrode interface.

Molecular-scale dynamics of light-induced spin cross-over in a two-dimensional layer.

Spin cross-over molecules show the unique ability to switch between two spin states when submitted to external stimuli such as temperature, light or voltage. If controlled at the molecular scale, such switches would be of great interest for the development of genuine molecular devices in spintronics, sensing and for nanomechanics. Unfortunately, up to now, little is known on the behaviour of spin cross-over molecules organized in two dimensions and their ability to show cooperative transformation. Here we demonstrate that a combination of scanning tunnelling microscopy measurements and ab initio calculations allows discriminating unambiguously between both states by local vibrational spectroscopy. We also show that a single layer of spin cross-over molecules in contact with a metallic surface displays light-induced collective processes between two ordered mixed spin-state phases with two distinct timescale dynamics. These results open a way to molecular scale control of two-dimensional spin cross-over layers.

Cyanide-bridged NiCr and alternate NiFe-NiCr magnetic ultrathin films on functionalized Si(100) surface.

Sequential growth in solution (SGS) was performed for the magnetic cyanide-bridged network obtained from the reaction of Ni(H(2)O)(2+) and Cr(CN)(6)(3-) (referred to as NiCr) on a Si(100) wafer already functionalized by a Ni(II) complex. The growth process led to isolated dots and a low coverage of the surface. We used the NiFe network as a template to improve the growth of the magnetic network. We elaborated alternate NiFe (paramagnetic)-NiCr (ferromagnetic) ultrathin films around 6 nm thick. The magnetic behaviour confirmed the alternate structure with the ferromagnetic zones isolated between the paramagnetic ones since the evolution of the blocking temperature is consistent with the evolution of the layers' thickness expected from the SGS process.

Sequential growth in solution of NiFe Prussian blue coordination network nanolayers on Si(100) surfaces.

Controlling the elaboration of Coordination Networks (CoNet) on surfaces at the nanoscale remains a challenge. One suitable technique is the Sequential Growth in Solution (SGS), which has the advantage to be simple, cheap and fast. We addressed two issues in this article: i) the controlled synthesis of ultra thin films of CoNet (thickness lower than 10 nm), and ii) the investigation of the influence of the precursors' concentration on the growth process. Si(100) was used because it is possible to prepare atomically flat Si-H surfaces, which is necessary for the growth of ultrathin films. We used, as a model system, the sequential reactions of K(4)[Fe(II)(CN)(6)] and [Ni(II)(H(2)O)(6)]Cl(2) that occur by the substitution of the water molecules in the coordination sphere of Ni(II) by the nitrogen atoms of ferrocyanide. We demonstrated that the nature of the deposited film depends mainly on the relative concentration of the anchoring sites versus the precursors' solution. Attenuated Total Reflection Fourier Transformed Infra Red (ATR-FTIR), X-ray reflectivity, X-ray Photoelectron Spectroscopy (XPS) and Atomic Force Microscopy (AFM) were used to characterize the steps of the growth process.

Assembly of a magnetic polyoxometalate on SWNTs.

Recently, the organisation of magnetic molecules on carbon nanotubes has raised much interest due to their possible interesting contribution to molecular spintronics. In this paper, we describe the assembly on SWNTs of a magnetic polyoxometalate encompassing a single cobalt ion (CoPOM) and its isostructural diamagnetic zinc analogue (ZnPOM). The simple magnetic behaviour of CoPOM and the availability of its diamagnetic counterpart render these POM@NTs systems interesting model compounds for the study of molecular electronics devices based on carbon nanotubes and magnetic molecules. The success and rate of the grafting have been investigated by electron microscopy, electron energy loss spectroscopy, X-ray photoelectron spectroscopy, cyclic voltammetry, Raman scattering and magnetisation measurements. These characterisations altogether demonstrate the preservation of the structural and magnetic properties of the molecules upon functionalisation and the existence of an electronic communication between the molecules and the nanotubes.

Growth and density control of nanometric nickel-iron cyanide-bridged objects on functionalized Si(100) surface.

Isolated nanometric objects of the nickel-iron cyanide-bridged coordination network are obtained by a sequential growth on "molecular seeds" anchored on Si(100) surfaces. Control of the density and the size of the nano-objects is achieved by imposing a growth process without side nucleation.

Hexa- and dodecanuclear polyoxomolybdate cyclic compounds: application toward the facile synthesis of nanoparticles and film electrodeposition.

Two new compounds based on O(3)PCH(2)PO(3)(4-) ligands and {Mo(V)(2)O(4)} dimeric units have been synthesized and structurally characterized. The dodecanuclear Mo(V) polyoxomolybdate species in (NH(4))(18)[(Mo(V)(2)O(4))(6)(OH)(6)(O(3)PCH(2)PO(3))(6)] x 33 H(2)O (1) is a cyclohexane-like ring in a chair conformation with pseudo S(6) symmetry. In the solid state, the wheels align side by side, thus delimiting large rectangular voids. The hexanuclear anion in Na(8)[(Mo(V)(2)O(4))(3)(O(3)PCH(2)PO(3))(3)(CH(3)AsO(3))] x 19 H(2)O (2) has a triangular framework and encapsulates a methylarsenato ligand. (31)P NMR spectroscopic analysis revealed the stability of 2 in various aqueous media, whereas the stability of 1 depends on the nature of the cations present in solution. It has been evidenced that the transformation of 1 into 2 occurs in the presence of CH(3)AsO(3)(2-) ions. This behavior shows that 1 can be used as a new precursor for the synthesis of Mo(V)/diphosphonate systems. The two complexes were very efficient both as reductants of Pt and Pd metallic salts and as capping agents for the resulting Pt(0) and Pd(0) nanoparticles. The size of the obtained nanoparticles depends both on the nature of the polyoxometalate (POM; i.e., 1 or 2) and on the [metallic salt]/[POM] ratio. In all cases, X-ray photoelectron spectroscopy (XPS) measurements have revealed the presence of Mo(VI) species that stabilize the nanoparticles and the absence of Mo(V) moieties. Diffuse-reflectance FTIR spectra of the Pt nanoparticles show that the capping Mo(VI) POMs are identical for both systems and contain the diphosphonato ligand. The colloidal solutions do not show any precipitate and the nanoparticles remain well-dispersed for several months. The electrochemical reduction of Mo(V) species was studied for 2. Cyclic voltammetry alone and electrochemical quartz crystal microbalance coupled with cyclic voltammetry show the deposition of a film on the electrode surface during this reduction.

Grafting a monolayer of superparamagnetic cyanide-bridged coordination nanoparticles on Si(100).

The grafting of a monolayer of 6 nm superparamagnetic cyanide-bridged CsNiCr nanoparticles was achieved on a Ni(II)-functionalized Si(100) substrate; magnetic studies reveals that the grafted nanoparticles are nearly magnetically isolated within the monolayer.

Speciation of europium (III) surface species on monocrystalline alumina using time-resolved laser-induced fluorescence-scanning near-field optical microscopy.

The aim of this work was to perform highly localized spectroscopic surface measurements by combining time-resolved laser spectroscopy and scanning near-field optical microscopy. The final purpose of that was to study surface sorption at the molecular level of trivalent ions in the framework of nuclear waste disposal assessment. Time-resolved laser spectroscopy presents the advantages of being selective, sensitive, and noninvasive and scanning near-field optical microscopy is a promising technique for high resolution surface speciation. Investigation of the interaction between trivalent europium and a monocrystalline alumina (1102) surface was made using different conditions of concentration and pH. We found that the distribution of sorbed europium was always homogeneous with a decay time of europium (III) equal to 350 micros+/-15 micros. On the other hand, carbonate species with a decay time of 210 micros+/-10 micros or other hydroxide species with a decay time of 180 micros+/-10 micros were detected on the surface when a higher concentration or a higher pH solution, respectively, were used. Distribution of these species was heterogeneous and their associated fluorescence signal was relatively high, evoking a precipitated form. X-ray photoelectron spectroscopy (XPS) was also used on the same samples as a complementary technique. A binding energy of 1135.1 eV was obtained for the sorbed europium and another binding energy of 1134.4 eV was obtained for the hydroxide species, thus confirming the presence of two kinds of species on the surface.