Investigation of Ionization Chamber Characteristics for Ultrahigh-dose-rate Scanned Carbon-ion Beams.

BACKGROUND/AIM: There are only a few studies on dosimetry with ultrahigh-dose-rate (uHDR) scanned carbon-ion beams. This study investigated the characteristics of four types of ionization chambers for the uHDR beam. MATERIALS AND METHODS: We employed a newly developed large-plane parallel chamber to monitor a 208.3-MeV/u uHDR scanned carbon-ion beam with a 110-Gy/s average dose rate. The ionization chambers used were the Advanced Markus chamber (AMC), PinPoint 3D chamber (PPC), Farmer chamber (FC), and large-plane parallel chamber (StingRay). The AMC and StingRay surfaces and the PPC and FC geometric centers were aligned to the radiation isocenter using treatment room lasers. Using the voltage range stated in the instruction manuals, we obtained the saturation curves of the chambers. From these curves, we obtained the ion recombination correction factors using the two-voltage and three-voltage linear methods. The dose linearity was evaluated using five measurement points, and the chamber repeatability was verified by conducting repeated measurements for different dose values. RESULTS: Although all chambers, except for AMC, reached saturation when specified voltages were applied, they exhibited excellent linearity for different dose values. The ion recombination correction factors of the AMC obtained using the aforementioned linear methods were nearly 1. Additionally, all chambers exhibited excellent repeatability. Although the standard deviation of the PPC for the lowest dose was ~1.5%, those of all the other chambers were <1.0%. CONCLUSION: All ionization chambers can be used for measuring the relative dose, and absolute dose can be conveniently measured using the AMC with an uHDR carbon-ion scanned beam.

Development and characterization of a dedicated dose monitor for ultrahigh-dose-rate scanned carbon-ion beams.

The current monochromatic beam mode (i.e., uHDR irradiation mode) of the scanned carbon-ion beam lacks a dedicated dose monitor, making the beam control challenging. We developed and characterized a dedicated dose monitor for uHDR-scanned carbon-ion beams. Furthermore, a simple measurable dose rate (dose rate per spot (DRspot)) was suggested by using the developed dose monitor and experimentally validating quantities relevant to the uHDR scanned carbon-ion beam. A large plane-parallel ionization chamber (IC) with a smaller electrode spacing was used to reduce uHDR recombination effects, and a dedicated operational amplifier was manufactured for the uHDR-scanned carbon-ion beam. The dose linearity of the IC was within ± 1% in the range of 1.8-12.3 Gy. The spatial inhomogeneity of the dose response of the IC was ± 0.38% inside the ± 40-mm detector area, and a systematic deviation of approximately 2% was measured at the edge of the detector. uHDR irradiation with beam scanning was tested and verified for different doses at the corresponding dose rates (in terms of both the average dose rate and DRspot). We confirmed that the dose monitor can highlight the characteristics (i.e., dose, dose rate, and dose profile) of uHDR-scanned carbon-ion beams at several dose levels in the monochromatic beam mode.

Luminescence imaging of water irradiated by protons under FLASH radiation therapy conditions.

Objective.FLASH radiation therapy with ultrahigh dose rates (UHDR) has the potential to reduce damage to normal tissue while maintaining anti-tumor efficacy. However, rapid and precise dose distribution measurements remain difficult for FLASH radiation therapy with proton beams. To solve this problem, we performed luminescence imaging of water following irradiation by a UHDR proton beam captured using a charge-coupled device camera.Approach. We used 60 MeV proton beams with dose rates of 0.03-837 Gy s-1from a cyclotron. Therapeutic 139.3 MeV proton beams with dose rates of 0.45-4320 Gy s-1delivered by a synchrotron-based proton therapy system were also tested. The luminescent light intensity induced by the UHDR beams was compared with that produced by conventional beams to compare the dose rate dependency of the light intensity and its profile.Main results. Luminescence images of water were clearly visualized under UHDR conditions, with significantly shorter exposure times than those with conventional beams. The light intensity was linearly proportional to the delivered dose, which is similar to that of conventional beams. No significant dose-rate dependency was observed for 0.03-837 Gy s-1. The light-intensity profiles of the UHDR beams agreed with those of conventional beams. The results did not differ between accelerators (synchrotron or cyclotron) and beam energies.Significance. Luminescence imaging of water is achievable with UHDR proton beams as well as with conventional beams. The proposed method should be suitable for rapid and easy quality assurance investigations for proton FLASH therapy, because it facilitates real-time, filmless measurements of dose distributions, and is useful for rapid feedback.