Facile synthesis of TiO2@ZnO nanoparticles for enhanced removal of methyl orange and indigo carmine dyes: Adsorption, kinetics.

Water pollution represents one of the most important problems affecting the health of living organisms, so it was necessary to work on the formation of active materials to get rid of pollutants. In this study, Titanium dioxide (TiO2) doping Zinc oxide (ZnO) nanocomposites were produced via simple sonication method at 500 Hz in ethanol medium. At different weight concentrations (2.5, 5, 7.5, and 10 %). The morphology, structure configuration, chemical bonding, crystalline phase, and surface properties of obtained nanocomposites were characterized via FESEM, BET, XRD, XPS, RAMAN and FTIR instrumentation. The nanocomposites were employed as an adsorbent to eliminate the methyl orange (MO) and Indigo Carmine (IC) dyes from an aqueous solution. Batch removal experiments revealed that the elimination of MO and IC dyes by the TiZnO surface was pH and doping Ti concentration-dependent, with maximum removal occurring at pH = 7 for MO and pH = 3 for IC contaminants at 10 % doping Ti concentration (Ti (10 %)@ZnO). Langmuir model fit the absorptive removal of MO and IC dyes into the Ti (10 %)@ZnO surface well. The maximal removal capacity of Ti (10 %)@ZnO nanocomposite was found to be 994.24 mg. g-1 for MO and 305.39 mg. g-1 for IC. The Ti (10 %)@ZnO nanocomposite showed remarkable high stability towards the removal of both dyes through consecutive four cycles.

In Vitro Influence of ZnO, CrZnO, RuZnO, and BaZnO Nanomaterials on Bacterial Growth.

In this work, ZnO, CrZnO, RuZnO, and BaZnO nanomaterials were synthesized and characterized in order to study their antibacterial activity. The agar well diffusion, minimum inhibitory concentration (MIC), and minimum bactericidal concentration (MBC) assays were used to determine the antibacterial activity of the fabricated nanomaterials against Staphylococcus aureus ATCC 29213, Escherichia coli ATCC35218, Klebsiella pneumoniae ATCC 7000603, and Pseudomonas aeruginosa ATCC 278533. The well-diffusion test revealed significant antibacterial activity against all investigated bacteria when compared to vancomycin at a concentration of 1 mg/mL. The most susceptible bacteria to BaZnO, RuZnO, and CrZnO were Staphylococcus aureus (15.5 ± 0.5 mm), Pseudomonas aeruginosa (19.2 ± 0.5 mm), and Pseudomonas aeruginosa (19.7 ± 0.5), respectively. The MIC values indicated that they were in the range of 0.02 to 0.2 mg/mL. The MBC values showed that the tested bacteria's growth could be inhibited at concentrations ranging from 0.2 to 2.0 mg/mL. According to the MBC/MIC ratio, BaZnO, RuZnO, and CrZnO exhibit bacteriostatic effects and may target bacterial protein synthesis based on the results of the tolerance test. This study shows the efficacy of the above-mentioned nanoparticles on bacterial growth. Further biotechnological and toxicological studies on the nanoparticles fabricated here are recommended to benefit from these findings.

Efficient Mesoporous MgO/g-C3N4 for Heavy Metal Uptake: Modeling Process and Adsorption Mechanism.

Removing toxic metal ions arising from contaminated wastewaters caused by industrial effluents with a cost-effective method tackles a serious concern worldwide. The adsorption process onto metal oxide and carbon-based materials offers one of the most efficient technologies adopted for metal ion removal. In this study, mesoporous MgO/g-C3N4 sorbent is fabricated by ultrasonication method for the uptake Pb (II) and Cd (II) heavy metal ions from an aqueous solution. The optimum conditions for maximum uptake: initial concentration of metal ions 250 mg g-1, pH = 5 and pH = 3 for Pb++ and Cd++, and a 60 mg dose of adsorbent. In less than 50 min, the equilibrium is reached with a good adsorption capacity of 114 and 90 mg g-1 corresponding to Pb++ and Cd++, respectively. Moreover, the adsorption isotherm models fit well with the Langmuir isotherm, while the kinetics model fitting study manifest a perfect fit with the pseudo-second order. The as fabricated mesoporous MgO/g-C3N4 sorbent exhibit excellent Pb++ and Cd++ ions uptake and can be utilized as a potential adsorbent in wastewater purification.

Application of Synthesized Vanadium-Titanium Oxide Nanocomposite to Eliminate Rhodamine-B Dye from Aqueous Medium.

In this study, a V@TiO2 nanocomposite is examined for its ability to eliminate carcinogenic Rhodamine (Rh-B) dye from an aqueous medium. A simple ultrasonic method was used to produce the nanosorbent. In addition, V@TiO2 was characterized using various techniques, including XRD, HRTEM, XPS, and FTIR. Batch mode studies were used to study the removal of Rh-B dye. In the presence of pH 9, the V@TiO2 nanocomposite was able to remove Rh-B dye to its maximum extent. A correlation regression of 0.95 indicated that the Langmuir model was a better fit for dye adsorption. Moreover, the maximum adsorption capacity of the V@TiO2 nanocomposite was determined to be 158.8 mg/g. According to the thermodynamic parameters, dye adsorption followed a pseudo-first-order model. Based on the results of the study, a V@TiO2 nanocomposite can be reused for dye removal using ethanol.

Application of Bi12ZnO20 Sillenite as an Efficient Photocatalyst for Wastewater Treatment: Removal of Both Organic and Inorganic Compounds.

This work aims to synthesize and characterize a material that can be used as an effective catalyst for photocatalytic application to remove both organic and inorganic compounds from wastewater. In this context, sillenite Bi12ZnO20 (BZO) in a pure phase was synthesized using the sol-gel method. Before calcination, differential scanning calorimetry (DSC) analysis was done to determine the temperature of the formation of the sillenite phase, which was found to be 800 °C. After calcination, the phase was identified by X-ray diffraction (XRD) and then refined using the Rietveld refinement technique. The results prove that BZO crystals have a cubic symmetry with the space group I23 (N°197); the lattice parameters of the structure were also determined. From the crystalline size, the surface area was estimated using the Brunauer-Emmett-Teller (BET) method, which was found to be 11.22 m2/g. The formation of sillenite was also checked using the Raman technique. The morphology of the crystals was visualized using electron scanning microscope (SEM) analysis. After that, the optical properties of BZO were investigated by diffuse reflectance spectroscopy (DRS) and photoluminescence (PL); an optical gap of 2.9 eV was found. In the final step, the photocatalytic activity of the BZO crystals was evaluated for the removal of inorganic and organic pollutants, namely hexavalent chromium Cr(VI) and Cefixime (CFX). An efficient removal rate was achieved for both contaminants within only 3 h, with a 94.34% degradation rate for CFX and a 77.19% reduction rate for Cr(VI). Additionally, a kinetic study was carried out using a first-order model, and the results showed that the kinetic properties are compatible with this model. According to these findings, we can conclude that the sillenite BZO can be used as an efficient photocatalyst for wastewater treatment by eliminating both organic and inorganic compounds.

Adsorption Behavior of Congo Red onto Barium-Doped ZnO Nanoparticles: Correlation between Experimental Results and DFT Calculations.

Ba-loaded ZnO nanoparticles (Ba/ZnO) were obtained by the co-precipitation process and employed as a sorbent for Congo Red (C32H22N6Na2O6S2) dye (CR). Physicochemical parameters such as particle size, pH, and contact time were checked to characterize the adsorption process. The maximum adsorption capacity of Ba/ZnO NPs for CR (1614.26 mg/g) proves its potential utility in the elimination of CR dye from wastewater. The adsorption mechanism was studied via infrared spectroscopy and density functional theory calculations. The geometrical parameters and electronic properties of the CR-Ba/ZnO complex, particularly the interaction energy, the density of states, and the charge transfer, highlighted the Ba-ion mediation in the chemical bond formation between CR and the surface. The interaction between CR and Ba-doped ZnO has found to show strong chemisorption with charge transfer between the SO3- group and adsorbed Ba2+ ion on the surface.

Efficient photodegradation of azucryl red by copper-doped TiO2 nanoparticles-experimental and modeling studies.

This research aims to investigate the effect of copper doping on the photocatalysis performance of TiO2 nanoparticles for disposal wastewater from organic pollutants. X-ray diffraction analysis manifests the crystallization of a rutile phase for pure and copper-doped TiO2 except for 2% resulting in a rutile-to-anatase phase transformation. The crystallite size is found less affected by Cu doping, i.e., ~30 nm. BET analysis indicates a decrease in the specific surface area as the doping loading increases. Scanning electron microscopy observations reveal spherical particles at the nanometer range for pure TiO2 and then larger agglomerates of ultrafine particles with Cu doping. FTIR analysis notifies the existence of hydroxyl groups, which will promote the photocatalysis process. The photodegradation of azucryl red (AR) has been investigated under different conditions; i.e., Cu-loading, initial concentration of AR, and pH. The kinetics of the photodegradation process is further found to comply with the Lagergren kinetic law, regardless the experimental conditions. Nevertheless, the photodegradation process is not only controlled by the intra-particle diffusion mechanism, but also by mass transfer through a liquid film boundary. The maximum degradation of AR, i.e., 86%, has been achieved at pH = 5.0 during 60 min of contact time for the 2% Cu doping, with effective regeneration. The Freundlich model exhibits a better fitting for AR dye photodegradation equilibrium data, compared to Langmuir, Temkin, and Dubinin-Radushkevich.

Effect of aluminum loading on structural and morphological characteristics of ZnO nanoparticles for heavy metal ion elimination.

The aim of this work consists on the synthesis of a nanomaterial for heavy metal ion removal from aqueous solutions. Al-doped ZnO (ZnO:Alx%) nanopowders with 0 to 5% Al content are prepared via an amended sol-gel method. The morphology and microstructure of the prepared ZnO:Alx% are probed by means of scanning electron microscopy (SEM), X-ray particles diffraction (XRD) analysis, energy dispersive X-ray spectroscopy (EDS) and elemental mapping. The findings reveal the prevalence of the hexagonal wurtzite ZnO structure with increasing crystallite size (45 to 60 nm) as a result of Al doping. SEM images show nearly spherical nanoparticles with considerable aggregation. EDS and elemental mapping analysis confirm the incorporation of Al within ZnO host lattice. The relatively large surface area as estimated from N2 adsorption makes the nanopowders very favorable for the uptake Cd(II), Cr (IV), Co (II) and Ni(II) from aqueous solution. The ZnO:Alx% with 1 wt% Al exhibits the highest uptake rate of heavy metal ions. The adsorption process has been found to be spontaneous and endothermic and obey Langmuir adsorption model. The high tendency of the prepared nanoparticles to eliminate heavy metal ions renders them suitable candidates for environmental remediation. Desorption studies with 0.1 M NaOH indicate that ZnO:Alx% can be regenerated effectively.

Aflatoxin M1 in breast milk of nursing Sudanese mothers.

The presence of aflatoxin M1 (AFM1) in the breast milk of nursing Sudanese mothers was investigated using AOAC official method 980.21 as the extraction method and HPLC with fluorescence detector for separation and detection. Following informed consent, 94 breast milk samples of mothers were collected, and 51 samples were found to be positive for AFM1, with an average concentration of 0.401 ± 0.525 ng g(-1) and a maximum level of 2.561 ng g(-1). The volunteers completed a questionnaire concerning their dietary preferences. The data collected suggest that peanut butter, vegetable oils and rice are the main sources responsible for the AFM1 burden in breast milk. The toxin levels are alarmingly high, and indicate that Sudanese infants are exposed to high levels of AFM1. A wide range of harmful effects, and consequently health problems, can be expected due AFM1 toxicity.