ABSTRACT
Although di(2-ethylhexyl) terephthalate (DOTP) is being widely adopted as a non-phthalate plasticizer, existing research primarily focuses on human and rat toxicity. This leaves a significant gap in our understanding of their impact on microbial communities. This study assessed the biodegradation and toxicity of DOTP on microbes, focusing on its impact on biofilms and microbial metabolism using Rhodococcus ruber as a representative bacterial strain. DOTP is commonly found in mass fractions between 0.6 and 20% v/v in various soft plastic products. This study used polyvinyl chloride films (PVC) with varying DOTP concentrations (range 1-10% v/v) as a surface for analysis of biofilm growth. Cell viability and bacterial stress responses were tested using LIVE/DEAD™ BacLight™ Bacterial Viability Kit and by the detection of reactive oxygen species using CellROX™ Green Reagent, respectively. An increase in the volume of dead cells (in the plastisphere biofilm) was observed with increasing DOTP concentrations in experiments using PVC films, indicating the potential negative impact of DOTP on microbial communities. Even at a relatively low concentration of DOTP (1%), signs of stress in the microbes were noticed, while concentrations above 5% compromised their ability to survive. This research provides a new understanding of the environmental impacts of alternative plasticizers, prompting the need for additional research into their wider effects on both the environment and human health.
Subject(s)
Biodegradation, Environmental , Biofilms , Phthalic Acids , Plasticizers , Reactive Oxygen Species , Plasticizers/toxicity , Biofilms/drug effects , Reactive Oxygen Species/metabolism , Phthalic Acids/toxicity , Phthalic Acids/metabolism , Rhodococcus/metabolism , Rhodococcus/drug effects , Polyvinyl Chloride/toxicity , Diethylhexyl Phthalate/toxicityABSTRACT
Burning incenses and scented candles may provide harmful chemicals. Although many studies have evaluated volatile organic chemicals emitted by their use and related health risks, extension of our understanding for guiding appropriate use under various use conditions is necessary. In this study, emission characteristics of commercial incenses and scented candles were evaluated in a laboratory chamber using real-time measurement and the time-weighted average exposure concentrations of monoaromatic compounds and monoterpenes were assessed using passive samplers while volunteers living in a studio apartment use them. After burning incense, the average levels of benzene increased from 1.4 to 100 µg m-3. The presence of a wood core in commercial incense products was the main cause of high benzene emission by burning them although the increase in benzene was also influenced by factors such as the brand of the products, the number of incense sticks burned, the duration of each burning session, and ventilation period. Electrical warming of scented candles increased the levels of monoterpenes by factors of 16-30 on average. Considering the emission characteristics found in this study, exposure to benzene and monoterpenes could be mitigated by cautious use of those products in residential areas.
Subject(s)
Air Pollutants , Air Pollution, Indoor , Benzene , Environmental Monitoring , Volatile Organic Compounds , Volatile Organic Compounds/analysis , Air Pollution, Indoor/analysis , Air Pollution, Indoor/statistics & numerical data , Environmental Monitoring/methods , Benzene/analysis , Air Pollutants/analysis , Housing , Humans , Monoterpenes/analysis , Odorants/analysisABSTRACT
The exposure levels of selected terpenes (limonene, α- and ß-pinenes, and γ-terpinene) emitted by essential oil diffusers in vehicles and studio apartments were assessed using a passive sampling method. A previously developed passive sampler composed of an expanded polytetrafluoroethylene membrane and adsorbent (ePTFE PS) was enlarged and made wearable. Before field deployment, the sampling performance of the modified ePTFE PS for selected terpenes was compared with that of active sampling in a lab-scale 5 m3 test chamber under constant exposure conditions, supporting that passive sampling provides reasonable estimates of the time-weighted exposure concentration. Fifty volunteers were recruited and asked to wear the ePTFE PS while using an essential oil diffuser inside their own vehicle while commuting and in their studio apartment while sleeping. Terpene levels without an essential oil diffuser were very low in vehicles and 47, 3.6, 1.6, and 0.62 µg m-3 for average concentrations of limonene, α- and ß-pinenes, and γ-terpinene in studio apartments, respectively, close to those reported in previous studies. The indoor concentrations of all selected terpenes in vehicles and studio apartments were elevated by the use of essential oil diffusers, especially in vehicles. The average concentration of limonene in vehicles after the use of essential oil diffusers was 11 µg m-3, which was greater than that before use by a factor of 30. Therefore, cautious usage of essential oil diffusers indoors where the volume is limited, such as a vehicle, is needed to reduce exposure to terpenes.
Subject(s)
Oils, Volatile , Terpenes , Humans , Limonene , Cyclohexane MonoterpenesABSTRACT
The unified bioaccessibility research group of Europe (BARGE) method (UBM) suggests using in vitro experimental conditions for simulating the release of chemicals from confined matrices, such as soils and sediments, in the human gastrointestinal tract. It contains comprehensive steps that simulate human digestion pathways and has good potential for application in the leaching of plastic additives from accidentally ingested plastic particles. However, its complexity could be a challenge for routine screening assessments of the migration of chemicals from consumer plastic products. In this study, the UBM was modified to assess the migration of plastic additives from consumer products with five model phthalate esters (i.e., dibutyl phthalate (DBP), benzyl butyl phthalate (BBP), bis(2-ethylhexyl) phthalate (DEHP), and di-n-octyl phthalate (DNOP)) from polyvinyl chloride (PVC). The migration of phthalate esters was observed in four digestive phases (saliva, gastric, duodenal, and bile). Three separate experiments were conducted with the addition of (1) inorganic constituents only, (2) inorganic and organic constituents, and (3) inorganic and organic constituents in combination with digestive enzymes. While using enzymes with the UBM solution, the migrated mass for leached compounds was comparatively low (0.226 ± 0.04 µg) in most digestion phases, likely due to a self-generated coating of enzymes on the plastic materials. However, higher mass migration (0.301 ± 0.05) was observed when phthalate esters were analyzed in the UBM solution, excluding the enzymes. A ring test among six independent laboratories confirmed the robustness of the modified method. Therefore, we propose a simplified version of the original UBM designed mainly for the migration of inorganic elements using only the inorganic and organic components of the solution throughout all phases of digestion.