Therapeutic Potential of Chlorhexidine-Loaded Calcium Hydroxide-Based Intracanal Medications in Endo-Periodontal Lesions: An Ex Vivo and In Vitro Study.

Endo-periodontal lesions are challenging clinical situations where both the supporting tissues and the root canal of the same tooth are infected. In the present study, chlorhexidine (CHX)-loaded calcium hydroxide (CH) pastes were used as intracanal medications (ICMs). They were prepared and tested on pathogens found in both the root canal and the periodontal pocket. Exposure to 0.5% and 1% CHX-loaded ICMs decreased the growth of Porphyromonas gingivalis and was effective in eradicating or inhibiting an Enterococcus faecalis biofilm. CH was injected into the root canal of extracted human teeth immersed in deionized water. CHX-loaded ICMs resulted in the transradicular diffusion of active components outside the tooth through the apex and the lateral dentinal tubules, as shown by the release of CHX (from 3.99 µg/mL to 51.28 µg/mL) and changes in pH (from 6.63 to 8.18) and calcium concentrations (from 2.42 ppm to 14.67 ppm) after 7 days. The 0.5% CHX-loaded ICM was non-toxic and reduced the release of IL-6 by periodontal cells stimulated by P. gingivalis lipopolysaccharides. Results indicate that the root canal may serve as a reservoir for periodontal drug delivery and that CHX-based ICMs can be an adjuvant for the control of infections and inflammation in endo-periodontal lesions.

Reactive Distillation of Glycolic Acid Using Heterogeneous Catalysts: Experimental Studies and Process Simulation.

The glycerol oxidation reaction was developed leading to selective catalysts and optimum conditions for the production of carboxylic acids such as glycolic acid. However, carboxylic acids are produced in highly diluted mixtures, challenging the recovery and purification, and resulting in high production costs, polymerization, and thermal degradation of some of the products. The protection of the acid function by esterification reaction is one of the most promising alternatives through reactive distillation (RD); this technique allows simultaneously the recovery of carboxylic acids and the elimination of most part of the water. The reactive distillation, experimental and simulation, of glycolic acid was performed, based on kinetic and thermodynamic models developed. For the thermodynamic model, binary parameters of the missing couples were determined experimentally, and the non-random two-liquid (NRTL) model was selected as the most suitable to represent the binary behavior. The kinetic study of the esterification in the presence of homogeneous and heterogeneous catalysis concluded that the heterogeneous reaction can be accurately described either by a pseudo-homogeneous model or the Langmuir-Hinshelwood (L-H) adsorption model. Reactive distillation was conducted in a distillation column filled with random packing sulfonated ion-exchange resin, Nafion NR50®, or with extruded TiO2-Wox. The conversion rate of glycolic acid in reactive distillation increases from 14% without catalyst to 30% and 36% using Nafion NR50® and TiO2-Wox, respectively. As opposed to the batch reactor study, the conversion rate of glycolic acid was better with TiO2-Wox than with sulfonated ion-exchange resin. The better performance was related to an increase in the hydrodynamics inside the column. Tests using water in the feed confirm the hypothesis by increasing the conversion rate because of the decrease in the mass transfer resistance by reducing the average diffusion coefficient. The simulation of the reactive distillation column with ProSim® Plus showed that the yield of the ester increased operating at a low feed rate with reactive stripping. In the presence of water in the feed, nonreactive stages are required, including an enrichment region to separate water vapor.

Aqueous solubility (in the range between 298.15 and 338.15 K), vapor pressures (in the range between 10(-5) and 80 Pa) and Henry's law constant of 1,2,3,4-dibenzanthracene and 1,2,5,6-dibenzanthracene.

Aqueous solubility and vapor pressures of 1,2,3,4-dibenzanthracene and 1,2,5,6-dibenzanthracene were determined using dynamic saturation methods. For the two isomers, aqueous solubility is in the range between 10(-10) and 10(-2) in molar fraction corresponding to temperature between 298.15 and 338.15K. Vapor pressures of the pure solutes range from 10(-5) to 80 Pa. Prior to the study of the two dibenzanthracenes and in order to check the experimental procedures, solubility of fluoranthene (between 298 and 338 K) and vapor pressures of phenanthrene and fluoranthene (between 300 and 470 K) were measured. From aqueous solubility data coupled with the vapor pressures of the pure solutes, partition coefficient air-water, KAW, and Henry's constant, KH, of environmental relevance were calculated.

First experimental determination of the absolute gas-phase rate coefficient for the reaction of OH with 4-hydroxy-2-butanone (4H2B) at 294 K by vapor pressure measurements of 4H2B.

The reaction of the OH radicals with 4-hydroxy-2-butanone was investigated in the gas phase using an absolute rate method at room temperature and over the pressure range 10-330 Torr in He and air as diluent gases. The rate coefficients were measured using pulsed laser photolysis (PLP) of H(2)O(2) to produce OH and laser induced fluorescence (LIF) to measure the OH temporal profile. An average value of (4.8 ± 1.2) × 10(-12) cm(3) molecule(-1) s(-1) was obtained. The OH quantum yield following the 266 nm pulsed laser photolysis of 4-hydroxy-2-butanone was measured for the first time and found to be about 0.3%. The investigated kinetic study required accurate measurements of the vapor pressure of 4-hydroxy-2-butanone, which was measured using a static apparatus. The vapor pressure was found to range from 0.056 to 7.11 Torr between 254 and 323 K. This work provides the first absolute rate coefficients for the reaction of 4-hydroxy-2-butanone with OH and the first experimental saturated vapor pressures of the studied compound below 311 K. The obtained results are compared to those of the literature and the effects of the experimental conditions on the reactivity are examined. The calculated tropospheric lifetime obtained in this work suggests that once emitted into the atmosphere, 4H2B may contribute to the photochemical pollution in a local or regional scale.

Vapour pressures, aqueous solubility, Henry's law constants and air/water partition coefficients of 1,8-dichlorooctane and 1,8-dibromooctane.

New data on the vapour pressures and aqueous solubility of 1,8-dichlorooctane and 1,8-dibromooctane are reported as a function of temperature between 20 degrees C and 80 degrees C and 1 degrees C and 40 degrees C, respectively. For the vapour pressures, a static method was used during the measurements which have an estimated uncertainty between 3% and 5%. The aqueous solubilities were determined using a dynamic saturation column method and the values are accurate to within +/-10%. 1,8-Dichlorooctane is more volatile than 1,8-dibromooctane in the temperature range covered (p(sat) varies from 3 to 250 Pa and from 0.53 to 62 Pa, respectively) and is also approximately three times more soluble in water (mole fraction solubilities at 25 degrees C of 5.95 x 10(-7) and 1.92 x 10(-7), respectively). A combination of the two sets of data allowed the calculation of the Henry's law constants and the air water partition coefficients. A simple group contribution concept was used to rationalize the data obtained.