ABSTRACT
A highly sensitive and selective formaldehyde sensor was successfully fabricated using hybrid materials of nitrogen-doped double-walled carbon nanotubes (N-DWCNTs) and polyvinylpyrrolidone (PVP). Double-walled carbon nanotubes (DWCNTs) and N-DWCNTs were produced by high-vacuum chemical vapor deposition using ethanol and benzylamine, respectively. Purified DWCNTs and N-DWCNTs were dropped separately onto the sensing substrate. PVP was then dropped onto pre-dropped DWCNT and N-DWCNTs (hereafter referred to as PVP/DWCNTs and PVP/N-DWCNTs, respectively). As-fabricated sensors were used to find 1,2-dichloroethane, dichloromethane, formaldehyde and toluene vapors in parts per million (ppm) at room temperature for detection measurement. The sensor response of N-DWCNTs, PVP/DWCNTs and PVP/N-DWCNTs sensors show a high response to formaldehyde but a low response to 1,2-dichloroethane, dichloromethane and toluene. Remarkably, PVP/N-DWCNTs sensors respond sensitively and selectively towards formaldehyde vapor, which is 15 times higher than when using DWCNTs sensors. This improvement could be attributed to the synergistic effect of the polymer swelling and nitrogen-sites in the N-DWCNTs. The limit of detection (LOD) of PVP/N-DWCNTs was 15 ppm, which is 34-fold higher than when using DWCNTs with a LOD of 506 ppm. This study demonstrated the high sensitivity and selectivity for formaldehyde-sensing applications of high-performance PVP/N-DWCNTs hybrid materials.
Subject(s)
Nanotubes, Carbon , Povidone , Nitrogen , Formaldehyde , Gases , TolueneABSTRACT
Here, we present a facile technique for synthesis of graphene nanosheet (GNS)-grafted double-walled carbon nanotube (DWCNT) hybrid carbon nanostructures (here after referred to as G-DWCNTs) by directly growing GNSs along the sidewalls of DWCNTs using a two-step chemical vapor deposition (CVD). DWCNTs were synthesized by floating catalyst CVD at 1300 °C using ferrocene and thiophene dissolved in ethanol. Then, GNSs were grafted onto the synthesized DWCNT bundles by thermal CVD at 1300 °C using ethanol. The sharp-edged petal-like structure of GNSs were grown along the sidewalls of DWCNT bundles while maintaining the one-dimensional structure of DWCNT. Next, DWCNTs and G-DWCNTs were dispersed in ethanol, then deposited on the paper using vacuum filtration method and used for ethanol detection. G-DWCNTs sensor exhibited a 3-fold improvement in the response to ethanol vapor compared to the DWCNTs sensor. The sensing mechanism of DWCNTs and G-DWCNTs can be described in terms of charge transfer between the gas molecules and sensing material. These results demonstrate that the facile technique by two-step CVD method provides a promising approach for simple and low-cost technique to synthesize the hybrid nanostructure of GNSs and DWCNTs. The new hybrid carbon nanostructures are attractive for gas sensing application.