ABSTRACT
In this paper, we present a feasible microsystem in which the direction of localized ultrahigh frequency (â¼1GHz) bulk acoustic wave can be controlled in a silicon wafer. Deep etching technology on the silicon wafer makes it possible to achieve high aspect ratio etching patterns which can be used to control bulk acoustic wave to transmit in the directions parallel to the surface of the silicon wafer. Passive 45° mirror planes obtained by wet chemical etching were employed to reflect the bulk acoustic wave. Zinc oxide (ZnO) thin film transducers were deposited by radio frequency sputtering with a thickness of about 1µm on the other side of the wafer, which act as emitter/receptor after aligned with the mirrors. Two opponent vertical mirrors were inserted between the 45° mirrors to guide the transmission of the acoustic waves. The propagation of the bulk acoustic wave was studied with simulations and the characterization of S(21) scattering parameters, indicating that the mirrors were efficient to guide bulk acoustic waves in the silicon wafer.
Subject(s)
Computer-Aided Design , Lenses , Models, Theoretical , Refractometry/instrumentation , Transducers , Ultrasonography/instrumentation , Computer Simulation , Equipment Design , Equipment Failure Analysis , Scattering, RadiationABSTRACT
SU-8, an epoxy-based photoresist, was introduced as the acoustical matching layer between silicon and water for lab-on-chip applications integrating acoustic characterization. Acoustical performances, including the acoustic longitudinal wave velocity and attenuation of the SU-8-based matching layer, were characterized at a frequency of 1 GHz at room temperature. The gain in echo characterization with a SU-8/SiO2 bilayer and with different nanocomposite monolayers made of SU-8 and TiO2 nanoparticles (size around 35 nm) between silicon and water was characterized as being above 10 dB in each case. With the increase of concentration of TiO2 in SU-8 based composites from 0 to 30 wt%, acoustical impedance of the nanocomposites increased from about 3 to 6 MRayls, respectively. The acoustical attenuation in the nanocomposites is between 0.5 and 0.6 dB/microm. The most efficient matching was obtained with the nanocomposite integrating 30 wt% TiO2 nanoparticles, with which the enhanced loss is about 0.34 dB as the attenuation is about 0.5 dB/microm. This type of matching layer has potential applications in lab-on-chip technology for high frequency transducers or in the fabrication of high frequency piezocomposites.