ABSTRACT
This research focuses on the synthesis of hydrogels exhibiting enhanced antioxidant properties derived from hyaluronic acid (HA) and poly(ethylene brassylate-co-squaric acid) (PEBSA), a copolymacrolactone that have the ability to be used in drug delivery applications. Quercetin (Q), a bioflavonoid with strong antioxidant properties, is employed as a bioactive compound. The biomolecule is encapsulated in the polymeric network using different entrapment techniques, including the initial formation of a complex between PEBSA and Q, which is demonstrated through the dynamic light scattering technique. Fourier transform infrared spectroscopy (FT-IR) and rheological studies confirm the formation of the hydrogels, revealing the occurrence of physical interactions between the synthetic polymer and the polysaccharide. Moreover, the hydrogels demonstrate biocompatible properties after direct contact with the HDFa cell line and antioxidant properties, as revealed by DPPH tests.
ABSTRACT
Miscarriage is defined as the loss of a pregnancy before 24 weeks and administration of progesterone in pregnancy has considerably decreased the risk of premature birth. Progesterone (PGT) starting from the luteal phase stabilizes pregnancy, promotes differentiation of the endometrium, and facilitates the implantation of the embryo. Within the present study, novel hybrid hydrogels based on chitosan methacrylate (CHT), hyaluronic acid (HA), and poly(N-isopropylacrylamide) (PNIPAAm) for vaginal delivery of progesterone were evaluated. The hydrogels were characterized by Fourier transform infrared spectroscopy (FTIR) and scanning electron microscopy (SEM) for structural identity assessment and evaluation of their morphological aspects. The ability to swell, the release capacity, enzymatic degradation, cytotoxicity, and mucoadhesion were also reported. The characterized hydrogels demonstrated mucoadhesive properties in contact with the vaginal tissue of swine and bovine origin as substrates, and biodegradability and controlled release in a simulated vaginal environment. Cytocompatibility tests confirmed the ability of the hydrogels and progesterone to support cell viability and growth. The results showed pH-dependent behavior, controlled drug release, good cytocompatibility, and mucoadhesive properties. The hydrogels with higher chitosan amounts demonstrated better bioadhesive properties. This study provides insights into the potential of these hydrogels for the controlled vaginal delivery of progesterone, with promising therapeutic effects and no cytotoxicity observed. The experimental results indicated that a composition with a moderate content of PNIPAAm was suitable for the controlled delivery of progesterone.
ABSTRACT
We report a biocompatible hydrogel dressing based on sodium alginate-grafted poly(N-vinylcaprolactam) prepared by encapsulation of Rifampicin as an antimicrobial drug and stabilizing the matrix through the repeated freeze-thawing method. The hydrogel structure and polymer-drug compatibility were confirmed by FTIR, and a series of hydrogen-bond-based interactions between alginate and Rifampicin were identified. A concentration of 0.69% Rifampicin was found in the polymeric matrix using HPLC analysis and spectrophotometric UV-Vis methods. The hydrogel's morphology was evaluated by scanning electron microscopy, and various sizes and shapes of pores, ranging from almost spherical geometries to irregular ones, with a smooth surface of the pore walls and high interconnectivity in the presence of the drug, were identified. The hydrogels are bioadhesive, and the adhesion strength increased after Rifampicin was encapsulated into the polymeric matrix, which suggests that these compositions are suitable for wound dressings. Antimicrobial activity against S. aureus and MRSA, with an increased effect in the presence of the drug, was also found in the newly prepared hydrogels. In vitro biological evaluation demonstrated the cytocompatibility of the hydrogels and their ability to stimulate cell multiplication and mutual cell communication. The in vitro scratch assay demonstrated the drug-loaded alginate-grafted poly(N-vinylcaprolactam) hydrogel's ability to stimulate cell migration and wound closure. All of these results suggest that the prepared hydrogels can be used as antimicrobial materials for wound healing and care applications.
ABSTRACT
Biobased porous hydrogels enriched with phytocompounds-rich herbal extracts have aroused great interest in recent years, especially in healthcare. In this study, new macroporous hybrid cryogel constructs comprising thiourea-containing chitosan (CSTU) derivative and a Hypericum perforatum L. extract (HYPE), commonly known as St John's wort, were prepared by a facile one-pot ice-templating strategy. Benefiting from the strong interactions between the functional groups of the CSTU matrix and those of polyphenols in HYPE, the hybrid cryogels possess excellent liquid absorption capacity, mechanical resilience, antioxidant performance, and a broad spectrum of antibacterial activity simultaneously. Thus, owing to their design, the hybrid constructs exhibit an interconnected porous architecture with the ability to absorb over 33 and 136 times their dry weight, respectively, when contacted with a phosphate buffer solution (pH 7.4) and an acidic aqueous solution (pH 2). These cryogel constructs have extremely high compressive strengths ranging from 839 to 1045 kPa and withstand elevated strains of over 70% without developing fractures. Moreover, the water-swollen hybrid cryogels with the highest HYPE content revealed a complete and instant shape recovery after uniaxial compression. The incorporation of HYPE into CSTU cryogels enabled substantial improvement in scavenging reactive oxygen species and an expanded antibacterial spectrum toward multiple pathogens, including Gram-positive bacteria (Staphylococcus aureus and Staphylococcus epidermidis), Gram-negative bacteria (Escherichia coli and Pseudomonas aeruginosa), and fungi (Candida albicans). Cell viability experiments demonstrated the cytocompatibility of the 3D cryogel constructs, which did not induce changes in the fibroblast morphology. This work showcases a simple and effective strategy to immobilize HYPE extracts on CSTU 3D networks, allowing the development of novel multifunctional platforms with promising potential in hemostasis, wound dressing, and dermal regeneration scaffolds.
Subject(s)
Anti-Bacterial Agents , Biocompatible Materials , Chitosan , Cryogels , Hypericum , Plant Extracts , Chitosan/chemistry , Chitosan/pharmacology , Hypericum/chemistry , Cryogels/chemistry , Biocompatible Materials/chemistry , Biocompatible Materials/pharmacology , Plant Extracts/chemistry , Plant Extracts/pharmacology , Anti-Bacterial Agents/pharmacology , Anti-Bacterial Agents/chemistry , Animals , Mice , Porosity , Staphylococcus aureus/drug effects , Compressive Strength , Antioxidants/pharmacology , Antioxidants/chemistry , Escherichia coli/drug effects , Escherichia coli/growth & developmentABSTRACT
In recent years, increasing interest has been accorded to polyester-based polymer microstructures, driven by their promising potential as advanced drug delivery systems. This study presents the preparation and characterization of new polymeric microparticles based on poly(ethylene brassylate-co-squaric acid) loaded with norfloxacin, a broad-spectrum antibiotic. Polymacrolactone was synthesised in mild conditions through the emulsion polymerization of bio-based and renewable monomers, ethylene brassylate, and squaric acid. The microparticles were obtained using the precipitation technique and subsequently subjected to comprehensive characterization. The impact of the copolymer/drug ratio on various properties of the new system was systematically evaluated, confirming the structure of the copolymer and the encapsulation of norfloxacin. The microspheres are approximately spherical and predominantly homogeneously distributed. The average hydrodynamic diameter of the microparticles falls between 400 and 2000 nm, a decrease that is observed with the increase in norfloxacin content. All samples showed good encapsulation efficiency and drug loading capacity, with the highest values obtained for microparticles synthesised using an equal ratio of copolymer and drug. In vitro drug release results disclose that norfloxacin molecules are released in a sustained biphasic manner for up to 24 h. Antimicrobial activity was also studied, with samples showing very good activity against E. coli and moderate activity against S. aureus and E. faecalis. In addition, HDFA human fibroblast cell cultures demonstrated the cytocompatibility of the microparticles.
ABSTRACT
Known as the degenerative disease of the knee with the highest prevalence, knee osteoarthritis (KOA) is characterized by a gradual destructive mechanism that, in severe cases, can provoke the need for total knee substitution. As the disease progresses, various enzymatic, immunological, and inflammatory processes abnormally degrade hyaluronic acid (HA), SF's main component, and affect the concentrations of specific proteins, with the final results seriously endangering synovial fluid (SF)'s rheological and tribological features and characteristics. No effective treatments have been found to stop the progression of KOA, but the injection of HA-based viscoelastic gels has been considered (alone or combined with physiotherapy (PT)) as an alternative to symptomatic therapies. In order to evaluate the effect of viscosupplementation and PT on the characteristics of SF, SF aspirated from groups treated for KOA (HA Kombihylan® and groups that received Kombihylan® and complex PT) was analyzed and compared from analytical, spectrophotometrical, and rheological perspectives. In the patients treated with PT, the SF extracted 6 weeks after viscosupplementation had a superior elastic modulus (G') and viscous moduli (Gâ³), as well as a homogeneous distribution of proteins and polysaccharides. The viscosupplementation fluid improved the bioadhesive properties of the SF, and the use of the viscosupplementation fluid in conjunction with PT was found to be favorable for the distribution of macromolecules and phospholipids, contributing to the lubrication process and the treatment of OA-affected joints.
ABSTRACT
The implementation of personalized patches, tailored to individual genetic profiles and containing specific amounts of bioactive substances, has the potential to produce a transformative impact within the medical sector. There are several methods of designing scaffolds in the context of personalized medicine, with three-dimensional (3D) printing emerging as a pivotal technique. This innovative approach can be used to construct a wide variety of pharmaceutical dosage forms, characterized by variations in shape, release profile, and drug combinations, allowing precise dose individualization and the incorporation of multiple therapeutic agents. To expand the potential and applicability of personalized medicine, particularly with regards to indomethacin (IND), a drug necessitating individualized dosing, this study proposes the development of new transdermal delivery systems for IND based on hyaluronic acid and a polylactone synthesized within our research group, namely poly(ethylene brasilate-co-squaric acid) (PEBSA). The obtained systems were characterized in terms of their swelling capacity, rheological behavior, and morphological characteristics that highlighted the formation of stable three-dimensional networks. To impart specific shape and geometry to the structures, multi-component systems based on PEBSA, HA, and methacrylate gelatin were obtained. The scaffolds were loaded with IND and subsequently 3D printed. The release capacity of IND and its dependence on the relative ratios of the components comprising the scaffold composition were highlighted. The cytocompatibility studies revealed the successful development of biocompatible and noncytotoxic systems.
Subject(s)
Hyaluronic Acid , Hydrogels , Hydrogels/chemistry , Gelatin , Administration, Cutaneous , Printing, Three-Dimensional , Indomethacin/pharmacologyABSTRACT
In light of the increasing resistance of pathogenic microorganisms to the action of antibiotics, essential oils extracted from plants with therapeutic activity provide a significant alternative to obtaining dressings for the treatment of skin wounds. The encapsulation of essential oils in an amphiphilic gel network allows better dispersion and preservation of hydrophobic bioactive substances while promoting their prolonged release. In this study, we focused on the development of a poly (vinyl alcohol) (PVA)/poly (ethylene brassylate-co-squaric acid) (PEBSA) platform embedded with thymol (Thy), and α-tocopherol (α-Tcp) as a co-drug structure with prospective use for the treatment and healing of skin wounds. The new complex bioactive system was prepared through repeated freeze-thaw processes. The influence of the composition on surface topography, hydrophilic/hydrophobic character, and in vitro interaction with simulated body fluids was evidenced. BALB/3T3 fibroblast cell culture demonstrated the cryogel scaffolds' cytocompatibility. Tests on Wistar rats confirmed their biocompatibility, integration with host tissue, and the absence of inflammatory processes. The bioactive compound significantly enhanced the healing process of full-thickness excision wounds in a rat model. Further investigations on in vivo infection models would assess the potential of the PVA/PEBSA platform with dual bioactive activity for clinical antimicrobial and wound healing therapy.
ABSTRACT
The aim of the present work was to obtain drug-loaded hydrogels based on combinations of dextran, chitosan/gelatin/xanthan, and poly (acrylamide) as a sustained and controlled release vehicle of Doxorubicin, a drug used in skin cancer therapy that is associated with severe side effects. Hydrogels for use as 3D hydrophilic networks with good manipulation characteristics were produced using methacrylated biopolymer derivatives and the methacrylate group's polymerization with synthetic monomers in the presence of a photo-initiator, under UV light stimulation (365 nm). Transformed infrared spectroscopy analysis (FT-IR) confirmed the hydrogels' network structure (natural-synthetic composition and photocrosslinking), while scanning electron microscopy (SEM) analysis confirmed the microporous morphology. The hydrogels are swellable in simulated biological fluids and the material's morphology regulates the swelling properties: the maximum swelling degree was obtained for dextran-chitosan-based hydrogels because of their higher porosity and pore distribution. The hydrogels are bioadhesive on a biological simulating membrane, and values for the force of detachment and work of adhesion are recommended for applications on skin tissue. The Doxorubicin was loaded into the hydrogels and the drug was released by diffusion for all the resulting hydrogels, with small contributions from the hydrogel networks' relaxation. Doxorubicin-loaded hydrogels are efficient on keratinocytes tumor cells, the sustained released drug interrupting the cells' division and inducing cell apoptosis; we recommend the obtained materials for the topical treatment of cutaneous squamous cell carcinoma.