Ten-Year Performance of Posterior 6-mm Implants with Single-Tooth Restorations: A Randomized Controlled Trial.

The aim of the study was to compare the clinical and radiographic outcomes of short dental implants (6-mm test group, TG) to longer implants (10-mm control group, CG) with single crown restorations after 10 y of loading. Patients requiring single-tooth replacement in the posterior jaws were randomly assigned to TG or CG. Implants were loaded with screw-retained single crowns after a healing period of 10 wk. Follow-up appointments were scheduled yearly and comprised patient-adapted oral hygiene reinstructions and polishing of all teeth and implants. After 10 y, clinical and radiographical parameters were assessed again. Out of initially 94 patients (47 in TG and CG, each), 70 (36 TG and 34 CG) could be reassessed. Survival rates accounted for 85.7% (TG) and 97.1% (CG), without significant intergroup difference (P = 0.072). All but 1 lost implant had been located in the lower jaw. These implants were not lost due to peri-implantitis but due to a late loss of osseointegration without signs of inflammation and with actually stable marginal bone levels (MBLs) over the investigation period. In general, MBLs were stable with medians (interquartile ranges) of 0.13 (0.78) mm and 0.08 (1.2) mm, for TG and CG, without significant intergroup differences. Crown-to-implant ratio showed a highly significant intergroup difference of 1.06 ± 0.18 mm and 0.73 ± 0.17 mm (P < 0.001). Few technical complications (i.e., screw loosening or chipping) were registered during the investigation period. In conclusion, given stringent professional maintenance, short dental implants with single-crown restorations show a slightly worse but statistically not different survival rate after 10 y, especially in the lower jaw, but can still be considered a valuable alternative, especially when vertical bone dimensions are limited (German Clinical Trials Registry: DRKS00006290).

In vitro evaluation of different protective techniques to reduce titanium particle contamination during implantoplasty.

OBJECTIVES: Our aim is to study titanium remains in a bone model during standardized implantoplasty under different isolation and protective modalities. MATERIAL AND METHODS: Forty implants were placed in artificial spongy bone blocks mimicking a horizontal bone loss and implant neck protrusion of 5 mm. Samples were randomly divided into four groups (n = 10), which were treated as follows: rubber dam (A), a dental adhesive paste (B), bone wax (C), and an unprotected positive control (D). Implantoplasty was performed using carbide and diamond burs under strict water cooling and standardized suction. After removal of the respective isolation materials, the bone blocks were thoroughly rinsed with tap water for 3 min and titanium chips were collected using a filter integrated in the model. The filter paper was removed and dissolved in 37% hydrochloric acid for 2 h at 120 °C and the titanium remnants were quantified using atomic absorption spectrometry. RESULTS: None of the test groups were able to completely prevent titanium particle contamination. Rubber dam (691 ± 249 µg) and bone wax (516 ± 157 µg) were found to be significantly more protective than the positive control (2313 ± 747 µg) (p < 0.001) with respect to the amount of titanium particles that remained in the bone model after implantoplasty. The adhesive paste group (1863.5 ± 538 µg) was not significantly different from the positive control (p = 0.19). CONCLUSIONS: Despite some limitations of the present study, titanium particles resulting from a standardized implantoplasty can be assumed to be significantly reduced when the tissues/bone were protected with rubber dam and bone wax, or a combination, depending on individual accessibility. CLINICAL RELEVANCE: Tissue protective measures to reduce or avoid particle contamination during implantoplasty is possible and should be considered and further clinically assessed to avoid iatrogenic inflammatory reactions.

Five-Year Survival of Short Single-Tooth Implants (6 mm): A Randomized Controlled Clinical Trial.

The aim of the present study was to evaluate whether 6-mm dental implants in the posterior segments of either jaw perform equally well in terms of clinical and radiographic outcomes when compared with 10-mm implants after 5 y of loading. Patients with single-tooth gaps in the posterior area who were scheduled for implant therapy were randomly assigned to a group receiving either a 6- or 10-mm implant. After a healing period of 10 wk, implants were loaded with a screw-retained single crown and followed up at yearly intervals. Of 96 patients, 86 could be recalled after 5 y. The implant survival rates amounted to 91% (95% confidence interval: 0.836 to 0.998) for the 6-mm group and 100% for the 10-mm group ( P = 0.036). Median crown-to-implant (C/I) ratios were 1.75 (interquartile range [IQR], 1.50 to 1.90) for the 6-mm group and 1.04 (IQR, 0.95 to 1.15) for the 10-mm group, whereas the median marginal bone levels measured -0.29 mm (IQR, -0.92 to 0.23) for the 6-mm group and -0.15 mm (IQR: -0.93 - 0.41) for the 10-mm group after 5 y. The C/I ratio turned out to be statistically significant ( P < 0.001), whereas marginal bone levels showed no significant difference between the groups. The 6-mm implants exhibited significantly lower survival rates than the 10-mm implants over 5 y, whereas there was no difference between upper and lower jaws in terms of survival ( P = 0.58). Lost implants did not show any sign of marginal bone loss or peri-implant infection previous to loss of osseointegration. High C/I ratio and implant length had no significant effect on marginal bone level changes or technical and biological complications (German Clinical Trials Registry: DRKS00006290).

Success of 6-mm Implants with Single-Tooth Restorations: A 3-year Randomized Controlled Clinical Trial.

The aim of the study was to test whether implants of 6 mm in length perform equally well as 10-mm implants in terms of survival and marginal bone-level changes when supporting single crowns. Patients with a posterior single-tooth gap were randomly allocated to either the placement of a 6-mm (test) or 10-mm implant (control). The treatment protocol allowed for internal sinus lift but not for lateral bone augmentation. After a healing period of 10 wk, implants were loaded with screw-retained single crowns. Survival rates, number of pockets ≥5 mm, and bleeding-on-probing were assessed clinically. The change of marginal bone level and crown-to-implant ratios were analyzed by 2 examiners. Longitudinal intragroup analyses for marginal bone levels were performed applying the Wilcoxon signed rank test. Intergroup differences at baseline and at 3 y were compared using the Mann-Whitney U test. The effect of implant length and crown-to-implant ratio on changes of marginal bone level also was determined. Of 94 implants placed (47 test and 47 control), 78 implants (40 test and 38 control) were available for follow-up examination at 3 y of loading. One test implant was lost during the second year. Hence, implant survival was not significantly different between the 2 groups after 3 y (98% test; 100% control). We found no significant change in the crestal bone level from baseline to 3 y for test and control implants with -0.19 ± 0.62 mm and -0.33 ± 0.71 mm, respectively. The intergroup difference was not significant. Crown-to-implant ratios were not associated with a statistically significant difference in marginal bone loss. However, the number of sites with pockets ≥5 mm was significantly higher in the test group. Based on the 3-y assessment, the use of 6-mm implants can be considered a viable option when reconstructing posterior single tooth gaps (German Clinical Trials Registry: DRKS00006290).