ABSTRACT
Microplastics have accumulated in the environment since plastic production began, with present-day observations that range from marine trenches to mountains. However, research on microplastics has only recently begun so it is unclear how they have changed over time in many oceanic regions. Our study addressed this gap by quantifying the temporal and spatial dynamics of microplastics in two deep-water regions of the Gulf of Mexico (GOM). We isolated agglutinated foraminifera from sediment cores and assessed microplastics that were incorporated into their tests. Our results indicated that microplastics were incorporated by agglutinated foraminifera after plastic production began. Microplastics were higher at deep-water sites and closer to the Mississippi River. This study confirms the presence of microplastic incorporation into agglutinated foraminifera tests and investigates microplastics in deep-water sediments in the GOM. Additional work is needed to fully identify the distribution of microplastics across the GOM and other oceanic basins.
Subject(s)
Foraminifera , Water Pollutants, Chemical , Microplastics , Plastics , Environmental Monitoring/methods , Gulf of Mexico , Water Pollutants, Chemical/analysis , Geologic Sediments , WaterABSTRACT
Aquatic sediment core subsampling is commonly performed at cm or half-cm resolution. Depending on the sedimentation rate and depositional environment, this resolution provides records at the annual to decadal scale, at best. An extrusion method, using a calibrated, threaded-rod is presented here, which allows for millimeter-scale subsampling of aquatic sediment cores of varying diameters. Millimeter scale subsampling allows for sub-annual to monthly analysis of the sedimentary record, an order of magnitude higher than typical sampling schemes. The extruder consists of a 2 m aluminum frame and base, two core tube clamps, a threaded-rod, and a 1 m piston. The sediment core is placed above the piston and clamped to the frame. An acrylic sampling collar is affixed to the upper 5 cm of the core tube and provides a platform from which to extract sub-samples. The piston is rotated around the threaded-rod at calibrated intervals and gently pushes the sediment out the top of the core tube. The sediment is then isolated into the sampling collar and placed into an appropriate sampling vessel (e.g., jar or bag). This method also preserves the unconsolidated samples (i.e., high pore water content) at the surface, providing a consistent sampling volume. This mm scale extrusion method was applied to cores collected in the northern Gulf of Mexico following the Deepwater Horizon submarine oil release. Evidence suggests that it is necessary to sample at the mm scale to fully characterize events that occur on the monthly time-scale for continental slope sediments.