Sequential pretreatment to recover carbohydrates and phosphorus from Desmodesmus sp. cultivated in municipal wastewater.

This study focused on the simultaneous recovery of carbohydrates (CHO) and phosphorus (P) from Desmodesmus sp. biomass cultivated in municipal wastewater, through a sequential pretreatment. The pretreatment consisted first of ultrasound to trigger cell disruption followed by ozonation to recover CHO and P. For ozone pretreatment, three different parameters were considered: ozone concentration (9, 15, 21, 27, 36, and 45 mg O3/L), contact time (15, 25 and 35 min), and pH (8 and 11). The maximum simultaneous release of 84% of CHO and 58% of P was achieved at the experimental parameters of ozone concentration of 45 mg O3/L, contact time of 35 min, and pH of 11. Also, P was concentrated in solution by 8- to 14-fold with respect to municipal wastewater. The sequential pretreatment was conducted at alkaline pH of 11 and atmospheric conditions, which may considerably reduce energy demand and reagents, in comparison to a traditional hydrolysis pretreatment. The results found suggest that the sequential pretreatment could be feasible on a large scale.

Intensified recovery of lipids, proteins, and carbohydrates from wastewater-grown microalgae Desmodesmus sp. by using ultrasound or ozone.

This study evaluates the effect of ultrasound and ozone pretreatments for the subsequent recovery of Desmodesmus sp. biocomponents-lipids, proteins, and carbohydrates-using a response surface methodology. Both pretreatments impact on the recovered lipids quality, solvent waste production and extraction time is analysed for process intensification purposes. For ultrasound pretreatment, independent parameters were energy applied (50-200 kWh/kg dry biomass), biomass concentration (25-75 g/L), and ultrasonic intensity (0.32 and 0.53 W/mL). While for ozone pretreatment, independent parameters were ozone concentration (3-9 mg O3/L), biomass concentration (25-75 g/L), and contact time (5-15 min). In the case of ultrasound pretreatment, recovery yield reached 97 ±â€¯0.4%, 89 ±â€¯3%, and 73 ±â€¯0.6% for proteins, carbohydrates and lipids respectively. Given process required: energy applied of 50 kWh/kg dry biomass, 75 g/L of biomass concentration, 0.32 W/mL of ultrasonic intensity, and 56 min of time process. Ultrasound caused high cell disruption releasing all proteins, thereby obviating downstream processing for its recovery. Ozone pretreatment recovery yield was 85 ±â€¯2%, 48 ±â€¯1.4%, and 25 ±â€¯1.3%, for carbohydrates, lipids and proteins respectively, under the following conditions: 9 mg O3/L of ozone concentration, 25 g/L of biomass concentration, and 5 min of contact time that depicts an energy consumption of 30.64 kWh/kg dry biomass. It was found that ultrasound and ozone pretreatments intensified the lysis and biocomponents recovery process by reducing solvent consumption by at least 92% and extraction time between 80% and 90% compared with extraction of untreated biomass biocomponents. Both pretreatments improve the composition of the recovered lipids. It was noted that the yield of neutral lipids increased from 28% to 67% for ultrasound pretreatment while for ozone pretreatment from 49% to 63%. The method used for lipid extraction may also have an effect but here it was kept constant.

Microbial fuel cells for inexpensive continuous in-situ monitoring of groundwater quality.

Online monitoring of groundwater quality in shallow wells to detect faecal or organic pollution could dramatically improve understanding of health risks in unplanned peri-urban settlements. Microbial fuel cells (MFC) are devices able to generate electricity from the organic matter content in faecal pollution making them suitable as biosensors. In this work, we evaluate the suitability of four microbial fuel cell systems placed in different regions of a groundwater well for the low-cost monitoring of a faecal pollution event. Concepts created include the use of a sediment/bulk liquid MFC (SED/BL), a sediment/sediment MFC (SED/SED), a bulk liquid/air MFC (BL/Air), and a bulk liquid/bulk liquid MFC (BL/BL). MFC electrodes assembly aimed to use inexpensive, durable, materials, which would produce a signal after a contamination event without external energy or chemical inputs. All MFC configurations were responsive to a contamination event, however SED/SED and BL/Air MFC concepts failed to deliver a reproducible output within the tested period of time. BL/BL MFC and SED/BL MFCs presented an increase in the average current after contamination from -0.75 ± 0.35 µA to -0.66 ± 0.41 µA, and 0.07 ± 0.2 mA to 0.11 ± 0.03 mA, respectively. Currents produced by the SED/BL MFC (SMFC) were considerably higher than for the BL/BL MFCs, making them more responsive, readable and graphically visible. A factorial design of experiments (DOE) was applied to evaluate which environmental and design factors had the greatest effect on current response in a contamination event. Within the ranges of variables tested, salinity, temperature and external resistance, only temperature presented a statistically significant effect (p = 0.045). This showed that the biosensor response would be sensitive to fluctuations in temperature but not to changes in salinity, or external resistances produced from placing electrodes at different distances within a groundwater well.

Mass spectrometry applied to the identification of Mycobacterium tuberculosis and biomarker discovery.

An adequate and effective tuberculosis (TB) diagnosis system has been identified by the World Health Organization as a priority in the fight against this disease. Over the years, several methods have been developed to identify the bacillus, but bacterial culture remains one of the most affordable methods for most countries. For rapid and accurate identification, however, it is more feasible to implement molecular techniques, taking advantage of the availability of public databases containing protein sequences. Mass spectrometry (MS) has become an interesting technique for the identification of TB. Here, we review some of the most widely employed methods for identifying Mycobacterium tuberculosis and present an update on MS applied for the identification of mycobacterial species.

First Report of Chestnut Blight Caused by Cryphonectria parasitica in a Chestnut Orchard in Andalusia (Southern Spain).

In Europe, chestnut blight caused by Cryphonectria parasitica (Murrill) Barr was first seen in Italy in 1938 (1). In Spain, the disease was first detected in Basque country in 1947 and later in other areas of northern Spain: Galicia, León, Navarra, and Catalonia, and in Trás-os-Montes in Portugal (2). In November 2012, in an orchard (2 ha) in Almonaster la Real (Huelva, Spain), approximately 20 cankered Castanea sativa (sweet chestnut) trees cv. Vazqueño, 40 to 50 years old, were observed. The trees were grafted 2 years before. In May and June 2013, six new disease focuses were detected near the first one. Five focuses were located in the same village and the other in Jabugo (a neighboring village). Diseased trees exhibited sunken cankers, cracked bark with mycelial fan spreads under the bark, and in some cases, orange fungal sporulation was visible on the bark. Samples were collected from two affected trees and symptom-bearing bark pieces were then placed in moist chambers at 20°C for up to 8 days to induce fungal sporulation. Cultures were made from spore masses extruding from the cankered bark and from the edge of necrotic lesions visible in the phloem of cankered bark tissue onto potato dextrose agar (PDA). Monoconidial fungal isolates were obtained from both trees. The morphological structure of two isolated fungi was identical to that described as C. parasitica (3). Species identity was confirmed by analysis of nucleotide sequences of the internal transcribed spacer (ITS) rDNA, using ITS1-ITS4 (4) as primer pairs, respectively. BLAST searches showed a high similarity between collected isolates' DNA sequences and C. parasitica sequences found on GenBank (96% coverage, 99% identity). Our isolates have been included in GenBank as KF220298 and KF220299. The pathogenicity assay of these two isolates was conducted using two cultivars of sweet chestnut (seedlings from Huelva and Granada nurseries). Isolate pathogenicity was tested on 3-year-old chestnut seedlings in a growth chamber at 25°C (day) and 20°C (night) with a 14-h photoperiod. The isolates were cultured on PDA at 25°C for 7 days. Stems were wounded at 10 cm height with a drill. Each isolate was inoculated to 25 replicates per cultivar by placing a mycelia agar plug (4 to 5 mm diameter) in the hole and wrapping the stem with Parafilm. Plants treated identically with sterile agar plugs were used as controls. Plants were then maintained at 100% relative humidity for 2 h. Both isolates induced diseases symptoms and death of seedlings of both cultivars at a mean time of 37.5 days after inoculation. No significant differences between isolates or between cultivars were detected. Twenty control plants similarly treated with sterile PDA discs did not display symptoms. C. parasitica was re-isolated from lesions, confirming Koch's postulates. Andalusia has 14,000 ha of chestnut crops with high commercial value due to their precocity. Dispersion of chestnut blight in this zone can reduce crop productivity. To our knowledge, this is the first report of C. parasitica causing chestnut blight in Andalusia (southern Spain), one of the few areas left in southwestern Europe free of chestnut blight. References: (1) A. Biraghi. Italia Agricola 7:1, 1946. (2) G. González-Varela et al. Eur. J. Plant Pathol. 131:67, 2011. (3) A. Sivanesan and P. Holliday. Cryphonectria parasitica. CMI Descriptions of Pathogenic Fungi and Bacteria. No. 704, Set. 71. Commonwealth Mycological Institute, Kew, UK, 1981. (4) T. J. White et al. Page 315 in: PCR Protocols: A Guide to Methods and Amplifications. M. A. Innis et al., eds. Academic Press, San Diego, CA, 1990.

Factors affecting current production in microbial fuel cells using different industrial wastewaters.

This study evaluated how different types of industrial wastewaters (bakery, brewery, paper and dairy) affect the performance of identical microbial fuel cells (MFCs); and the microbial composition and electrochemistry of MFC anodes. MFCs fed with paper wastewater produced the highest current density (125 ± 2 mA/m(2)) at least five times higher than dairy (25 ± 1 mA/m(2)), brewery and bakery wastewaters (10 ± 1 mA/m(2)). Such high current production was independent of substrate degradability. A comprehensive study was conducted to determine the factor driving current production when using the paper effluent. The microbial composition of anodic biofilms differed according to the type of wastewater used, and only MFC anodes fed with paper wastewater showed redox activity at -134 ± 5 mV vs NHE. Electrochemical analysis of this redox activity indicated that anodic bacteria produced a putative electron shuttling compound that increased the electron transfer rate through diffusion, and as a result the overall MFC performance.

Hipercalciuria idiopática en la urolitiasis y hematuria asintomática del niño / Idiopatic hypercalciuria in the urolithiasis and asymptomatic hematuria in child

Entre Febrero de 1984 y Mayo del 85, se estudiaron en forma prospectiva 27 niños con hipercalciuria, quienes presentaron eliminación de calcio en orina de 24 horas mayor de 4 mg/kg con media de 5.56 ñ 1.55 y relación de Cau/Cru mayor de 0.2, con media 0.37 ñ 0.15, con valores de calcio sérico normal. Nueve pacientes (33.3%) presentaron urolitiasis y 18 (66.7%) tuvieron hematuria asintomática 74% correspondieron al sexo masculino. La edad promedio fue de 7.47 ñ 2.86. Veintidos pacientes (81.4%) fueron considerados portadores de calciuria renal, (HIR) al presentar en la prueba de sobre-carga de calcio, valores en ayuna de Cau%Cru de 0.37 ñ 0.08, es decir, mayor de 0.2. En cinco (18.6%) casos se demostró hipercalciuria absortiva (HIA), con valores normales de Cau%Cru en ayunas de 0.13 ñ 0.009 y después de la sobre-carga de calcio, valores elevados 0.46 ñ 0.18. Estos resultados muestran la prevalencia de hipercalciuria renal en niños. Dos de los pacientes con hipercalciuria renal, mostraron evidencias de hiperparatiroidismo secundario en base a la eliminación de Adenosin monofosfato cíclico en orina (AMPc). Los niveles de hormona paratiroidea en suero fueron normales en los 27 niños con hipercalciuria. Tres pacientes con hipercalciuria renal, mostraron respuesta hipercalcémica a la sobre-carga de calcio, con valores de calcio sérico > 10.8 mg/dl. Se encontró correlación positiva (r = 0.7) entre la relación Cau%Cru pre-carga y los valores de calcio sérico post-carga, en los hipercalciurios renales, lo cual sugiere aumento de absorción intestinal de calcio en la HIR y explica la baja incidencia de hiperparatiroidismo ..

Megacaliosis bilateral e insuficiencia renal aguda. Reporte de un caso. / Bilateral megacaliosis and acute kidney failure. Report of a case

Se presenta el caso de un nino de 3 anos de edad quien inicialmente fue admitido al Servicio de Nefrologia del Hospital Central de Valencia por infeccion urinaria e insuficiencia renal aguda. Estudios radiologicos y ecosonograficos mostraron la tipica dilatacion primaria de los calices renales; posteriormente el paciente presento como complicacion la formacion de litiasis en pelvis renal izquierda y persistencia de la infeccion; el estudio metabolico practicado y la prueba de sobrecarga de calcio fue normal.Pruebas funcionales de filtracion glomerular han sido reiteradamente normales; solamente persiste defecto en la capacidad de concentracion renal.Este caso constituye hasta donde tenemos informacion el primer paciente pediatrico descrito en el pais con megacalicosis bilateral