ABSTRACT
All-Van der Waals (vdW)-material-based heterostructures with atomically sharp interfaces offer a versatile platform for high-performing spintronic functionalities at room temperature. One of the key components is vdW topological insulators (TIs), which can produce a strong spin-orbit-torque (SOT) through the spin-momentum locking of their topological surface state (TSS). However, the relatively low conductance of the TSS introduces a current leakage problem through the bulk states of the TI or the adjacent ferromagnetic metal layers, reducing the interfacial charge-to-spin conversion efficiency (qICS). Here, a vdW heterostructure is used consisting of atomically-thin layers of a bulk-insulating TI Sn-doped Bi1.1Sb0.9Te2S1 and a room-temperature ferromagnet Fe3GaTe2, to enhance the relative current ratio on the TSS up to ≈20%. The resulting qICS reaches ≈1.65 nm-1 and the critical current density Jc ≈0.9 × 106 Acm-2 at 300 K, surpassing the performance of TI-based and heavy-metal-based SOT devices. These findings demonstrate that an all-vdW heterostructure with thickness optimization offers a promising platform for efficient current-controlled magnetization switching at room temperature.
ABSTRACT
Current-induced control of magnetization in ferromagnets using spin-orbit torque (SOT) has drawn attention as a new mechanism for fast and energy efficient magnetic memory devices. Energy-efficient spintronic devices require a spin-current source with a large SOT efficiency (ξ) and electrical conductivity (σ), and an efficient spin injection across a transparent interface. Herein, single crystals of the van der Waals (vdW) topological semimetal WTe2 and vdW ferromagnet Fe3 GeTe2 are used to satisfy the requirements in their all-vdW-heterostructure with an atomically sharp interface. The results exhibit values of ξ ≈ 4.6 and σ ≈ 2.25 × 105 Ω-1 m-1 for WTe2 . Moreover, the significantly reduced switching current density of 3.90 × 106 A cm-2 at 150 K is obtained, which is an order of magnitude smaller than those of conventional heavy-metal/ferromagnet thin films. These findings highlight that engineering vdW-type topological materials and magnets offers a promising route to energy-efficient magnetization control in SOT-based spintronics.
ABSTRACT
Efficient magnetic control of electronic conduction is at the heart of spintronic functionality for memory and logic applications1,2. Magnets with topological band crossings serve as a good material platform for such control, because their topological band degeneracy can be readily tuned by spin configurations, dramatically modulating electronic conduction3-10. Here we propose that the topological nodal-line degeneracy of spin-polarized bands in magnetic semiconductors induces an extremely large angular response of magnetotransport. Taking a layered ferrimagnet, Mn3Si2Te6, and its derived compounds as a model system, we show that the topological band degeneracy, driven by chiral molecular orbital states, is lifted depending on spin orientation, which leads to a metal-insulator transition in the same ferrimagnetic phase. The resulting variation of angular magnetoresistance with rotating magnetization exceeds a trillion per cent per radian, which we call colossal angular magnetoresistance. Our findings demonstrate that magnetic nodal-line semiconductors are a promising platform for realizing extremely sensitive spin- and orbital-dependent functionalities.
ABSTRACT
Superconductivity in the vicinity of a competing electronic order often manifests itself with a superconducting dome, centered at a presumed quantum critical point in the phase diagram. This common feature, found in many unconventional superconductors, has supported a prevalent scenario in which fluctuations or partial melting of a parent order are essential for inducing or enhancing superconductivity. Here we present a contrary example, found in IrTe2 nanoflakes of which the superconducting dome is identified well inside the parent stripe charge ordering phase in the thickness-dependent phase diagram. The coexisting stripe charge order in IrTe2 nanoflakes significantly increases the out-of-plane coherence length and the coupling strength of superconductivity, in contrast to the doped bulk IrTe2. These findings clarify that the inherent instabilities of the parent stripe phase are sufficient to induce superconductivity in IrTe2 without its complete or partial melting. Our study highlights the thickness control as an effective means to unveil intrinsic phase diagrams of correlated van der Waals materials.
ABSTRACT
This study evaluated the use of electrolyzed alkaline-reduced water instead of an alkaline activator for the production of a strong cement matrix with a large blast furnace slag replacement ratio. The flexural and compressive strength measurements, X-ray diffraction analysis, and scanning electron microscopy images of the cement matrices produced using electrolyzed alkaline-reduced water and regular tap water, and with blast furnace slag replacement ratios of 30 and 50% were compared to a normal cement matrix. The cement matrix produced using electrolyzed alkaline-reduced water and blast furnace slag exhibited an improved early age strength, where hydrate formation increased on the particle surface. The cement matrix produced using electrolyzed alkaline-reduced water exhibited a high strength development rate of over 90% of ordinary Portland cement (OPC) in BFS30. Therefore, the use of electrolyzed alkaline-reduced water in the place of an alkaline activator allowed for the formation of a very strong cement matrix in the early stages of aging when a large blast furnace slag replacement ratio was used.
ABSTRACT
We investigated the transport characteristics of a square shape superconducting Ta thin film under DC electrical current bias along the diagonal direction. The resistance parallel (Râ¥) and perpendicular (Râ¥) to the DC current, IDC, is measured with various magnetic fields. R⥠and R⥠show contrasting dependence on IDC. First, the critical current of R⥠is smaller than that of Râ¥. Second, R⥠shows an unexpected reduction at current bias where R⥠shows a rapid increase near the transition from a flux flow state to a normal state. The intriguing anisotropic transport characteristics can be understood by the inhomogeneous current density profile over the square sample. Diagonal DC current induces an anisotropic current density profile where the current density is high near the biasing electrode and low at the center of the sample. Accordingly, the electrical transport in the perpendicular direction could remain less affected even near the critical current of Râ¥, which leads to the higher critical current in Râ¥. Complicated conduction profile may also allow the anomalous reduction in the R⥠before finally shifting to the normal state.
ABSTRACT
The superconductor-insulator (SI) transition in two-dimensional Ta thin films is investigated by controlling both film thickness and magnetic field. An intriguing metallic phase appears between a superconducting and an insulating phase within a range of film thickness and magnetic field. The temperature and electric field scaling analyses are performed to investigate the nature of the SI transition in the thickness-tuned metallic and superconducting samples. The critical exponents product of νz obtained from the temperature scaling analysis is found to be approximately 0.67 in the entire range of film thickness. On the other hand, an apparent discrepancy is measured in the product of ν(z + 1) by the electric filed analysis. The product values are found to be about 1.37 for the superconducting films and about 1.86 for the metallic films respectively. We find that the discrepancy is the direct consequence of electron heating that introduces additional dissipation channels in the metallic Ta films.