Design of a suspended germanium micro-antenna for efficient fiber-chip coupling in the long-wavelength mid-infrared range.

Recent developments of photonic integrated circuits for the mid-infrared band has opened up a new field of attractive applications for group IV photonics. Grating couplers, formed as diffractive structures on the chip surface, are key components for input and output coupling in integrated photonic platforms. While near-infrared optical fibers exhibit large mode field diameters compared to the wavelength, in the long-wave regime commercially available single-mode optical fibers have mode field diameters of the order of the operating wavelength. Consequently, an efficient fiber-chip surface coupler designed for the long-wave infrared range must radiate the power propagating in the waveguide with a higher radiation strength than a conventional grating coupler in the near-infrared range. In this article, we leverage the short electrical length required for long-wave infrared couplers to design a broadband all-dielectric micro-antenna for a suspended germanium platform at 7.67 µm. The design methodology is inspired by fundamental grating coupler equations, which remain valid even when the micro-antenna has only two or three diffractive elements. A simulated coupling efficiency of ~ 40% is achieved with a 1-dB bandwidth broader than 430 nm, which is almost twice the typical fractional bandwidth of a conventional grating coupler. In addition, the proposed design is markedly tolerant to fiber tilt misalignments of ±10°. This all-dielectric micro-antenna design paves the way for efficient fiber-chip coupling in long-wavelength mid-infrared integrated platforms.

Silicon-on-insulator free-carrier injection modulators for the mid-infrared.

Experimental demonstrations of silicon-on-insulator waveguide-based free-carrier effect modulators operating at 3.8 µm are presented. PIN diodes are used to inject carriers into the waveguides, and are configured to (a) use free-carrier electroabsorption to create a variable optical attenuator with 34 dB modulation depth and (b) use free-carrier electrorefraction with the PIN diodes acting as phase shifters in a Mach-Zehnder interferometer, achieving a VπLπ of 0.052 V·mm and a DC modulation depth of 22 dB. Modulation is demonstrated at data rates up to 125 Mbit/s.

Suspended silicon waveguides for long-wave infrared wavelengths.

In this Letter, we report suspended silicon waveguides operating at a wavelength of 7.67 µm with a propagation loss of 3.1±0.3 dB/cm. To our knowledge, this is the first demonstration of low-loss silicon waveguides at such a long wavelength, with loss comparable to other platforms that use more exotic materials. The suspended Si waveguide core is supported by a sub-wavelength grating that provides lateral optical confinement while also allowing access to the buried oxide layer so that it can be wet etched using hydrofluoric acid. We also demonstrate low-loss waveguide bends and s-bends.

Suspended silicon mid-infrared waveguide devices with subwavelength grating metamaterial cladding.

We present several fundamental photonic building blocks based on suspended silicon waveguides supported by a lateral cladding comprising subwavelength grating metamaterial. We discuss the design, fabrication, and characterization of waveguide bends, multimode interference devices and Mach-Zehnder interferometers for the 3715 - 3800 nm wavelength range, demonstrated for the first time in this platform. The waveguide propagation loss of 0.82 dB/cm is reported, some of the lowest loss yet achieved in silicon waveguides for this wavelength range. These results establish a direct path to ultimately extending the operational wavelength range of silicon wire waveguides to the entire transparency window of silicon.

Angled multimode interferometer for bidirectional wavelength division (de)multiplexing.

We have demonstrated a bidirectional wavelength division (de)multiplexer (WDM) on the silicon-on-insulator platform using two 4-channel angled multimode interferometers (AMMIs) sharing the same multimode interference waveguide. An excellent match of the peak transmission wavelength of each channel between the two AMMIs was achieved. The input and output access waveguides were arranged in a configuration such that the propagation of light of one AMMI in the multimode interference waveguide suffered minimal perturbation by the input and output waveguides of the other AMMI. This type of device is ideal for the WDM system for datacom or telecom applications, e.g. an integrated optical transceiver, where the transmission wavelengths are required to match with the receiving wavelengths. The device also benefits from simple fabrication (as only a single lithography and etching step is required), improved convenience for the transceiver layout design, a reduction in tuning power and circuitry and efficient use of layout space. A low insertion loss of 3-4 dB, and low crosstalk of -15 to -20 dB, was achieved.

Mid-infrared wavelength division (de)multiplexer using an interleaved angled multimode interferometer on the silicon-on-insulator platform.

A low-cost and high-performance wavelength division (de)multiplexing structure in the mid-IR wavelength range is demonstrated on the silicon-on-insulator platform using an interleaved angled multimode interferometer (AMMI). As compared to a single AMMI, the channel count was doubled and the channel spacing halved with negligible extra insertion loss and crosstalk and with only a slight increase in device footprint. The device requires only single lithography and etching steps for fabrication. Potential is also shown for achieving improved performance with further optimized design.