ABSTRACT
We report a low-temperature colloidal synthesis of single-layer, five-atom-thick, ß-In2Se3 nanosheets with lateral sizes tunable from â¼300 to â¼900 nm, using short aminonitriles (dicyandiamide or cyanamide) as shape controlling agents. The phase and the monolayer nature of the nanosheets were ascertained by analyzing the intensity ratio between two diffraction peaks from two-dimensional slabs of the various phases, determined by diffraction simulations. These findings were further backed-up by comparing and fitting the experimental X-ray diffraction pattern with Debye formula simulated patterns and with side-view high-resolution transmission electron microscopy imaging and simulation. The ß-In2Se3 nanosheets were found to be indirect band gap semiconductors (Eg = 1.55 eV), and single nanosheet photodetectors demonstrated high photoresponsivity and fast response times.
ABSTRACT
It is common knowledge that poly(3-hexylthiophene) (P3HT)/[6,6]-phenyl-C61-butyric acid methyl ester (PCBM) blend, a prototype system for bulk heterojunction (BHJ) solar cells, consists of a network of tens of nanometers-large donor-rich and acceptor-rich phases separated by extended finely intermixed border regions where PCBM diffuse into P3HT. Here we specifically address the photo-induced dynamics in a 10â nm thin P3HT/PCBM blend that consists of the intermixed region only. Using the multi-pass transient absorption technique (TrAMP) that enables us to perform ultra high sensitive measurements, we find that the primary process upon photoexcitation is ultrafast energy transfer from P3HT to PCBM. The expected charge separation due to hole transfer from PCBM to P3HT occurs in the 100â ps timescale. The derived picture is much different from the accepted view of ultra-fast electron transfer at the polymer/PCBM interface and provides new directions for the development of efficient devices.
ABSTRACT
In this paper, a photochromic electret for light energy harvesting is proposed and discussed. Such electret directly converts the photon energy into electric energy thanks to a polarization modulation caused by the photochromic reaction, which leads to a change in dipole moment. Theoretical concepts on which the photochromic electret is based are considered with an estimation of the effectiveness as a function of material properties. Finally, an electret based on a photochromic diarylethene is shown with the photoelectric characterization as a proof of concept device.
ABSTRACT
A novel system for the modulation of amplified emission based on a polyfluorene/diarylethene (namely F8BT/DTP) blend is shown. The high sensitivity of amplified spontaneous emission (ASE) is exploited to achieve efficient emission modulation with a low-intensity control signal. Modulation is then characterized by photoluminescence (PL) lifetime measurements, photocurrent experiments, and density functional theory calculations. This system can also act as a photocurrent switch based on the same principle. This technique may represent a useful tool for fluorescence quenching and sensing as well as find application in organic photonics.
ABSTRACT
The ultimate target of molecular electronics is to combine different types of functional molecules into integrated circuits, preferably through an autonomous self-assembly process. Charge transport through self-assembled monolayers has been investigated previously, but problems remain with reliability, stability and yield, preventing further progress in the integration of discrete molecular junctions. Here we present a technology to simultaneously fabricate over 20,000 molecular junctions-each consisting of a gold bottom electrode, a self-assembled alkanethiol monolayer, a conducting polymer layer and a gold top electrode-on a single 150-mm wafer. Their integration is demonstrated in strings where up to 200 junctions are connected in series with a yield of unity. The statistical analysis on these molecular junctions, for which the processing parameters were varied and the influence on the junction resistance was measured, allows for the tentative interpretation that the perpendicular electrical transport through these monolayer junctions is factorized.
